AXESS AX-ADXSVI-MB2 Bruksanvisning
AXESS
Inte kategoriserad
AX-ADXSVI-MB2
Läs gratis den bruksanvisning för AXESS AX-ADXSVI-MB2 (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 13 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 7 recensioner. Har du en fråga om AXESS AX-ADXSVI-MB2 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
INSTAX-ADXSVI-MB2
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
1-800-221-0932 metraonline.com
REV. 6/27/16
INSTAX-ADXSVI-MB2
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
1-800-221-0932 metraonline.com
REV. 6/27/16
WIRING THE AX-ADXSVI-MB2
• Connect the Yellow wire to the radio’s 12 volt battery or memory wire.
• Connect the wire to the radio’s ground wire.Black
• Connect the wire to the ignition wire of the aftermarket radio.Red
• Connect the wire to the illumination wire of the aftermarket radio. If the Orange
aftermarket radio has no illumination wire, tape off the Orange wire.
• Connect the wire to the antenna turn on wire of the aftermarket radio.Blue
•
Connect the wire to the left front positive speaker output of the aftermarket radioWhite
.
• Connect the wire to the left front negative speaker output of the White/Black
aftermarket radio.
•
Connect the wire to the right front positive speaker output of the aftermarket radio Gray
.
• Connect the wire to the right front negative speaker output of the Gray/Black
aftermarket radio.
AX-ADXSVI-MB2
Mercedes accessory and NAV output CAN Interface 2005-up
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Used in non-amplified systems, or when bypassing an amplified system
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Prewired ASWC-1 harness (ASWC-1 sold separately)
• Retains balance and fade
• Micro “B” USB updatable
Attention! This harness must be used along with the AX-ADXSVI
(sold separately)
APPLICATIONS
MERCEDES
C Class 2005-2011
CLK Class 2005-2009
E Class 2010-up
G Class 2007-2012
GLK Class 2010-2012
R Class 2006-2011
SLK Class 2005-2011
Sprinter 2010-up
K PNOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most cognized and spected re re
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for mo information and take steps re
toward a better tomorrow.
Metra recommends MECP
certified technicians
• Connect the wire to the radio’s left rear positive speaker output.Green
• Connect the wire to the radio’s left rear negative speaker output.Green/Black
• Connect the wire to the radio’s right rear positive speaker output.Purple
• Connect the wire to the radio’s right rear negative speaker output.Purple/Black
The following (3) wires are for the aftermarket radios that have navigation built in.
• Connect the wire to the parking brake wire of the aftermarket Light Green
navigation radio (if applicable).
• Connect the wire to the VSS or speed sense wire of the aftermarket Blue/Pink
navigation radio (if applicable).
• Connect the wire to the reverse wire of the aftermarket navigation Green/Purple
radio (if applicable).
INITIALIZING THE AX-ADXSVI-MB2
Attention! If the interface loses power for any reason, the following steps will need to
be performed again. Also, if installing an ASWC-1 connect it after you initialize and test
the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio
comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off
position, disconnect the interface, check all connections, reconnect the interface,
and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions
of the installation for proper operation, before reassembling the dash.
CAUTION!
All accessories, switches, climate con-
trols panels, and especially air bag indicator lights
must be connected before cycling the ignition.
Also, do not remove the factory radio with the key
in the on position, or while the vehicle is running.
Produktspecifikationer
| Varumärke: | AXESS |
| Kategori: | Inte kategoriserad |
| Modell: | AX-ADXSVI-MB2 |
Behöver du hjälp?
Om du behöver hjälp med AXESS AX-ADXSVI-MB2 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad AXESS Manualer
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
Inte kategoriserad Manualer
- Mellerware
- G3
- Saramonic
- SurgeX
- ZYCOO
- Tandberg Data
- Softing
- Forza
- Hoymiles
- Key Digital
- Weltevree
- Nuna
- IStarUSA
- For_Q
- Omiindustriies
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025