Elite Screens Manual M120XWV2 Bruksanvisning

Elite Screens Projektionsduk Manual M120XWV2

Läs gratis den bruksanvisning för Elite Screens Manual M120XWV2 (2 sidor) i kategorin Projektionsduk. Guiden har ansetts hjälpsam av 23 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 12 recensioner. Har du en fråga om Elite Screens Manual M120XWV2 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
Rev. 110216-DR info@elitescreens.com www.elitescreens.com
Back of end cap
Front view
Manual SRM Series
Manual Pull-Down Projection Screen
USER’S GUIDE
Pre-Installation
1. Carefully unpack the screen.
2. Always handle the screen in a leveled position on a clean surface.
NOTE:
Regardless of mounting method, the screen should be securely supported so that vibration or even abusive
pulling on the viewing surface will not cause the case to work loose or fall. The installer must insure that the
fasteners used are of adequate strength and suitable for the mounting surface chosen.
INSTALLATION
Flush Wall Mounting
1. Mark the location of where the screen is to be
installed for the pre-drilled hole.
2. After marking the area and drilling the hole,
insert the proper screw into the drilled hole and leave about
1/8” of an inch from the wall to mount the screen.
3. Mount your screen from the keyhole located on back of
screen’s left and right end cap.
Ceiling Mounting
(additional hardware required)
Optional installation using a chain to hang the screen from the
ceiling.
1. You can also hang the screen on a ceiling by using a
chain (not included) and hang it by the two loops
located on each end of the case.


Produktspecifikationer

Varumärke: Elite Screens
Kategori: Projektionsduk
Modell: Manual M120XWV2

Behöver du hjälp?

Om du behöver hjälp med Elite Screens Manual M120XWV2 ställ en fråga nedan och andra användare kommer att svara dig