Enda ET2011 Bruksanvisning

Enda Termostat ET2011

Läs gratis den bruksanvisning för Enda ET2011 (4 sidor) i kategorin Termostat. Guiden har ansetts hjälpsam av 29 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 15 recensioner. Har du en fråga om Enda ET2011 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/4

230V AC +%10 -%20, 50/60Hz 24V AC %10, 50/60Hzor

Max. 5VA

Power : , Si : 1 ²connector 2.5mm²' screw-terminal gnal connector ,5mm screw-terminal conenction.

EEPROM ( )minimum 10 years

Max. 100ohm

1 bit2

00ms1

R : 250V AC, 8A (for resistive load), Selectable as NO+NC Control or Alarm2 output.elay

°C

Withot load 30.000.000 mechanical operation; 250V AC, on the 8A resistive load 100.000

electrical switching

C/A2 output

ENDA ET2011 PID TEMPERATURE CONTROLLER

* x mm .77 35 sized

Thank you for choosing 2011 temperature controller.ENDA ET

TECHNICAL SPECIFICATIONS

* Selectable dual-set value.

* Se tlectable thermocouple ypes or Pt100 input.(Selection must be

* Soft-Start feature.

* (SELF TUNE).Automatic calculation of PID parameters.

* Selectable heating/cooling control.

* C/A2 Relay output can be programmable as alarm or control output.

* .Selectable SSR control output

* Input offset feature.

* In the case of sensor failure periodical running or relay state can be

selected.

Input type

Temperature range

J (Fe-CuNi) Thermocouple

K (NiCr-Ni) Thermocouple

T (Cu-CuNi) Thermocouple

S (Pt 0Rh-Pt) T1 hermocouple

R (Pt13Rh-Pt) Thermocouple

EN 60584

0... 600

0...1300

0... 400

0...1700

°C

Accuracy

0, % ( )5 of full scale

1 digit

0, % ( )5 of full scale 1 digit

+32... +1112

+32... +2 237

+32... +752

+32... +3092

°F

°C

°F

SSR output

Max 20mA 12Volt (as control output)

SET

°C

SET

ET2011

ENDA

°F

C/A2

SSR

Pt 100 Resistance thermometer

EN 60751

EN 60751 -200...600 °C

-328...1112 °F

- ... 00 °C99.9 3 .0

- ...543 °F99.9 .0

0,5% (of full scale)

1 digit

0,5% (of full scale) 1 digit

specified in order).

Enter PID parameters of the system if they are known at the beginning.

Otherwise, Self-Tune should be activated.

ENVIRONMENTAL CONDITIONS

Height

Max. 2000m

80 up to 31 decreasing linearly 50 at 40.% %

Ambient/storage temperature

Max. Relative humidity

0 ... +50 /°C -25... +70°C (with no icing)

Rated pollution degree

According to EN 60529 Front panel : IP65

Rear panel : IP20

Do not use the device in locations subject to corrosive and flammable gases.

OUTPUTS

Life expectancy for relay

ELECTRICAL CHARACTERISTICS

Supply

Power consumption

Wiring

Line resistance

Data retention

EMC

Safety requirements

EN 61326-1: 2006

EN 61010-1: 2010 (Pollution degree 2, overvoltage category II)

CONTROL

Control type

Single set-point and alarm control

Control algorithm

A/D converter

Sampling time

Proportional band

Control period

Hysteresis

Output power

Adjustable between 0 and 100 . If Pb=0 , On-Off control is selected.% % %

and 250 secondsAdjustable between 1

1 and 50Adjustable between °C/F

The ratio of power at a set point can be adjusted between 0 and 100% %

HOUSING

Housing type

Suitable for flush-panel mounting according to DIN 43 700.

Dimensions

W77xH35xD71mm

Weight

Approx. 200g (after packing)

Self extinguishing plastics.

Enclosure material

While cleaning the device, solvents (thinner, benzine, acid etc.) or must not be used.corrosive materials

Read this document carefully before using this device. The guarantee will be expired by

damaging of the device if you don't attend to the directions in the user manual. Also we don't

accept any compensations for personal injury, material damage or capital disadvantages.

R : 250V AC, 16A (for resistive load), Selectable as NO Control or Alarm2 output.elay

english

1. / 4

E-mail : info@suran-elektronik.de

Internet : www.suran-elektronik.de

Tel.: +49 (0)7451 / 625 617

Fax: +49 (0)7451 / 625 0650

SURAN Industrieelektronik

Dettinger Str. 9 / D-72160 Horb a.N

ET2011-E-06052019

Produktspecifikationer

Varumärke:	Enda
Kategori:	Termostat
Modell:	ET2011
Enhetsplacering:	Ingebouwd
Typ av operation:	Touch
Färg på produkten:	Zwart
Antal effektnivåer:	17
Inbyggd display:	Ja
Timer:	Ja
Bredd:	583 mm
Djup:	513 mm
Höjd:	55 mm
Sladdlängd:	1.1 m
Barnlås:	Ja
Integrerad klocka:	Ja
Typ av klocka:	Elektronisch
Typ av material (överst):	Glaskeramiek
Brännare/kokzonseffekt 2:	1800 W
Brännare/kokzonseffekt 3:	1400 W
Brännare/kokzonseffekt 1:	1800 W
Antal brännare/kokzoner:	4 zone(s)
Typ av häll:	Inductiekookplaat zones
Antal gasbrännare:	- zone(s)
Antal elektroniska kokzoner:	4 zone(s)
Kontrollposition:	Voorkant
Ansluten last (elektrisk):	7400 W
Installationsfackets bredd:	560 mm
Installationsfack höjd:	55 mm
På / Av knapp:	Ja
Ansluten last (gas):	- W
Automatisk avstängning:	Ja
Skriv timer:	Digitaal
Bredd på häll:	60 cm
Boost funktion:	Ja
Installationsutrymmets djup (min):	490 mm
Automatisk avstängningstimer lagar mat på ett säkert sätt:	Ja
Brännare/kokzonseffekt 4:	2200 W
Strömkälla brännare/kokzon 1:	Electrisch
Strömkälla brännare/kokzon 2:	Electrisch
Strömkälla brännare/kokzon 3:	Electrisch
Strömkälla för brännare/kokzon 4:	Electrisch
Kookzone 1 boost:	3100 W
Kookzone 2 boost:	3100 W
Kookzone 3 boost:	2200 W
Kookzone 4 boost:	3700 W
Installationsutrymmets djup (max):	500 mm
Placera brännare/kokzon 1:	Links voor
Diameter brännare/kokzon 1:	180 mm
Placera brännare/kokzon 2:	Links achter
Placera brännare/kokzon 3:	Rechts achter
Brännare/kokzons diameter 3:	145 mm
Placera brännare/kokzon 4:	Rechts voor
Brännare/kokzons diameter 4:	210 mm
Kokzon 2 storlek (BxD):	180 x 280 mm
Bänkskivans tjocklek (min):	16 mm