Electro Harmonix Freeze Bruksanvisning
Läs gratis den bruksanvisning för Electro Harmonix Freeze (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 24 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 12.5 recensioner. Har du en fråga om Electro Harmonix Freeze eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
FREEZE
Innite Sound Retainer
Congratulations on your purchase of the Electro-Harmonix pedal! At the FREEZE
simple push of a button, the will allow you to sustain individual notes and FREEZE
chords indefinitely. With three different modes of operation, it’s easy to set up just
the right type sound retention for the club, the studio or your bedroom. of
– – CONTROLS
EFFECT LEVEL –Controls the volume of the sustained sound. The output
always contains the dry signal at its original volume
MODE SWITCH – Selects between one of three effect modes: FAST, SLOW, and
LATCH. See the MODE DESCRIPTIONS section for more detail .
STATUS LED – The LED is on while the effect is sounding or fading out. When the
LED is off, the effect is completely silenced and the output contains only the pure dry
signal.
INPUT JACK – Connect the output of your instrument or another effects pedal to
this jack. The input impedance presented at the INPUT jack is 2.2 M .
AMP JACK – Connect the AMP jack to your amplifier input or the input of another
effects pedal. The output impedance at this jack is . 470
9V Power Jack – Plug the output of the supplied AC Adapter into this jack located
at the top of the . The current requirement is at 9VDC. FREEZE FREEZE’s 140mA
The polarity of the power jack is center-negative. The FREEZE accepts most Boss
style AC Adapters.
– – MODE DESCRIPTIONS
FAST FREEZE–When the footswitch is triggered, the will immediately sustain the
current input. The sound will be sustained until the footswitch is released, at which
point the effect will immediately disengage.
WARNING: Your Freeze pedal comes equipped with an Electro-Harmonix
9.6DC-200BI power supply (same as used by Boss™ & Ibanez™: 9.6 Volts
DC 200mA). The Freeze requires 140mA at 9VDC with a plug that is center
negative. The Freeze does not take batteries. Using the wrong adapter may
damage your unit and void the warranty.
Produktspecifikationer
| Varumärke: | Electro Harmonix |
| Kategori: | Inte kategoriserad |
| Modell: | Freeze |
Behöver du hjälp?
Om du behöver hjälp med Electro Harmonix Freeze ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Electro Harmonix Manualer
2 April 2025
2 April 2025
2 Januari 2025
30 December 2025
30 December 2025
30 December 2025
30 December 2025
5 December 2024
24 September 2024
24 September 2024
Inte kategoriserad Manualer
- Metrix
- Monzana
- Crivit
- Sena
- Teia
- XP-PEN
- IMM Photonics
- Titanwolf
- Fakir
- Solplanet
- Davis
- Schuberth
- Steiner
- AV Tool
- Deltex
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025