Flir Pinnacle DPB14TLX Bruksanvisning

Flir övervakningskamera Pinnacle DPB14TLX

Läs gratis den bruksanvisning för Flir Pinnacle DPB14TLX (10 sidor) i kategorin övervakningskamera. Guiden har ansetts hjälpsam av 18 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 9.5 recensioner. Har du en fråga om Flir Pinnacle DPB14TLX eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/10
Please read this manual thoroughly before use and keep it handy for future reference.
Models: DPB14TLX
Ultra Resolution
Day & Night Bullet Camera
www.digimerge.com
V4.0
Ultra Resolution
Day & Night Bullet Camera
INSTRUCTION MANUAL
the
INTRODUCTION
Features
1/3” Sony Super HAD™ II CCD
Excellent low light performance using
Smart IR technology
0.15 Lux / F1.2 (Color)
0.001 Lux w/Sense-Up at x256
600 TV lines(Color) of resolution
3D Digital Noise Reduction (3D-DNR)
OSD menu control
True Day/Night with ICR
Privacy Masking / Motion Detection
VIDEO OUT(BNC)
Test Monitor Output
2.8-10.5mm Varifocal Day/Night Lens F1.4 DC Iris
Octagon junction box compatible
-3-
General DPB14TLX
Image Sensor
1/3” Sony Super HAD™ II CCD
Effective Pixel
H: 768 V: 494
Effective Pixel Area
H: 5.59mm V: 4.68mm
Scan System
2:1 Interlace NTSC
Scan Frequency
H: 15.734KHz, V: 59.94Hz
Synchronization
Internal
Minimum Illumination
0 Lux IR LED On
S/N Ratio
50dB @ AGC Off
Resolution
600 TV Line
White Balance
Auto 1800°K ~ 10500°K
AES Speed
1/60~1/100000 Sec
Gain Control
Auto
BLC
Manual
Video Output
1.0Vpp @ 75 ohm
Termination
BNC Female
Lens/ Lens Mount
2.8-10.5mm F1.4 Varifocal DC Auto Iris
Viewing Angle
H: 96.7° ˜ 24.1°, V: 71.2° ˜ 18.2°, D: 124.3° ˜ 30.2°
Power Source
12V DC / 24V AC
Power Consumption
Max 8.4W
Minimum Power
Requirement
700mA
Operating Temp Range
-40°C ~ 50° C
Operating Range
Within 90% RH
Dimensions (LxHxW)
298x101x88 mm
Gamma
0.45
SPECIFICATIONS
Polaris Vision 2 technology
0.0 w/IR LED
-5--4-
MEASUREMENTS INSTALLATION
PACKAGING CONTENT
PARTS DESCRIPTION
Bullet package contains the following:
Camera in housing ---------------------------------1
Instruction guide (This Document) -------------1
Mounting screw pack ------------------------------1
Service Video Cable -------------------------------1
Sunshield Screw
to camera) -------------1
Allen Key ----------------------------------------------2
1a) Loosen the thread nut with the small
allen key and turn the camera base
counter clockwise to remove it from the
camera mount.
1b) Mount the camera base to the surface.
NOTE: The camera base is compatible with
an Octagon junction box.
2a) Attach camera back onto the camera
base by turning the camera clockwise.
2b) Tighten the thread nut to secure the
camera’s horizontal position.
3) Adjust lens zoom and focus by turning the
two external adjustment screws located
on the underside of the camera.
Adjustment can be made using fingers
or with a flathead screwdriver.
4) The OSD Settings and video test port are
accessed via the service access port
on the underside of the camera. Turn
the cap counter-clockwise to remove.
Note: Apply considerable pressure when
replacing the cap to keep camera
weather proof.
Zoom Adjust Service Access Pan / Tilt Adjustment 360 Rotate Rotate Lock
Thread Nut
Focus Adjust
Open Close
(B) Fitting Screws
PA4 x 35mm 4pcs
(A) Wall Plugs
S8 x 30mm 4pcs
(C) Sunshield Screw
M5 Thread
1
2
3
4
CDS
298.6 mm
11.8"
100.9 mm
4.0"
101.5 mm
4.0"
88.0 mm
3.5"
b
C
(D) Allen Keys
2c) Use the large allen key to adjust the
vertical viewing angle of the camera.
2d) Use the large allen key to twist the
camera around the mounting stand.
d

Produktspecifikationer

Varumärke: Flir
Kategori: övervakningskamera
Modell: Pinnacle DPB14TLX

Behöver du hjälp?

Om du behöver hjälp med Flir Pinnacle DPB14TLX ställ en fråga nedan och andra användare kommer att svara dig