Cellular Line INTERPHONE F4S Bruksanvisning

Cellular Line Hörlurar INTERPHONE F4S

Läs nedan 📖 manual på svenska för Cellular Line INTERPHONE F4S (2 sidor) i kategorin Hörlurar. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

www.interphone.cellularline.com

B B

QUICK GUIDE EN

www.interphone.cellularline.com - www.cellularline.com

Export Dept. international.interphone@cellularline.com

A - YELLOW

B - GREEN

for installation of audio kit refer to the help available

www.interphone.cellularline.com

1 - Multipurpose button

2 - Multipurpose LED

3 - Volume adjustment button +

4 - Volume adjustment button -

5 - Recharge / Multipurpose socket and

accessories

6 - Bluetooth® control panel connection guide

7 - Speaker

8 - Microphone

ASSEMBLY OF THE SLIDE SUPPORT

WITH REMOVABLE CLIP

Take the support and note the best place

to fasten it to the side of the helmet. Insert

the rear part of the clip into the helmet and

couple the other part on the outside.

Insert the screws and tighten gently.

ASSEMBLY OF THE ADHESIVE SLIDE

SUPPORT

Take the adhesive support and look for the

best side and place to position it. Clean and

de-grease the part of the helmet where you

are going to stick the support (do not use

any detergents that could damage the hel-

Check position and move

the support if necessa-

ry, by sliding it along.

Tighten the screws with

the screwdriver supplied.

met’s nish). Remove the

protective lm from the

bi-adhesive, and apply the

support to the helmet.

As the support will not be

able to be moved once

stuck onto the helmet,

take great care with its po-

sitioning, when applying.

SPVINTERPHONEF4

MICINTERPHONEF4

ULTRASLIMF4FFKIT

MICINTERPHONEF4UNI

MICINTERPHOF4MP3

MICINTERPHONEF4FF

CUSBINTERPHONEF4

TESTKITINTERPHONE

ACHEUINTERPHONEF4-UK-AUS-JP

CBRARINTERPHONEF4

INTERPHONEF ACCESSORIES

Congratulations on your purchase of the InterphoneF4S.

Before using this product, we recommend you carefully perform the operations

outlined in this Quick Guide.

1 - Charging

Plug the battery charger into a 110/220 V socket.

Insert the plug on the battery charger into the connector on the InterphoneF4S.

The LED lights up red during charging.

The LED turns green when charging is complete.

When charging is complete, disconnect the unit from the charger by pulling out

the plug, and also pull out the charger from the mains socket.

2 - Setup

With InterphoneF4S o, press and hold the multifunction button for approx. 8 se-

conds until the LED ashes blue and red alternately .

With the LED ashing red/blue, search for devices from the phone (refer to the mo-

bile phone or navigator instruction manual).

6 - Telephone + stereo function A2DP

With this combination, the connection to the telephone function takes priority.

• During a telephone conversation, the playing of music is not permitted.

• When listening to music, you can answer a telephone call received. Press and

release the MFB button to enable the call. At the end of the call, music will auto-

matically continue playing from the exact point at which it had stopped.

• To refuse a call, press and hold the MFB button for approximately four seconds.

• To adjust the volume, press the buttons Volume + Volume - or , depending on

the desired volume level.

N.B.: In telephones equipped with musical players, and therefore which include a Ste-

reo (A2DP) prole, the Telephone + Stereo (A2DP) function coincides.

7 - Intercom - Pairing

After having turned the two o, press and hold the MFB buttons InterphoneF4S

on both until the warning light alternates red and blue ashes. This will take about

8 seconds.

When both LEDs ash red/blue alternately, press and release the MFB button on

one of the two InterphoneF4S.

The two InterphoneF4S are connected when both LEDs show a xed blue light.

8 - Intercom function

To enable intercom function: to enable the conversation in an intercom prole,

press the MFB button on one of the two , and hold for about 3 seInterphoneF4S -

conds. An audible warning will advise you when connection has occurred.

Conversation in intercom mode is full-duplex.

To disable intercom function: to disable intercom function, simply press and re-

lease the MFB button.

9 - Bluetooth® specications®

Bluetooth®:

v2.1 EDR

Supported proles:

Headset – Handsfree – A2DP / AVRCP / SBC

3 - Connecting to a phone

From the Bluetooth menu on your mobile phone (such as the sample iPhone menu

shown below), search for a new device.

When the device is found, select InterphoneF4S. Connection will take place

automatically after a few seconds.

If a password is required, enter 0000.

4  Telephone Function

To answer a call: as a call comes in, the speaker produces a warning sound or the

telephone’s ring: to answer, simply press and release the MFB button.

To end a call: to end a call, simply press and release the MFB button.

Vocal call: some telephones allow you to make a vocal call simply by pressing and

releasing the MFB button.

To refuse a call: to refuse the call, press and hold the MFB button for approximately

4 seconds.

To refuse a call in mode, follow the instructions given in the FUNCTION VOX VOX

section.

Volume adjustment: to adjust the volume, press the buttons or Volume + Volu-

me -, depending on the desired volume level.

5 - Music remote control

Play/Pause: press and release the MFB button twice.

Rew: press and hold the button for 3 seconds.Volume -

FF: press and hold the button for 3 seconds.Volume +

Volume: To adjust the volume, press the buttons or , depenVolume + Volume - -

ding on the desired volume level.

Interphone F4S

Produktspecifikationer

Varumärke:	Cellular Line
Kategori:	Hörlurar
Modell:	INTERPHONE F4S
Färg på produkten:	Grijs
Vikt:	- g
Kraftkälla:	Kabel
Instruktioner:	Ja
Avsedd för:	Kantoor
Rekommenderad användning:	PC
Antal knappar:	11
Förbindelse:	USB Type-A
Rulla typ:	Wiel
Rörelseupplösning:	- DPI
Minimal processor:	Pentium 500
Typ av knappar:	Aanraaktoets
Skrolla:	Ja
Antal scrollhjul:	1