Celly PT-PDAC02R1 Bruksanvisning
Läs gratis den bruksanvisning för Celly PT-PDAC02R1 (8 sidor) i kategorin powerbank. Guiden har ansetts hjälpsam av 20 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 10.5 recensioner. Har du en fråga om Celly PT-PDAC02R1 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/8
Please read this manual and
pay attention to the safety
warnings before using the
product
Keep the manual to have the possibility
to consult it at a later time, or in case of
passing the product to a third party.
DATAplus Supplies Inc. will in no way be
held responsible for injury or damage
caused to persons or property resulting
from improper use of the product.
Safety notes
To avoid malfunction or damage to the
product, avoid accidental drops, crush,
puncture or exert a high level of pressure
on the product. is could cause an
internal short circuit and / or overheating.
Keep away from moisture, water or other
liquids. If the product comes into contact
with water, moisture or other liquids,
do not use the product to avoid electric
shock, explosion or damage.
If the product gets wet, even if it dries and
operates normally, the battery contacts
and circuitry may slowly corrode and pose
a safety hazard.
Do not store or expose the product to
any heat source, direct sunlight, radiators,
stoves or other heat sources such as the
dashboard of your car in the summertime.
is could cause the battery to explode
or affect performance. Never use the
product unsupervised.
During operation, the case will become
hot. Allow adequate ventilation. e
casing must never be covered.
Never use the product when moving
from a cold to a warm environment.
Condensation may form which, in some
cases, could damage the product.
Allow the product to reach room
temperature before plugging it back in
and using it again.
is could take several hours.
Usage temperature: 0-40 ° C.
Do not attempt to modify, repair
or disassemble the product. Risk of
explosion!
Do not leave the product in contact with
metal objects.
Metallic objects can interfere with
the electrical connections causing the
protection circuit to malfunction.
Stop using the product immediately if you
notice any swelling, dispersion or other
abnormality.
Do not use a damaged product.
Make sure that the cable provided for
charging the product is intact and does
not short circuit the charging ports.
A non-replaceable rechargeable battery
is built into the product, never open or
disassemble the product. Do not short-
circuit the battery contacts / terminals.
Do not dispose of the product in open
flames. Danger of explosion and fire!
Charge the battery regularly, even when
the product is not in use. is will extend
its life (at least once every 2 months)
Never charge the product when
unattended. While charging, place the
product on a heat-resistant surface. Heat
build-up is normal when charging.
Under no circumstances use aggressive
cleaning agents, alcohol or other chemical
solutions for cleaning as they could
damage the housing or even compromise
the functionality of the product.
Disconnect all connected cables before
starting cleaning. Do not immerse the
product in water or other liquids.
Do not press too hard on the housing to
avoid scratches and damage. Keep the
product out of the reach of children. Never
allow children or people with disabilities
to use electrical products unsupervised.
Make sure children do not play with
the plastic wrap. ey could swallow
fragments and choke.
Charging the power bank
1. Plug the smaller end of the supplied
micro USB cable into the micro USB port
on the power bank.
2. Plug the larger end of the micro USB
cable into the USB port of a charging
socket or computer. Charging of the
power bank will start. It is recommended
to charge 12 hours for the first charge
cycle. While charging, a white light will
flash. When charging is complete, the
white light will stop flashing and stay on.
e time required for charging is 6 hours.
3. Disconnect the micro USB cable from
the USB port of the power bank after
charging.
Loading devices
1. Make sure the power bank is sufficiently
charged.
2. Before charging the device, make sure
that the technical characteristics (Voltage,
output and amperage) are compatible
with the powerbank.
3. Connect the device to the USB port of
the powerbank using the original cable
supplied with your device. Charging of the
device will start.
4. Disconnect the device cable from the
device and the power bank after charging.
Cleaning
Disconnect all cables before cleaning.
If necessary, clean the power bank with a
damp cloth and allow it to dry completely
before use.
Use a clean brush with soft, long bristles
to remove dust from the connectors.
Do not use solvents, corrosive agents or
gaseous cleaners.
Make sure that water or other liquids do
not enter the housing.
Storage
Store the power bank in a clean and dry
area. Keep away from direct sunlight.
User information for proper
disposal (Directive 2013/56 / EU)
e crossed-out bin symbol shown
on the equipment or on its packaging
indicates that the product at the end of
its useful life, including the non-removable
battery, must be collected separately
from other waste to allow for proper
treatment and recycling. e safe use of
this product is guaranteed in compliance
with the following instructions, therefore
it is necessary to keep them and follow
them scrupulously throughout the life
of the product. e product does not
require technical maintenance, NEVER
DISASSEMBLE IT. e battery inside is
integrated and not replaceable. Do not
attempt to remove the built-in Lithium
Ion / Polymer battery yourself as it
may cause overheating, fire and injury.
e battery should only be removed by
independent qualified professionals who
are able to remove it safely and disposed
of in accordance with applicable laws. e
user must therefore give the equipment
at the end of its life free of charge to
the appropriate municipal centers for
the separate collection of electrical
and electronic waste, or return it to the
retailer, on a one-by-one basis, or free
of charge for appliances with smaller
external dimensions. to 25 cm. Adequate
separate collection for the subsequent
sending of the decommissioned
equipment for recycling, treatment and
environmentally compatible disposal
helps to avoid possible negative effects
on the environment and health and
favors the reuse and / or recycling of the
materials of which it is composed the
equipment. Illegal disposal of equipment,
batteries and accumulators by the user
involves the application of the penalties
provided for in the current legislation.
Technical specifications
MicroUSB input: DC 5V / 2A
Type-C input: DC 5V / 2A
USB A1 output: DC 5V / 1A
USB A2 output: DC 5V / 2.1A
Output Type-C: DC 5V / 2.1A
Total output: DC 5V / 2.1A
Capacity: 10000mAh / 37Wh
Battery type: Li-ion battery
Weight: 223g
Usage temperature: 0 - 40 °C
is product complies with
RoHS 2011/65 / EU-2015/863
/ EU. e product is marked with
the CE mark and complies with the safety
standards established by the European
Union.
Pantone Licensed Manufacturer
2022 © DATAplus Supplies, Inc. registered in Taiwan.
Address: 9th Floor, 279, Hsin Yi Road, Sec. 4, Taipei, Taiwan.
All products are designed by DATAplus and used under license.
Imported by Esprinet Spa
via Energy Park 20 - 20871 Vimercate (MB) - Italy
Made in China.
Instruction manual
PORTABLE POWERBANK
Model: PT-PB1000V2
Rev00 - 28.03.2022
EN
Produktspecifikationer
| Varumärke: | Celly |
| Kategori: | powerbank |
| Modell: | PT-PDAC02R1 |
Behöver du hjälp?
Om du behöver hjälp med Celly PT-PDAC02R1 ställ en fråga nedan och andra användare kommer att svara dig
powerbank Celly Manualer
29 December 2024
29 December 2024
27 December 2024
26 September 2024
25 September 2024
9 September 2024
9 September 2024
9 September 2024
8 September 2024
7 September 2024
powerbank Manualer
- Zipper
- Vivanco
- Skullcandy
- Hamlet
- Agfaphoto
- Sweex
- Kanex
- XLayer
- Scosche
- Aluratek
- Maxell
- Philips
- Vultech
- Laser
- Nedis
Nyaste powerbank Manualer
2 April 2025
30 Mars 2025
30 Mars 2025
28 Mars 2025
27 Mars 2025
27 Mars 2025
27 Mars 2025
27 Mars 2025
14 Mars 2025
14 Mars 2025