Bazooka MT8100W Bruksanvisning
Sidor 1 Engels högtalare
Läs bruksanvisningen för Bazooka MT8100W gratis online eller ladda ner PDF:en. 29 personer har tyckt att guiden var hjälpsam. Fråga om modellen? Ställ en fråga
Center top of Tubbie
mounting plate with bottom
of clamp. Loosen saddle
clamp latching bolt until
nut is 1/8” from end of
threaded mounting
stud. Wrap saddle
clamp around bottom
of clamp and top of
Tubbie mounting plate.
Tighten latch bolt.
Place clamp on mounting pipe. Minimum
distance from edge of clamp to nearest
obstruction is 7”(177.8 mm). If clamp is
mounted any closer, the Tubbie will not be
able to rotate 360 degrees. Make sure
clamp is level, then mark pipe so a hole
can be drilled for the wires. Hole should be
between 1/2” (12.7mm) & 3/4” (19.5 mm).
Remove clamp & drill hole.
Extend the length of the PCB
wires so they will be able to
reach your audio source.
Run wires through bottom of clamp and through
your mounting pipe. Reattach clamp to make
sure wires are centered in the mounting hole.
MTCL3-S, MTCL2-S, MTCL2-B
Southern Audio Services 1-800-THE-TUBE or 225-272-7135 www.bazooka.com Canadian customers contact: Trends Electronics International Inc. 604-988-2966 or 877-946-9255
Remove PCB board if already installed
in bottom of clamp.
MT8100B / MT8100W
Single ended Tubbies:
Red -Speaker positive
Black - Speaker negative
Gray - NA
White - NA
MT81LKB / MT81LKW
Single ended Tubbies w/ light kit
Red -Speaker positive
Black - Speaker negative
Gray - 12vdc positive
White - 12 vdc negative
MT8265B / MT265W
Double ended Tubbies
Dual 4 ohm configuration
Red -Speaker positive
Black - Speaker negative
Gray - Speaker negative
White - Speaker positive
MT8265B / MT265W
Double ended Tubbies
Single 2 ohm configuration
Combine Red and White Speaker positives
Combine Black and Gray Speaker negative
Pipe Clamp
Top
Pipe Clamp
Bottom
2 ea. 6 mm
socket head
cap screws
Clamp PCB
Saddle Clamp
Retaining
clipLatch Bolt
Plastic
Inserts
Latch bolt can be loosened
and tighten by hand to be
able to rotate Tubbie. If you
want a more permanent
mount, tightened with a
10mm wrench or supplied
allen wrench. Ether way
always make sure clamp
is tight and retaing clip
is in place before
boat is in motion.
Parts per Clamp
Produktspecifikationer
| Varumärke: | Bazooka |
| Kategori: | högtalare |
| Modell: | MT8100W |
| Enhetsplacering: | Ingebouwd |
| Typ av operation: | Touch |
| Färg på produkten: | Zwart |
| Antal effektnivåer: | 9 |
| Inbyggd display: | Ja |
| Timer: | Ja |
| Bredd: | 770 mm |
| Djup: | 520 mm |
| Höjd: | 50 mm |
| Barnlås: | Ja |
| Antal brännare/kokzoner: | 6 zone(s) |
| Typ av häll: | Inductiekookplaat zones |
| Antal elektroniska kokzoner: | 6 zone(s) |
| Sjud brännare/kokzon: | 1.4 W |
| Normal brännare/kokzon: | - W |
| Kontrollposition: | Boven voorzijde |
| Installationsfackets bredd: | 755 mm |
| Installationsfack djup: | 495 mm |
| Boost funktion: | Ja |
| Restvärmeindikator: | Ja |
| Pansigenkänning: | Ja |
| Type beeldscherm: | LCD |
Behöver du hjälp?
Om du behöver hjälp med Bazooka MT8100W ställ en fråga nedan och andra användare kommer att svara dig
högtalare Bazooka Manualer
Bazooka MT8265W Bruksanvisning Bazooka MAC6510W Bruksanvisning Bazooka MT8265B Bruksanvisning Bazooka MT8100B Bruksanvisning Bazooka MAC6502BLED-4PK Bruksanvisning Bazooka UT8200RL Bruksanvisning Bazooka UT8200 Bruksanvisning Bazooka UT6200RL Bruksanvisning
Alla Bazooka högtalare manualer
Populära i högtalare
högtalare Manualer
Nyaste högtalare Manualer
FBT KEIRON 8C Bruksanvisning Sony SRS-X55 Bruksanvisning FBT SOP 426 T Bruksanvisning FBT Canto 5C Bruksanvisning Rockville RPB-XL Bruksanvisning Tracer CUBE20 Bruksanvisning FBT Canto 8CA Bruksanvisning Rockville GlideTone Bruksanvisning Rockville ROCK LAUNCHER Bruksanvisning Phoenix Gold ZDBMW4CX Bruksanvisning