Azden WHD-PRO + I Bruksanvisning

Läs gratis den bruksanvisning för Azden WHD-PRO + I (4 sidor) i kategorin mikrofon. Guiden har ansetts hjälpsam av 29 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 9 recensioner. Har du en fråga om Azden WHD-PRO + I eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

WHD-PRO +iAUDIO KIT

WR WM- -PRO -- -PRO EX503 - - SGM990 i CABLE-HX-

INSTRUCTION MANUAL

WARNING

 Do not store or use the products in high heat or humidity.

 Do not use near a broadcast staon, airport or plane. You must change the frequencies if you are

interfering with other transmiers.

 The system will work connuously for 10 hours on one set of baeries. If sound quality is poor,

change baeries.

 Remove baeries when the system is not in use.

Thank you for purchasing the AZDEN WHDPRO Audio Kit. The following contents are included in your kit:-

-1 x WRPRO VHF Receiver

-1 x WMPRO VHF BeltPack Transmier-

-1 x EX503 Lavalier Microphone

-1 x SGM990 Direconal Microphone

-1 x HXi Smartphone Connector Cable

The PRO systems operate in the lowinterference VHF band and have 2 switchable frequencies, -

169.445 (F1) and 170.245 (F2). You should select the quieter frequency for use.

The systems conforms to Part 90 of the FCC rules. You should contact the FCC oce for ling forms.

1. Loading Baery

Open the baery compartment lid by sliding it down and raising the lid. Insert a 9volt -

baery into the baery compartment with the correct polarity. Direcons are on the inside of the

baery compartment. Do not force the baery compartment lid to close. If it does not close easily,

turn the baery around and try again.

2. Power/Frequency Selector Switch

This slide switch is used to turn the unit on and o as well as to select a frequency. When

not using the WRPRO, make sure that the switch is turned to OFF. -

3. Signal Indicator

This LED has 2 funcons: When you rst turn the Power/Frequency Selector Switch of the

Receiver on, but if the Transmier is not on, the LED will show red indicang that the baery is good.

If both the Transmier and the Receiver are on and they are on the same frequency, the Receiver LED

will show green and the Transmier LED will show red.

WR- PRO RECEIVER

Produktspecifikationer