Dyson CR01 Aqua Bruksanvisning
Dyson
tvättmaskin
CR01 Aqua
Läs gratis den bruksanvisning för Dyson CR01 Aqua (13 sidor) i kategorin tvättmaskin. Guiden har ansetts hjälpsam av 17 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 9 recensioner. Har du en fråga om Dyson CR01 Aqua eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/13
DYSON CR01
DRUM BEARING REPAIR
I have written this guide assuming that the reader has no knowledge on how to dismantle
any part of the Dyson CR01. Having never worked on a CR02, I am unaware if the
construction of that model differs greatly.
I have borrowed various images from the net and thank everyone for their contribution.
Read each paragraph twice before starting that phase of dismantling.
Tools required.
a) Set of Torx bits / screwdrivers
b) Large hammer
c) Bolster.
d) Set of metric spanners / sockets
e) Digital Camera. (Always a good idea to photograph in situ before your remove)
1) Disconnect from the water and electricity supply and remove hoses. Drain as much
water from the machine as possible by removing the coin trap cover and putting the drain
pipe as low as possible.
2) Remove the top cover. Remove the two Phillips screws at the rear of the cover and slide
it backwards
3) Remove soap dispenser. The yellow catch at the rear of the dispenser allows it to be
removed.
4) Remove front controls / display.
a)This is held on with two torx screws and when removed should be slid downwards.
This will release the plastic tabs that hold it in place.
b) Disconnect the ribbon cable from where it attached to the machine body.
c)Remove the pressure sensor pipe. This just pulls off.
d) Disconnect the four power cables to the main on / off switch. The position of the
cables should be recorded for reassembly.
The entire control panel assembly should now be free
5) Remove exterior door. This is held in place with spring clips / hinges that are visible. I
found it easy to insert a flat screw driver into the hinge and push down the yellow clip.
6) Remove front panel. This is held in place with 4 torx screws and a number of plastic
tabs. Care should be taking not to break the plastic tabs. 2 screws are clearly visible on
the top of the panel and the other two are recessed into the hinge of the exterior door. If
you have not already removed the coin trap cover then this is the time do it as the front
Produktspecifikationer
| Varumärke: | Dyson |
| Kategori: | tvättmaskin |
| Modell: | CR01 Aqua |
Behöver du hjälp?
Om du behöver hjälp med Dyson CR01 Aqua ställ en fråga nedan och andra användare kommer att svara dig
tvättmaskin Dyson Manualer
10 Januari 2025
30 September 2024
17 Augusti 2024
14 Augusti 2024
6 Augusti 2024
23 Juli 2024
tvättmaskin Manualer
- Calor
- John Lewis
- Eudora
- Winia
- Eurom
- Dexter Laundry
- Cecotec
- Technika
- Artusi
- Comfee
- Avanti
- Lynx
- Foppapedretti
- Gaggenau
- WLA
Nyaste tvättmaskin Manualer
23 Oktober 2025
23 Oktober 2025
21 Oktober 2025
21 Oktober 2025
20 Oktober 2025
20 Oktober 2025
20 Oktober 2025
20 Oktober 2025
20 Oktober 2025
20 Oktober 2025