Chord SPM 1400 Mk2 Bruksanvisning

Chord mottagare SPM 1400 Mk2

Läs gratis den bruksanvisning för Chord SPM 1400 Mk2 (5 sidor) i kategorin mottagare. Guiden har ansetts hjälpsam av 9 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 5 recensioner. Har du en fråga om Chord SPM 1400 Mk2 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/5

SPM 1400 MK2

POWER AMPLIFIER MANUAL

OPERATING INSTRUCTIONS

INSTALLATION

Your amplier should be positioned to ensure a free ow of air over the rear heat sink and through the upper and

lower grilles. When driven continuously at well above average listening levels, the temperature on the heat sink may

exceed 50oC. This is not a fault, but an indication of the need for adequate ventilation.

Please ensure that the IEC mains lead is correctly terminated.

UK/EUROPE Brown = LIVE = Black USA/CANADA

Blue = NEUTRAL = White

Yellow/Green = EARTH = Green

THE SPM 1400 Mk 2 MUST BE EARTHED AT ALL TIMES VIA ITS OWN MAINS LEAD.

FAILURE TO DO THIS MAY BE HAZARDOUS.

CE This unit complies with EN 50081-1 & IEC 801/2

It has come to light that, in some European

countries a hum may occur if Pre and Power

Ampliers are connected to mains wall sockets

which do not have an earth. Please ensure

that, if this is the case, the pre and power amps

are connected via a multi-way mains block

which contains an earth point at each socket

outlet. This is to ensure that the chassis

metalwork of each item is connected together

and Chord Electronics Limited rmly

recommends that an earthing method for the

building is implemented.

REAR PANEL

The rear of the SPM 1400 Mk 2 has two sets of inputs, one set of balanced XLR connections and one set of phono

RCA connectors. You will also notice by looking at the diagram below that the inputs can be connected as either

INVERTING or NON-INVERTING modes. Connecting to either the phono or the XLR on the right hand side will

give an inverted output as is normal with other Chord amplication. However if a non-inverting output is preferred

simply connect to the left hand side.

As the SPM 1400 Mk 2 is of mono block construction only one of the inputs should be used. Where a pair of units is

used for stereo operation the user should take care to connect both ampliers in the same manner so as not to have an

out of phase configuration. The input should be connected last, with the amplier switched o.

There are two sets of high current gold plated output terminals, the speaker may be connected to either the left or the

right set of terminals. For Bi-wiring conguration both sets of outputs can be used.

Produktspecifikationer

Varumärke:	Chord
Kategori:	mottagare
Modell:	SPM 1400 Mk2
Färg på produkten:	Grijs
Bredd:	180 mm
Djup:	70 mm
Höjd:	20 mm
Snäll:	Model Railways Parts & Accessories
Rekommenderad ålder (min):	- jaar
Antal per paket:	1 stuk(s)
Varumärkeskompatibilitet:	Faller
Föreslaget kön:	Jongen/meisje
Antal bitar:	70 stuk(s)
Typ produkt:	Perron
Maträtt:	H0 (1:87)/TT (1:120)