Frigidaire CFPWD15A Bruksanvisning

Frigidaire Inte kategoriserad CFPWD15A

Läs gratis den bruksanvisning för Frigidaire CFPWD15A (12 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 1.5 recensioner. Har du en fråga om Frigidaire CFPWD15A eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/12

PIEZAS DEL KIT BLANCO:

D 1 soporte delantero izquierdo.

E 1 soporte delantero derecho.

F 2 soportes traseros.

COMPOSANTS DU NÉCESS. BLANC :

D 1 support avant gauche.

E 1 support avant droit.

F 2 supports arrière.

WHITE KIT COMPONENTS:

D 1 Left Front bracket.

E 1 Right Front bracket.

F 2 Rear brackets.

Use these instructions to mount pedestal

under washer and dryer style to the right

with mechanical style timers.

Utilisez ces instructions pour ﬁ xer un so-

cle sous une laveuse et une sécheuse à la

droite munies d’une minuterie mécanique.

Utilice estas instrucciones para instalar

el pedestal por debajo de la lavadora y

secadora de instalación a la derecha con

temporizadores mecánicos. Washer and dryer consoles with mechanical

style timers.

La consola de la lavadora y la secadora tiene

un temporizador de tipo mecánico.

La console de la laveuse et la sécheuse est

munie d’une minuterie mécanique.

El no desconectar el suministro eléctrico an-•

tes de la instalación apilada puede ocasio-

nar lesiones personales o incluso la muerte.

La instalación inadecuada de la ventilación •

de la secadora puede ocasionar lesiones

personales o daños a la propiedad.

Para evitar lesiones en la espalda u otro •

tipo de lesiones, procure levantar o mover

la lavadora o secadora con la ayuda de

más de una persona.

No apile la secadora sobre la lavadora si •

ya está instalada sobre un pedestal.

Failure to disconnect from power source •

before stacking could result in personal

injury or even death.

Improper installation of dryer venting •

could result in personal injury or damage

to property.

To avoid back or other injury, have more •

than one person move or lift the washer

or dryer.

Do not stack a dryer on top of washer •

already installed on pedestal.

Ne pas débrancher l’appareil de sa source •

d’alimentation en électricité avant de le super-

poser peut causer des blessures, voire la mort.

Une installation inappropriée du système •

de ventilation de la sécheuse peut causer

des blessures ou des dommages matériels.

Pour éviter les blessures au dos ou •

d’autres types de blessure, demandez

l’aide d’autres personnes pour déplacer

ou soulever la laveuse ou la sécheuse.

Ne superposez pas une sécheuse sur •

une laveuse déjà installée sur un socle.

English continued on page 2. Pour la suite de la version française,

reportez-vous à la page 5.

La versión en español continúa en la página 8.

WARNING AVERTISSEMENT ADVERTENCIA

Adjustable wrench

Clé à molette

Llave ajustable

Carpenter’s level

Niveau de charpentier

Nivel de carpintero

Optional universal

wrench available

from dealer

Clé universelle

optionnelle (en vente

chez le détaillant)

Llave universal opcional

(disponible a través

de su distribuidor local)

Phillips screwdriver

Tournevis Phillips

Destornillador Phillips

AND

9/16” or 14 mm box wrench

Clé polygonale de

9/16 po ou de 14 mm

Llave de cubo de

9/16 po o 14 mm

Tools needed: / Outils nécessaires: / Herramientas necesarias:

SCREW KIT COMPONENTS:

14 #10 (16 x .500) screws.C

COMPOSANTS DU NÉCESSAIRE DE VIS:

14 vis n° 10 (16 x .500).C

PIEZAS DEL KIT (TORNILLOS):

14 tornillos n.º 10 (16 x .500).C

1137338900 A (1002)

Allow for approximately 5 in. (12.5 cm) behind the

pedestal for clearance of back of washer or dryer to the wall.

Allow additional space if venting dryer upward or downward.

If locking nuts are not removed on units with metal

feet, mounting holes in appliance will not align to mounting

holes in brackets.

Due to higher center of gravity of appliance on ped-

estals, some side-to-side rocking is normal during operation.

Vibration can be minimized by assuring appliance is installed

properly, including being level and solid on all four (4) legs by

following these directions.

PREPARATION INSTRUCTIONS

If washer or dryer is new and has not been installed yet, skip to 1.

step 4.

If dryer is already installed, disconnect dryer from electrical and 2.

gas connections and exhaust venting.

If washer is already installed, disconnect washer from electrical 3.

connection. Turn off hot and cold water supply and disconnect

hot and cold water supply hoses from water supply outlets.

Disconnect drain hose from drain pipe.

If appliance has plastic feet, screw each foot ﬂ ush to the base.4.

If appliance has metal feet, unscrew them, remove the locking 5.

nut and reinstall the feet ﬂ ush to the base.

A) Preparing washer or dryer for mount-

ing on pedestal

B) Preparing pedestal before mounting

washer or dryer

Locate pedestal to within a few inches of its ﬁ nal location.1.

Level the pedestal front-to-back and side-to-side by adjusting 2.

each leveling leg. Keep leg extension to a minimum.

Rock the pedestal from corner-to-corner to check for stability. 3.

Repeat leveling and rocking until all four (4) feet are sturdy on the

ﬂ oor and pedestal is level.

Without turning the rubber foot, lock each pedestal leg in place 4.

by tightening its lock nut tight against the pedestal base.

DO NOT remove foam!

lock nut

raise

lower

Optional universal

wrench (or adjustable

pliers).

- EXCESSIVE WEIGHT HAZARD - To avoid

back or other injury, have more than one person move or lift

the washer.

C ) 1

Attaching washer mounting hardware

3.1 cu ft WASHER INSTRUCTIONS

D ) Mounting washer1

E1) Installing or re-installing washer

Use the following instructions for mounting this type of washer 1.

to the pedestal:

Using two or more persons, slightly tip the washer back and lift it 1.

onto the pedestal. Still tipped, slide the washer back against the

rear brackets and gently set down the front so the appliance is

between the front and rear brackets.

Remove lower service access panel.2.

Remove 2 lower screws from backsheet of washer. Save screws to 3.

reinstall later.

Attach each front clip to outer-most set of holes with 2 screws.4.

Adjust the appliance side-to-side to align its mounting holes with 2.

the pedestal’s bracket holes.

Reinstall backsheet screws removed earlier through each rear 3.

bracket into the base of the washer.

Reinstall the lower service access panel.4.

Reinstall the 2 screws removed earlier 5.

through the outer hole of

each front bracket into the base of the

washer.

Slide appliance/pedestal into place.1.

Check for levelness and rock all four (4) legs again. Repeat until 2.

level and solid.

Refer to 3. for complete details Washer Installation Instructions

on installing water, drain, or electrical.

SLIDE BACK TIP DOWN

middle

slot

outward

Insert “A” tab of each rear bracket into the middle slots on rear 5.

of pedestal. Orient bracket outward for washer mounting.

“A”

tab

Remove 2 screws

from service access

below front panel.

Remove 2 screws from

washer backsheet.

Install 2 screws through each rear bracket into aligning pedestal 6.

holes.

Produktspecifikationer

Varumärke:	Frigidaire
Kategori:	Inte kategoriserad
Modell:	CFPWD15A
Energie-efficiëntieklasse:	A
Årlig-energiförbrukning:	679 kWu
Snäll:	Buiteneenheid airconditioning
Strömförsörjning:	230V, 50Hz, 10.2A
Kylmedium:	R410A
Inverterteknik:	Ja
Luftkonditioneringsfunktioner:	cooling, heating
Extern ljudnivå:	50 dB
Kylkapacitet (max):	- BTU/h
Kylenergieffektivitet:	3.83
Uppvärmning energieffektivitet:	3.86
Utomhusenhets mått (BxDxH):	800 x 285 x 550 mm
Utomhusenhets vikt:	40000 g
Antal utomhusenheter:	1
Slanglängd (max):	30 m
Energiförbrukning (kylning) (max):	6000 W
Energiförbrukning (uppvärmning) (max):	7000 W
Energiförbrukning (kylning) (min):	1100 W
Energiförbrukning (uppvärmning) (min):	1000 W