Aerohive AP170 Bruksanvisning

Läs gratis den bruksanvisning för Aerohive AP170 (12 sidor) i kategorin Åtkomstpunkt. Guiden har ansetts hjälpsam av 19 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 5 recensioner. Har du en fråga om Aerohive AP170 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

P/N 330052-03, Rev. A1

AP170 INSTALLATION GUIDE

This guide explains how to mount an Aerohive AP170 Outdoor Access Point to a pole or flat

surface in virtually any outdoor setting, and connect it to Aerohive HiveManager Network

Management over the network. To register, get the latest product documentation, see compliance

information, and download software updates, visit www.aerohive.com/support.

KIT CONTENTS, REQUIRED ACCESSORIES, AND TOOLS

The AP170 kit includes the items shown in Figure 1.

Figure 1 AP170 kit contents

To install your AP170, you will need the following accessories (ordered separately) and tools:

•(2) 2.4 GHz antennas (AH-ACC-170-ANT-2G)

•(2) 5 GHz antennas (AH-ACC-170-ANT-5G)

•A switch that provides PoE power, or a PoE provisioning device

•(1) shielded cat5 Ethernet cable rated for outdoor use; length not to exceed 328 feet (100 m)

•Crosshead screwdriver for 1/4” (6 mm) x 3/8” (10 mm) screws

•Drive sockets (nut drivers) for 3/8” (10 mm) nuts

•Flat blade screwdriver to tighten hose clamp

S AFETY INSTRUCTIONS AND S HITE AZARD WARNINGS

Read and follow these safety instructions and hazard warnings before installing an AP170 outdoors. Keep these

instructions for future reference.

•To comply with RF (radio frequency) exposure limits, do not place the AP170 within 8" (20 cm) of people.

•You can install the AP170 in wet, windy locations. Therefore, make sure to install the Ethernet cable housing for

a complete waterproof connection.

•To protect the AP170 from lightning, do not place it at the highest point of a building or structure.

•To protect your network from lightning, place an Ethernet protector (SKU AH-ACC-1G-ETH-PROT) inline between

the AP170 and the rest of the network. Refer to the installation instructions that ship with the Ethernet

protector.

Plane Bracket (1)

AP170

Base

Bracket (1)

(4) Sleeve-Bolt Assembly

Sleeve, 5/8” (16 mm),

Bolt 1 15/16” (5 cm),

Hex nut 3/8” (10 mm),

Washer 5/8” (16 mm)

(4) Round Head Screw 1/4” (6 mm)

Lock Washer, Flat Washer

(4) Hex Head Bolt, 3/8”x1/2”

(10 mm x 13 mm)

Lock Washer, Flat Washer 1/2” (13 mm)

Hose Strap (1)

Ground Cable (1)

Ethernet

Housing (1)

Produktspecifikationer