Extron SM 26 Bruksanvisning
Läs gratis den bruksanvisning för Extron SM 26 (4 sidor) i kategorin högtalare. Guiden har ansetts hjälpsam av 35 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 18 recensioner. Har du en fråga om Extron SM 26 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
Number of Wires
per Connection Point
Maximum
Wire Gauge
1 12 GAW
2 16 GAW
4 18 GAW
Wire Gauge Table
5.1"
(13.0 cm)
6.0"
(1
5.2 )cm
2.6"
(6.6 cm)
3.5"
(8.9 cm)
R = 0.28"
(0.71 )cm
SMK P SM 26/28 Pivot Mount Kit • Setup Guide
This setup guide contains installation information about the Extron SMK P SM 26/28 Pivot Mount Kit.
WARNING: Installation and service must be performed by authorized personnel only.Potential risk of severe injury.
AVERTISSEMENT : Risque potentiel de blessure grave ou de mort. L’installation et l’entretien doivent être effectués par
le personnel autorisé uniquement.
ATTENTION: The final installation should be able to continuously support the speaker weight. The final installation should
also be able to support any short term overloading. Since applications can vary considerably, it is assumed that the
installer will exercise good judgment when selecting the mounting location, method, and hardware. Installation and service
must be performed by authorized personnel only.
Installing the Pivot Mount Kit
The pivot mount enables the speaker to be positioned
and locked at various angles due to the adjustable ball
joint feature.
NOTE: Observe all applicable building codes and
local ordinances when installing the speaker.
ATTENTION: Attaching a secondary support
cable to the SM 26/28 speaker is required when
using the pivot mount kit.
1. Locate a suitable mounting location where the
pivot mount will be installed. Allow for the
dimensions of the SM 26 and SM 28, as shown
below.
SM 28 SM 26: :
2. All four mounting plate
screw holes must be secured
with at least two
screws attached to
a wall stud. Mark
the four holes on
the wall as indicated
by the wall plate
holes.
NOTE:
Mounting
hardware
is not
provided.
3. Drill the four holes
for the wall plate.
4. Drill a hole for the speaker wire.
5. Route the speaker wire through the speaker wire hole
while leaving enough slack for connection to the wall
plate.
NOTE: If the speaker wire is not being routed
through the wall, a notch on the wall plate allows
the wire to enter the wall plate from a raceway.
6. Attach speaker wires to the Euroblock on the wall plate.
Quick Connect Contacts
1
11.50"
(29.21 cm)
2.44 - 3.35"
(6.20 - cm 8.51)
7.28"
(18.50 cm)
16.50"
(4
1.91 )cm
9.2"
(23.37 )cm
8.45"
(21.46 cm)
2.44 - 3.35"
(6.20 - cm 8.51)
6.45"
(16.38 cm)
12.98"
(32.97 )cm
9.16"
(23.27 cm)
Produktspecifikationer
| Varumärke: | Extron |
| Kategori: | högtalare |
| Modell: | SM 26 |
Behöver du hjälp?
Om du behöver hjälp med Extron SM 26 ställ en fråga nedan och andra användare kommer att svara dig
högtalare Extron Manualer
12 Mars 2025
25 December 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
högtalare Manualer
- Shure
- Monster
- Tribit
- DOSS
- Osprey
- BW
- Lexibook
- Klip Xtreme
- Seeburg
- Odys
- ESX
- Perfect Choice
- Airpulse
- Gemini
- Revox
Nyaste högtalare Manualer
23 Oktober 2025
20 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
18 Oktober 2025