Blaupunkt THA500.1 Bruksanvisning
Blaupunkt
Inte kategoriserad
THA500.1
Läs gratis den bruksanvisning för Blaupunkt THA500.1 (8 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 11 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 6 recensioner. Har du en fråga om Blaupunkt THA500.1 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/8
THA500.1
1 062 310 500 001
Warranty
We provide manufacturer's warranty for 12 months
from the date of sale for Blaupunkt products purchased
within India.
Recommendation
The performance of an amplier can only be as good as
its installation. Correct installation increases the overall
performance of your car sound system. The THA
amplier should be installed by a trained person. If you
would like to install it yourself, please read these
installation instructions very carefully and allow yourself
sufficient time for the installation.
In conclusion, allow us a few words about the topic of
health protection:
During playback of music in your vehicle, please
consider that continuous sound-pressure levels above
100 dB can lead to permanent damage of the human ear
& in some cases loss of hearing. Using today's high-
performance systems and loudspeaker congurations
allows for reaching sound-pressure levels above 130 dB.
Safety notes
Please observe the following safety notes during the
installation and connection.
- Disconnect the negative terminal of the battery!
Observe safety notes of the vehicle manufacturer.
- When you drill holes, ensure that you do not damage
any vehicle components.
- Please use minimum 10AWG power & ground cable
with a fuse located within 18 inches of the battery.
- Use cable glands for holes with sharp edges.
- Incorrect installation can result in malfunction of
vehicle electronic systems or sound system.
Installation and connection instructions
With respect to accident safety, the THA 500.1 must be
secured fastened at its mounting location.
When selecting the installation location, select a dry
location that offers sufficient air circulation for cooling
the amplier.
The THA 500.1 must not be installed on rear shelves, rear
seats or other locations that are open to the passenger
cabin.
The installation location must be suitable to accept the
accompanying screws and provide a rm support.
The amplier power cable must be tted with a fuse no
more than 45 cms from the battery to protect the vehicle
battery in case of a short circuit between power
amplier and battery. The fuse of the amplier protects
only the amplier, not the vehicle battery.
Use loudspeakers with 2 - 4 Ohms impedance (see table
or installation drawing). Do not connect loudspeakers to
ground, use only the referenced terminals.
Audio inputs (see Fig. 3)
You can select between 2 different audio inputs;
- Cinch (RCA)
- Hi level (loudspeaker connections)
Use only one of the audio inputs; otherwise, it may lead
to audio interference.
The preamplier outputs are connected to the cinch
(RCA) sockets ) via a shielded sound cable. j
With control via the loudspeaker outputs, the input
connections of pos. / are fed to the closest k l
loudspeaker cables (front or rear) on the left and right.
They are separated and connected to the input
connections. The polarity of the +or - connections must
be observed. Bridge output stages (BTL) can also be
connected directly without an additional adapter.
Positive / negative connection
- We recommend a minimum cross section of 10 AWG
- Route commercially available positive cable to the
battery and connect via fuse holder.
- Use cable glands for holes with sharp edges.
- Securely fasten commercially available negative
cables to a noise-free ground point (chassis screw,
chassis metal) not to the negative pole of the battery.
- Scrape the contact surfaces of the ground point until
they are bright and grease with graphite grease.
Integrated fuses (Fuse)
The fuses integrated in the amplier (Fuse) protect the
power amplier and the entire electrical system in case
of an error. If a replacement fuse is used, never bridge
fuses or replace them with a type with higher current.
1 x 500 W / 2
25 Hz - 500 Hz
> 100 dB @ RMS power
> 75 dB @ 1W/1kHz
<0.15%
0.2 / 5V
50 - 500Hz
185 x 54 x 184
7.3 x 2.1 x 7.3
0 dB / 6 dB
THA500.1 THA500.1
RMS power
THA500.1 THA500.1
Adjusting the type and range of the
frequency crossovers
With the THA 500.1, the type of frequency crossover (i.e.
"Low Pass") and the desired frequency can be adjusted.
For example, if a subwoofer is connected, the low-pass
settings shown are required (Fig. 3). The frequency is
de pen den t up on the fr equency ra nge o f th e
loudspeakers (see recommended frequency range of
the loudspeakers).
Low-pass frequency control
This control is active if the switch is in the position "Low-
Pass", and allows for setting the desired entry frequency.
Example: At a setting of 120Hz, the amplier has a
frequenc y range of 50Hz to 5 00Hz . (Ideal for
Subwoofers).
Bass boost
The bass boost control is used to adjust the bass
response of the amplier.
The setting options are: 0 dB / +6 dB.
Power-on indicator (PWR / PRO)
Green LED: Output stage on, regular operating status.
Red LED: Output stage is electronically switched off due
to an error.
Recycling & Disposal
Please use the return and collection systems
available to dispose of the product.
Subject to changes
Connection examples
Connection of the voltage supply............Fig. 2
Audio inputs....................................................Fig. 3
Loudspeaker connections..........................Fig. 4/5
Remote connection of the amplier with switchable
+12V voltage source.
This allows the amplier to be switched on and off using
the on/off-switch of the radio device.
Level control
The Level control is used to adjust the input sensitivity of
the power amplier to the output voltage of your car
sound system preamplier output.
The adjustment range is from 0.2 V to 5V.
If a car sound system of a third party manufacturer is
connected, the input sensitivity must be adjusted
corresponding to the manufacturer data.
An important explanation in this context:
By turning the control clockwise, the input sensitivity of
the amplier and, therefore, also the volume increases.
However, this is not a volume control; no further
amplier output can be achieved in the full position,
even if it may sound like that at the beginning. The
system merely increases the volume faster if the volume
control of the car sound system is turned up.
DC Offset- 4
When connecting to an OE radio, it may not be possible
to connect the remote turn on lead on the amplier,
please use the high level input available on the side
panel & turn on DC Offset to automatically turn on/off
the amplier when the OE radio is turned on / off.
Loudspeaker connections
As with every audio component, the correct polarity of
amplier and loudspeakers is important for a good bass
response. For this reason, ensure that the positive (+)
connection of the amplier is connected with the
positive connection (+) of the loudspeaker; the same
applies to the negative (-) connections. In addition, the
left amplier channel must be connected with the left
loudspeaker and the right amplier channel with the
right loudspeaker.
Caution:
Amplier load must not be lower than 2 Ohms. A
lower load leads to overheating & cause the
amplier to switch off & can cause permanent
damage.
Produktspecifikationer
| Varumärke: | Blaupunkt |
| Kategori: | Inte kategoriserad |
| Modell: | THA500.1 |
Behöver du hjälp?
Om du behöver hjälp med Blaupunkt THA500.1 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Blaupunkt Manualer
11 Mars 2025
23 Februari 2025
7 Januari 2025
5 Januari 2025
5 Januari 2025
5 Januari 2025
7 December 2024
7 December 2024
5 December 2024
5 December 2024
Inte kategoriserad Manualer
- Overtone Labs
- Hamilton Beach
- Spektrum
- Gem Toys
- Yaesu
- Ravensburger
- X Rocker
- Lifenaxx
- Gazelle
- Dave Smith
- Razer
- Black Box
- ProLights
- Omega Altise
- Outwell
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025