Adj Starburst Bruksanvisning
Adj
Inte kategoriserad
Starburst
Läs gratis den bruksanvisning för Adj Starburst (11 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 4 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 2.5 recensioner. Har du en fråga om Adj Starburst eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/11
User Manual
STARBURST
©2020 ADJ Products, LLC all rights reserved. Information, specications, diagrams, images, and
instructions herein are subject to change without notice. ADJ Products, LLC logo and identifying
product names and numbers herein are trademarks of ADJ Products, LLC. Copyright protection
claimed includes all forms and matters of copyrightable materials and information now allowed by
statutory or judicial law or hereinafter granted. Product names used in this document may be trade-
marks or registered trademarks of their respective companies and are hereby acknowledged. All
non-ADJ Products, LLC brands and product names are trademarks or registered trademarks of their
respective companies.
ADJ Products, LLC and all aliated companies hereby disclaim any and all liabilities for property,
equipment, building, and electrical damages, injuries to any persons, and direct or indirect economic
loss associated with the use or reliance of any information contained within this document, and/or as
a result of the improper, unsafe, insucient and negligent assembly, installation, rigging, and opera-
tion of this product.
Europe Energy Saving Notice
Energy Saving Matters (EuP 2009/125/EC)
Saving electric energy is a key to help protecting the enviroment. Please turn o all electrical products when
they are not in use. To avoid power consumption in idle mode, disconnect all electrical equipment from power
when not in use. Thank you!
ADJ Products, LLC - www.adj.com - Starburst User Manual Page 2
ADJ Products, LLC - www.adj.com - Starburst User Manual Page 7
Notice: Be sure to follow figures two and three when making your own cables. Do not use the
ground lug on the XLR connector. Do not connect the cable’s shield conductor to the ground lug
or allow the shield conductor to come in contact with the XLR’s outer casing. Grounding the shield
could cause a short circuit and erratic behavior.
Starburst Set Up
Special Note: Line Termination. When longer runs of cable are used, you may need to use a ter-
minator on the last unit to avoid erratic behavior. A terminator is a 110-120 ohm 1/4 watt resistor
which is connected between pins 2 and 3 of a male XLR connector (DATA + and DATA -). This unit is
inserted in the female XLR connector of the last unit in your daisy chain to terminate the line. Using a
cable terminator (ADJ part number ) will decrease the possibilities of erratic behavior.Z-DMX/T
5-Pin XLR DMX Connectors. Some manufacturers use 5-pin DMX-512 data cables for DATA trans-
mission in place of 3-pin. 5-pin DMX fixtures may be implemented in a 3-pin DMX line. When insert-
ing standard 5-pin data cables in to a 3-pin line, a cable adaptor must be used. These adaptors are
readily available at most electric stores. The chart below details a proper cable conversion.
Produktspecifikationer
| Varumärke: | Adj |
| Kategori: | Inte kategoriserad |
| Modell: | Starburst |
Behöver du hjälp?
Om du behöver hjälp med Adj Starburst ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Adj Manualer
28 Januari 2025
28 Januari 2025
28 Januari 2025
4 Januari 2025
4 Januari 2025
31 December 2025
29 December 2024
29 December 2024
24 September 2024
23 September 2024
Inte kategoriserad Manualer
- Stenda
- Heaven Fresh
- Solplanet
- Naish
- Hansa
- Mr Gardener
- Favini
- XS Power
- DPA
- SVAT
- Karma
- Cinderella
- Intermec
- Kopul
- Videotec
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025