CDA KC42 Bruksanvisning

Läs gratis den bruksanvisning för CDA KC42 (1 sidor) i kategorin Tvättställ. Guiden har ansetts hjälpsam av 18 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 2 recensioner. Har du en fråga om CDA KC42 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

KC41 and KC42 Fitting Instructions

FAILURE TO FOLLOWTHESE INSTRUCTIONS CAN LEADTO PREMATURE PRODUCT FAILURE.

The CDA Group Ltd cannot beheld responsible for injuries or losses caused by incorrect use or

installation of thisproduct. Please note thatCDA reserve theright to invalidate the guarantee

supplied with this product following incorrect installation or misuse of the appliance or use in a

commercial environment.

Over Mounting

1.Place the paper template providedcarefully into the correct position on the worktop.

2.Cut along the over mount line until the central section of the worktop comes out.

3.Use clear silicone to seal the cut that has been made; liberally spread the silicone onto the

area of the worktop directly adjacent to the hole you have made to the width of the sinkrim

that it will come into contact with.

4.Repeat step 3on the under side of the sink rim itself on the surfacethat will come into

contact with the worktop.

5.Carefully position so that you avoid unnecessary readjustment of the sink at the moment of

contact.

6.Press down firmly and hold in position for at least5 minutes applying an evenpressure.

7.Ensure the sink is fully sealed and the joint is waterproof by squeezing residual silicone out

from along the line of the joint.

8.Do not use the sinkfor at least 24 hours once fitted.

9.After 24 hours check to ensure the seal is waterproof.

Under Mounting

1.Place the paper template providedcarefully into the correct position on the worktop.

2.Cut along theunder mountline until thecentral section of the worktop comes out.

3.Finish the worktop cut out edge to the desired standard.

4.Turn the worktopupside down on a flat, stable surface. Note this will need to be left in

position for 24 hours.

5.Spread clear silicone liberally on the glazed surface on the rim of the sinkensuring no areas

are left uncovered.

6.Spread clear silicone liberally on the underside of the worktop to the corresponding area

where the rim of the sink will be incontact.

7.Press the sink down into the required position firmly for at least 5 minutes applying even

pressure. Position a weight on the sink to keep it in place.

8.Ensure the sink is fully sealed and the joint is waterproof by squeezing residual silicone out

from along the line of the joint.

9.Do not use the sinkfor at least 24 hours.

10.3 metal brackets are provided which should be fixed along the front edge and one on each

side; the edge of the bracket overlaps the sink rim and the other edge fixes to the worktop. If

a stone/granite worktop is beingused woodenblocks can be used to affixthe clips to secure

the sink; these should be fixed with an epoxy-type adhesive (follow manufacturers’

instructions forEpoxy adhesive use).

Produktspecifikationer