Ambient Recording UMP III Bruksanvisning

Ambient Recording Inte kategoriserad UMP III

Läs gratis den bruksanvisning för Ambient Recording UMP III (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 6 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 3.5 recensioner. Har du en fråga om Ambient Recording UMP III eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/4

Schleissheimer Straße 181 C | DE +49 89 360 55 10– 80797 Munich | phone -0 | www.ambient.de/en | info@ambient.de

Universal Microphone Power Supply

Instruction Manual

Schleissheimer Straße 181 C | DE +49 89 360 55 10– 80797 Munich | phone -0 | www.ambient.de/en | info@ambient.de

P reparing the UMP III

- P ush the battery lever on the bottom in and slide right (direction MIC connector)

- Insert battery with the polarity protection gap to the left when looking at the

front

- Close the door and push back to the left

Power on

Plug in the Mic In cable. The device can only be switched on with the Mic In cable

connected.

Press the button until the LED turns from red to green, release. The LED will now display

the current power setting.

Schleissheimer Straße 181 C | DE +49 89 360 55 10– 80797 Munich | phone -0 | www.ambient.de/en | info@ambient.de

Power settings LED color:

• Blue (default): 48V Phantom

• White: 12V Phantom

• Yellow: 12V T- Power

• Red: Low battery, approx. 15min operation left

Note: Default setting is 48V phantom, but the unit will retain a previously selected mode. To

prevent damage caused by improper power mode, check the current active setting matches

your microphone before connecting it.

Check the setting while unit is on briefly tap the button. The Led will blink in the color of

the active setting.

Changing the power setting

Alternate between 48V and 12V Phantom briefly tap the button twice. The unit will light :

up the setting it would switch to. If you want to confirm, tap while LED is lit, to cancel,

wait. The unit will now blink 3 times in the color of the now active mode.

Enabling T-Power: tap 3 times. The LED will light up yellow. To confirm, tap the button

while LED is lit yellow. The un will blink 3 times yellow to indicate Tit -Power is now

activated.

Disabling T-Power: tap button twice. The Led will light up blue. To confirm selection tap

button while LED is lit. The unit will blink 3 times blue to indicate 48V Ph is now

activated.

Produktspecifikationer

Varumärke:	Ambient Recording
Kategori:	Inte kategoriserad
Modell:	UMP III
Bredd:	180 mm
Djup:	180 mm
Höjd:	100 mm
Lätt att städa:	Ja
Användarvänlig:	Ja
Lätt att installera:	Ja
Typ produkt:	Muurlicht