Adam Hall SLT001 Bruksanvisning

Adam Hall DJ-utrustning SLT001

Läs gratis den bruksanvisning för Adam Hall SLT001 (2 sidor) i kategorin DJ-utrustning. Guiden har ansetts hjälpsam av 16 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 8.5 recensioner. Har du en fråga om Adam Hall SLT001 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/2

BEDIENUNGSANLEITUNG

USER´S MANUAL MANUEL D´UTILISATIONI

SLT001 / SLT001W MULTI-PURPOSE LAPTOP STAND

PARTS

Adam Hall GmbH · Daimlerstr. 9 61267 Neu-Anspach Germany

Tel.: (+49) 60 81 / 94 19 0 Fax.: (+49) 60 81 /94 19 1000 e-mail: mail@adamhall.com

1. Take one of the upper supports and place it over the outside of one of the lower supports (see ﬁgure A). Align the upper support holes with the

lower support mounting holes to obtain the desired height.

2. Place one knob at a time through the mounting holes (must be spaced at least 2 holes apart).

3. Take a stabilizer bar and screw the top knob into the end of the stabilizer bar. Repeat with bottom knob.

4. Install 1 inch spacers on each stabilizer bar to increase stand width. Repeat step 3 with the other upper support and lower support for the opposite

side of the stand (see Figure B). Secure all knobs tight to minimize stand wobble.

Table top assembly

1. Attach ﬂat foot bar to lower support

with two (2) A-screws and washers

(see ﬁgure C).

2. Repeat above with the other lower

support for the opposite side of the

stand.

Table C-clamp assembly

1. Turn clamp with knobs facing down

and attach to lower support with two

(2) B-screws and B-washers (see

ﬁgure D).

2. Repeat above with the other lower

support for the opposite side of the

stand.

DJ cofﬁn C-clamp assembly

1. Turn clamp with knobs facing back

of stand and attach to lower support

with two (2) B-screws and B-washers

(see ﬁgure E).

2. Repeat above with the other lower

support for the opposite side of the

stand.

Figure B

Place Upper

support over

Lower support, so

that the Upper

Support is on the

outside of the

stand

Knobs must be

spaced at least 2

holes apart

Figure A

Produktspecifikationer

Varumärke:	Adam Hall
Kategori:	DJ-utrustning
Modell:	SLT001
Produkttyp:	Ställ till bärbara datorer
Vikt:	2400 g
Bredd:	290 mm
Djup:	250 mm
Höjd:	280 mm
Material:	Stål
Produktens färg:	Svart