Fender Passport Event Series 2 Bruksanvisning

Fender hi-fi system Passport Event Series 2

Läs gratis den bruksanvisning för Fender Passport Event Series 2 (44 sidor) i kategorin hi-fi system. Guiden har ansetts hjälpsam av 8 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 4.5 recensioner. Har du en fråga om Fender Passport Event Series 2 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/44

OWNER’S MANUAL | MANUAL DE INSTRUCCIONES

MODE D’EMPLOI | MANUAL DO PROPRIETÁRIO

MANUALE UTENTE | BEDIENUNGSHANDBUCH

INSTRUKCJA OBSŁUGI | NÁVOD K POUŽITÍ

NÁVOD NA POUŽITIE | UPORABNIŠKI PRIROČNIK

SYSTEM SETUP

Congratulations on purchasing a Fender® Passport Event Series 2

audio system—a self-contained portable audio system designed for

great sound anywhere. Carry Passport like a suitcase, and simply flip

open the cabinet-release latches to access two full-range speaker

cabinets, a powered mixer, and power and speaker cables.

Use Passport as a public address system or to amplify musical

instruments and vocals. Connect mobile devices for easy

accompaniment, including Bluetooth pairing. Passport's quick

and easy setup, its ability to cover large audiences and its simple

operation are the hallmarks of this innovative product. Its control

panel features mono mic/line channels and stereo line channels

with a variety of input jacks to provide superb connectivity

flexibility.

ENGLISH

PASSPORT

EVENT SERIES 2

1. OPEN: Flip open cabinet latches on top of Passport

and detach speaker cabinets from powered

mixer section:

3. SPEAKER CABLE/POWER CORD STORAGE: Open storage

compartment on rear of mixer and remove power cord and

speaker cables:

2. PLACEMENT: For optimal results, elevate speaker cabinets on

Passport speaker stands or sturdy tables. Place the speakers far

apart to maximize stereo separation. Position mixer close by

for easy access to control panel:

4. Plug POWER CORD/SPEAKER CABLE CONNECTION:

speaker cables into left and right speaker jacks on back of

the mixer ( ), then connect corresponding upper right arrow

left and right speakers. Make sure power switch is off before

connecting power cord (included) into power inlet on back of

mixer (lower left arrow); plug other end into a grounded AC

power outlet:

ENGLISH

5. INPUTS: Connect microphones to channels 1 through 4;

connect other mono sound sources such as instruments to any

channel ( ). Use channel 6/7 inputs (large arrows smaller arrows) for

stereo/mono sound sources such as keyboards, other line-level

audio sources, and mobile devices:

7. POWER UP: Turn on all external equipment connected to

Passport first, then turn Passport on. Power LED will illuminate

green:

9. SETTING LEVELS: Connect a microphone or other sound

source and slowly turn up that channel's VOLUME control

(curved yellow arrow). LED above VOLUME control will

illuminate green when signal is present. LED will illuminate

yellow when signal is approaching clipping level; will

illuminate red when clipping (distortion) occurs. For best

performance, set channel VOLUME and TONE controls (curved

green arrows) so that LED is green and occasionally yellow.

If LED turns red, reduce VOLUME or TONE control settings.

If LED is still turning red after adjusting VOLUME and TONE

controls, press MIC/LINE button in (straight arrow):

Adjust each channel the same way. Use channel VOLUME

knobs to set relative loudness of each channel for overall

balance, then adjust MASTER VOLUME knob for overall mix

loudness. MASTER VOLUME has a SIGNAL LEVEL METER

just to the right; if meter illuminates red, decrease MASTER

VOLUME accordingly.

6. INITIAL VOLUME/REVERB: Turn MASTER VOLUME knob,

all channel VOLUME knobs and all REVERB knobs fully

counterclockwise to start:

8. SETTING MASTER VOLUME: Turn MASTER VOLUME up to

1/4 volume:

10. SETTING TONE/REVERB: Starting with each TONE

control (TREBLE, BASS) in the center-detented position (flat

equalization), set each TONE control to preference for best

clear and consistent sound coverage throughout the area.

REVERB controls (green arrows) are not center detented; set

these to preference:

Produktspecifikationer

Varumärke:	Fender
Kategori:	hi-fi system
Modell:	Passport Event Series 2
Färg på produkten:	Zwart, zilver
Vikt:	3300 g
Bredd:	440 mm
Djup:	230 mm
Höjd:	540 mm
Förpackningens vikt:	3600 g
Förpackningens bredd:	462 mm
Djuppackning:	130 mm
Förpackningshöjd:	680 mm
Lämplig för:	Binnen
Justerbar termostat:	Ja
Certifiering:	CE
Överhettningsskydd:	Ja
Lämplig för rumsvolymer upp till:	30 m³
Värmekraft:	1000 W
Placeringsalternativ:	Vloer
Värmeeffekt (min):	- W