Denver PWP-62 Bruksanvisning

Läs gratis den bruksanvisning för Denver PWP-62 (2 sidor) i kategorin Skrivare. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 9 recensioner. Har du en fråga om Denver PWP-62 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Water Transfer Photo Paper

Safety Precautions & Warnings

Age Restriction: Recommended for adults. Not suitable for children under 13 years of age. Use by children must be

under direct adult supervision.

Skin Sensitivity Test: Before full application, perform a patch test. Apply a small piece of the tattoo to a discrete area (e.g.,

inner arm) and wait 24 hours to check for any signs of allergic reaction. Discontinue use immediately if any irritation

occurs.

Application Sites - STRICTLY AVOID:

Eyes, eyelids, and immediate surrounding area.

Lips, inside the mouth, and mucous membranes.

Broken, irritated, sunburned, or diseased skin.

Areas with recent scars or tattoos.

Ingestion Hazard

The product components are not meant to be eaten. If swallowed, seek immediate medical attention.

Flammability:

Keep away from fire and high heat sources.

In Case of Accidental Contact with Eyes: Rinse immediately with plenty of clean water and seek medical advice if

irritation persists.

Eye Contact

In case of accidental contact with the eyes, rinse immediately with plenty of clean water. If irritation persists, seek

medical advice.

Step 1: Print

Place the white tracing paper, print side down, into the printer's paper tray, and select the image/photo you want to

print in the app. (Please be sure to select mirror printing.)

NOTE: After printing, let the sticker lie flat at room temperature (25°C) for at least 90 seconds to ensure the ink is

completely dry.

Step 2: Transfer

Peel off the blue transfer sticker and then apply it completely over the design, please make sure to cover the photo

completely, you can use a tissue to help press the two sheets together.

Step 3: Cut Out

Carefully cut out the design along its outline using scissors. Leaving a small white border can improve the result.

Step 4: Apply

Tear off the transparent film slowly, firmly place the tattoo design side (glue side) onto clean, dry skin at the desired

location.

Step 5: Wet

Thoroughly wet the backing paper (the Water-Soluble Adhesive Layer) attached to the pattern with water. Hold for

approximately 15-20 seconds.

Step 6: Remove

Gently slide and remove the outer white backing paper. The pattern will now be completely transferred onto your skin.

Step 7: Dry

Gently blot away excess water with a clean towel or paper towel and let it air dry completely to set the colors.

Daily Care:

Avoid intense contact with water for the first hour after application.

Produktspecifikationer