Caliber PARK 500 Bruksanvisning


Läs gratis den bruksanvisning för Caliber PARK 500 (11 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 10 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 5.5 recensioner. Har du en fråga om Caliber PARK 500 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/11
E N G L I S H
1
PARK 500 PARKING SENSOR SYSTEM
PARK 500 consists of ultrasonic sensors, camera and digital control
box. (Besides these, a outer connected display with RCA plug is
needed).The video signal is inputted into control box via VIN (video
Input) and processed by control box, then outputted to outer
connected display with RCA plug via VOUT (Video Output). This
system detects the distance between the car and back obstruction
by ultrasonic sensors fixed at rear bumper of the car, and the display
shows the back image via the camera fixed at the rear of the car.
With the change of alarm sound, figure or simulation bars as well as
the image, the driver could judge the distance to avoid accident.
INSTALLATION TOOLS
SELECT DRILLING POSITION FOR SENSOR A AND D
A B E C D
Ø 21 mm
for sensor
Ø 25 mm
for camera
A. 4 drilled holes (A, B, C, D) and camera hole
(E) should be under the same line
B. 0.5-0.8m vertically high to the ground, 0.55m
is recommended
C.Vertical, tidy surface without metal
components is preferred.
A. Choose suitable drilling position for A and D
sensor with relevant mark


Produktspecifikationer

Varumärke: Caliber
Kategori: Inte kategoriserad
Modell: PARK 500

Behöver du hjälp?

Om du behöver hjälp med Caliber PARK 500 ställ en fråga nedan och andra användare kommer att svara dig