Delonghi PACEL92HP Bruksanvisning

Läs gratis den bruksanvisning för Delonghi PACEL92HP (7 sidor) i kategorin Luftkonditionering. Guiden har ansetts hjälpsam av 44 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 7 recensioner. Har du en fråga om Delonghi PACEL92HP eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

12

INTRODUCTION

Thank you for choosing a De’Longhi product. Please take a few

moments to read the instructions to avoid risks or damage to the

appliance.

DESCRIPTION

Description of the appliance (see page 2 - A)

A1air outlet grille

A2control panel

A3handles

A4castors

A5silver ion lter

A6air intake grille

A7air exhaust hose housing

A8air intake grille

A9power cable

A10drainage hose with cap

A11remote control signal receiver

A12remote control compartment

Description of the accessories (see page 2- B)

B1wall ange with cap

B2air exhaust hose

B3hose adaptor

B4adapter for window bracket

B5window bracket with wing nut

B6adapter for wall mounting/window outlet

B7window outlet

B8remote control

B9window bracket cap

ELECTRICAL CONNECTION

Before plugging into the mains, check the following:

• the mains voltage is the same as that indicated on the plate

on the back of the appliance;

• the socket and electrical line are sized to support the load

required;

• the socket is the proper type for the plug, otherwise, re-

place the socket;

• the socket is connected to an ecient earthing system.

The manufacturer is not responsible in the event of non-

compliance with these injury prevention standards.

• The power cable must only be replaced by special-

ised technicians.

USE

The instructions below will enable you to prepare your air con-

ditioner for operation as eciently as possible. Before use, make

sure the air intake and outlet grilles are unobstructed.

Please note: This appliance is provided with an auto-evapora-

tion feature for condensate removal during cooling and dehu-

midifying modes.

AIR CONDITIONING WITHOUT INSTALLATION

CASEMENT WINDOW

If you have a casement window proceed as follows:

• Fit the air exhaust hose (B2) in the relevant housing located

on the rear side of the appliance (g. 1).

• Screw the window outlet(B7) and place outside the win-

dow to exhaust the hot air (g. 2).

DOUBLEHUNG WINDOW

If you have a double-hung window proceed as follows:

• Insert and lock the adapter for window bracket (B4) into

the slot of the window bracket (B5) (g.3)

• Place the window bracket in the window sill, and extend

the bracket fully within the window frame (g. 4).

• Fix the bracket by the wing nut (g. 5) (Should the window

bracket be too large for the window the plastic can be cut

with a saw by a qualied professional).

• Insert the air exhaust hose (B2) into the adapter for win-

dow bracket (B4) and rotate it as shown in g. 6.

• In order to facilitate the tting of the air exhaust hose (B2)

in the relevant housing located on the rear side of the appli-

ance, position the hose adapter ‘s tabs (B3) in a horizontal

axis as shown in g. 7 and proceed as shown in g.1.

SLIDING WINDOWS

• Thanks to the locking wing nut, it’s possible to use the win-

dow bracket also for sliding windows. Position the bracket

vetically with the hole in the lower part so to allow a correct

installation of the exhaust hose.

AIR CONDITIONING WITH INSTALLATION

• Fit the air exhaust hose (B2) in the relevant housing located

on the rear side of the appliance (g. 1).

• Drill a hole 150 mm in an outside wall or through a window

panel. Respect the distances, dimensions and heigh of the

hole given in gure 8.

Produktspecifikationer