Audix M3WHM Bruksanvisning

Audix mikrofon M3WHM

Läs gratis den bruksanvisning för Audix M3WHM (4 sidor) i kategorin mikrofon. Guiden har ansetts hjälpsam av 17 personer och har ett genomsnittsbetyg på 4.1 stjärnor baserat på 9 recensioner. Har du en fråga om Audix M3WHM eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/4

AUDIX M3

INSTALLATION GUIDE

Thank you for choosing Audix! Our products are designed to provide you with many years of

reliable service. Please read this manual before using the system

for optimal installation and operation.

IN THE PACKAGE

OPTIONAL ACCESSORIES

M3 Tri-element Hanging Ceiling Microphone

JBM3 - Plenum rated junction box circuitry

Junction box lid

Breakout cable consisting of RJ45 female to three terminal block connectors

Seismic / Fire restraint cable

PLENHSEM3 Brass plenum bell housing (patent pending). This brass

housing is specically designed to provide a plenum seal when threaded on

to the plenum junction box. The bell housing is included with all Audix CAT 7

prepackaged interface cables (see below for models), and may be purchased

separately for bulk cable runs.

CBLM3XLR Breakout cable consisting of an RJ45 female to three XLR male

connectors. This cable is designed to be used in conjunction with Audix CAT

7 interface cable, keeping the shielded and balanced audio path intact when

connecting to the three mic level XLR inputs of a DSP Controller.

CAT7 Interface cable. Audix manufactures a high quality CAT 7 cable

optimized for balanced audio and cross talk elimination. The cable is LS0H

(low smoke zero halogen) and consists of four twisted pairs that are individu-

ally shielded, RJ45 male connectors and a brass housing to further seal the

cable at the plenum rated junction box. The interface cable is available in

prepackaged lengths or in bulk (see below for models).

Note: The Audix M3 also works with CAT 5 and CAT 6 cable, however, Audix recommends

using shielded cable.

CBLM307 - Interface Cable 7 meters (23’)

CBLM310 - Interface Cable 10 meters (33’)

CBLM315 - Interface Cable 15 meters (49’)

CBLM320 - Interface Cable 20 meters (66’)

CBLM325 - 25 meters (82 ) Interface Cable '

CBLM330 - Interface Cable 30 meters (98 )'

CBLM350 - Bulk cable. 50 meters (162’). Use with brass plenum bell housing #6 for best results.

CBLM3100 - As above. 100 meters (325’)

5 4

Fig A. Remove ceiling tile and drill

5/8” (16mm) hole in the desired

location.

Fig B. Position the JBM3 plenum

rated junction box over the

drilled hole.

Fig C. Remove the nut from

the threaded portion of the M3

cable , feed cable through the

tile hole and into the junction box.

Fig D. Install the threaded nut with

shoulder side down and secure.

Fig E. Insert the 7 pin mini female

XLR connector into the male

receptacle.

Fig F. Set the initial height of the

M3 and spool the excess cable

inside the junction box.

Fig I. Adjust the cable to exact

desired length by either feeding

or pulling the cable through the

ceiling mount.

Fig G. Fasten the lid on top

of the junction box. Insert RJ45/

Cat cable into JBM3 receptacle.

(See back page for installing

seismic cable)

Fig H. If using Audix Cat 7 LSOH

interface cable , screw on the

brass bell housing over the RJ45

connection and reset ceiling tile.

Fig K. Microphone elements are

spaced 120 degree apart. Channel

1 is directly below the Audix logo

Fig J. Position the microphone by

turning the cable as necessary and

gently turn the nut clockwise to se-

cure (1 to 2 turns). Do not over tighten.

INSTALLATION AND WIRING INSTRUCTIONS

Fig L. Connect RJ45 cables into

the breakout cable and connect to

DSP Controller.

Produktspecifikationer

Varumärke:	Audix
Kategori:	mikrofon
Modell:	M3WHM
Färg på produkten:	Zwart, zilver
Vikt:	4700 g
Bredd:	150 mm
Djup:	320 mm
Höjd:	890 mm
Förpackningens vikt:	6140 g
Förpackningens bredd:	310 mm
Djuppackning:	480 mm
Justerbar i höjdled:	Ja
Monteringsmetod:	Bureau
Ursprungsland:	China
Kod Storbritanniens handelstull:	73269098
Maximal viktkapacitet:	8 kg
Rotationsvinkel:	180 °
Montage:	Klem
Kompatibilitet med monteringsgränssnitt (min):	75 x 75 mm
Kompatibilitet med monteringsgränssnitt (max):	100 x 100 mm
Antal skärmar som stöds:	2
Förbättrad kabelhantering:	Ja
Tiltvinkelområde:	0 - 90 °
Maximal skärmstorlek:	27 "
Harmoniserad systemkod (HS):	85299097
Förpackningsvolym:	19344 cm³
Minsta skärmstorlek:	17 "