Formula Sound FF2.2L Bruksanvisning
Formula Sound
DJ-utrustning
FF2.2L
Läs gratis den bruksanvisning för Formula Sound FF2.2L (8 sidor) i kategorin DJ-utrustning. Guiden har ansetts hjälpsam av 12 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 6.5 recensioner. Har du en fråga om Formula Sound FF2.2L eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/8
Formula Sound FF2.2 Mixer
Warranty
The FF2.2 has a 1 year parts and labour warranty under reasonable use with the exception of
moving parts.
Reasonable use means operating and storage in a benign environment (0-35 degrees C and
below 60% humidity, dust levels of typical home or bar /club and no contact with liquids), operating
without using undue force on controls, connecting to an appropriate mains supply and connecting
appropriate inputs in the power o condition. Removing screws and/or opening the FF2.2 will
invalidate the warranty.
Moving parts will wear, the warranty for moving parts is 3 months, moving parts are expected to
last at least 10,000 operations which typically will give 1000 hours of mixer use.
Formula Sound Limited accept no responsibility for consequential damage, please read the
specication carefully and ensure any equipment that is connected to the FF2.2 or that the FF2.2 is
connected to is compatible.
In the event of a defect contact Formula Sound Ltd, should your equipment need to be returned
you will be responsible for the cost of the return and ensuring the equipment reaches Formula
Sound Limite without damage in transit. d
In the event of a defect Formula Sound Limited will investigate why the defect occurred and
providing it is covered by the warranty x that defect.
The warranty is in addition to any consumer rights you are entitled to under English law, the
warranty is governed by English Law.
Should you have an issue with your FF2.2 contact us for advice by email info@formula-
sound.co.uk or by telephone on (+44) 161 688 0020.
Introduction
The FF2.2 has 2 main input channels (line/phono) which are situated left and right of the mixer,
additionally there is a channel 3 balanced line input (can be strapped unbalanced) and a
microphone input.
Derived from the FF6.2/FF4.2 the two main input channels have many of the same features but
there are also a few changes. The output section is a very stripped down version of the
FF6.2/FF4.2 output section to t in the middle of the mixer but still retaining the key features.
The channel 1 & 2 phono inputs have the ability to select 1 of 4 capacitances to best match to
your deck cartridge, the phono input circuit is a 2 stage design which gives excellent vinyl
sound reproduction and with switchable rumble and noise lters it would be difcult to nd a
better mixer for vinyl.
The FF2.2 has a remote power supply (not shown), the advantage of a remote power supply is
that noise and magnetic eld of the power supply are kept away from the audio resulting in a
lower noise oor and better audio quality
1
Power Supply
The FF2.2 has an external power supply, this consists of a the power supply block and a mains
cable with local style mains connector at one end and IEC style at the end that plugs into the body
of the remote power supply block.
The FF2.2 has a ying cable with a 7 pin connector on the end, this 7 pin connector plugs into the
remote power supply block, this connector needs to be plugged in to the mating connector on the
remote power supply block and then the outer of the connector turned to screw the connector into
place.
The power supply block has a IEC inlet with mains power switch, a green neon indicates when
the power is on. The FF2.2 uses 3 power rails (+VE, -VE & 5V) which each have a screw in fuse,
see appendix drawing for details.
The FF2.2 should be switched on and o using the switch by the IEC connector on the remote
power supply block.
The Mixer has a fully regulated internal power supply that is designed to operate on
220-240Vac or 110-120Vac, a label on the outside will indicate which mains supply your remote
power supply requires.
DAMAGE MAY RESULT IF THE UNIT IS CONNECTED TO THE WRONG
SUPPLY VOLTAGE.
Mains fuse sizes are 800mA anti-surge for 220-240Vac and 1.5A anti-surge for 110-120Vac
operation.
It is important for safety reasons that the correct fuse sizes are always used.
Master Section
Refer to appendix drawings for positions of controls, inputs and settings accessible through
the base of the FF2.2. Drawings indicate positions and functions, FF2.2 may dier.
Outputs
Master and Booth outputs are available in balanced stereo on XLR connectors along with
unbalanced stereo outputs for each on RCA connectors (the booth output is called record on the
RCA connector).
There is also a mono output on XLR with a switch accessible through the base of the unit that
allows the selection of either mono master or sub bass.
Master and booth each have volume controls on the front panel, additionally there is a booth pan
pot accessible through the base together with a switch that allows the booth to be switched to
mono should it be required.
Master and booth each have 12 LED stereo metering indicating output level in dB.
2
Produktspecifikationer
| Varumärke: | Formula Sound |
| Kategori: | DJ-utrustning |
| Modell: | FF2.2L |
Behöver du hjälp?
Om du behöver hjälp med Formula Sound FF2.2L ställ en fråga nedan och andra användare kommer att svara dig
DJ-utrustning Formula Sound Manualer
28 Juli 2025
22 Augusti 2024
DJ-utrustning Manualer
- Behringer
- Ibiza Sound
- Korg
- Bigben Interactive
- AudioQuest
- Music Hall
- Audient
- PLAYdifferently
- Zoom
- Thomson
- Native Instruments
- Stanton
- Majestic
- Nektar
- Cambridge
Nyaste DJ-utrustning Manualer
29 Juli 2025
27 Juli 2025
27 Juli 2025
26 Juli 2025
26 Juli 2025
25 Juli 2025
25 Juli 2025
25 Juli 2025
25 Juli 2025
25 Juli 2025