Fujitsu MAW 3300 NP Bruksanvisning
Läs gratis den bruksanvisning för Fujitsu MAW 3300 NP (2 sidor) i kategorin Hårddisk. Guiden har ansetts hjälpsam av 10 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 5.5 recensioner. Har du en fråga om Fujitsu MAW 3300 NP eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
                        Sida 1/2
                    
                    
                    
MAW3300NC/NP, MAW3147NC/NP,  
MAW3073NC/NP 
DISK DRIVES INSTALLATION GUIDE   
CARE OF YOUR FUJITSU DRIVE 
Careful handling  and installation of your disk drive is paramount  to  the  longevity  of  the  unit.   Serious  damage can  occur to the internal 
mechanisms if forces outside the environmental specifications are exerted to the casing.  In transportation, always use the original packing 
in which the drive was supplied and avoid sharp changes in temperature to minimise the risk of condensation. 
Handling 
1. Never drop.  Handle with care. 
2.  Never move the disk  drive while the disks  are spinning.   This  is  when  the  drive is  powered  on  and also  immediately  after power  off.  
Refer to the Start/Stop specification for your drive. 
3. Always turn off the power before connecting or disconnecting the interface cable.  The same applies to changing any of the switches or 
terminal settings except Write protect switch on NP model drives. 
4. Never place the drive in the vicinity of strong magnetic fields such as monitors, televisions, or loudspeakers. 
5. Never use any cleaning agents or liquids on the drive. 
6. Always use an antistatic mat and wrist strap when handling the drive.  Hold the drive by the Base casting and never touch the components 
on printed circuit board. 
7. Never remove any labels from the drive and do not deface them in any way; these labels are part of the disk drive design. 
8. Never open the disk enclosure for any reason.  Doing so voids any warranty. 
9. Always pay close attention to the mounting specifications such as sway space and cooling.  If the temperature difference between storage 
location and installation locations is more than 10°C, leave the drive in the new location for at least two hours for Temperature acclimation.  
This minimises any risk of condensation forming on the drive. 
The Drive needs NO preventative or periodic maintenance during its life time if properly used in the correct environment. 
INSTALLATION 
1.  ORIENTATION–The  drive  can  be  installed  in  each  six  surface  down  orientations.    Inclination  from  vertical  or  horizontal  should  not 
exceed 5°. 
2. MOUNTING SCREW INSTALLATION–When the mounting screw holes on the side of the drive are used, be sure to use the two pairs 
of outer holes.  Do not use the center hole in conjunction with only one of the outer holes.  The screws must not penetrate the drive by more 
than 5.0 millimeters.  Impact caused by the electric driver must be within the device specifications. 
3. COOLING–Allow space above and below the drive to provide an adequate air flow.  Fan cooling is recommended.  The disk enclosure 
temperature measured at center of base cover (label side) should never exceed 60°C.  See Table 1. 
Table 1.  Reference value of airflow 
Environmental temperature  Required velocity of airflow 
35°C  > 0.2m/s 
40°C  > 0.5 m/s 
45°C  > 0.9 m/s 
50°C > 1.5 m/s 
4. TERMINATION–A terminator should be installed externally at both ends of the SCSI bus. 
5. TERMINATOR POWER–Terminator power must be supplied to terminator for correct operation.  This can be supplied from either the 
drive, except for NC model or the SCSI bus.  If only NC model drives are connected to the SCCI bus, terminator power should be supplied 
externally. 
6. ATTACHING THE CABLES–To avoid possible damage to the drive, make sure the direction of the connector matches. 
CAUTION:  Warranty may be avoided if damage to the connector is caused by wrong insertion. 
FUJITSU LIMITED 
Storage Products Group 
4-1-1 Kamikodanaka, Nakahara-ku, Kawasaki 211-8588, Kanagawa-ken, Japan 
Copyright © 2005 FUJITSU LIMITED  Corporate  http://www.jp.fujitsu.com/ 
USA  http://www.fcpa.com/ 
EUROPE  http://www.fujitsu-europe.com/ 
C141-E227-01EN
Produktspecifikationer
| Varumärke: | Fujitsu | 
| Kategori: | Hårddisk | 
| Modell: | MAW 3300 NP | 
Behöver du hjälp?
Om du behöver hjälp med Fujitsu MAW 3300 NP ställ en fråga nedan och andra användare kommer att svara dig
Hårddisk Fujitsu Manualer
                        
                         1 September 2024
                        
                    
                                                            
                        
                         21 Augusti 2024
                        
                    
                                                            
                        
                         8 Augusti 2024
                        
                    
                                                            
                        
                         7 Augusti 2024
                        
                    
                                                            
                        
                         4 Augusti 2024
                        
                    
                                                            
                        
                         24 Juli 2024
                        
                    
                                                            Hårddisk Manualer
- PNY
- BLACKJET
- AudioControl
- Samsung
- Seagate
- G-Technology
- SilverStone
- Transcend
- Gembird
- Oyen Digital
- Sandberg
- Verbatim
- Pioneer
- Xcellon
- StarTech.com
Nyaste Hårddisk Manualer
                        
                         9 April 2025
                        
                    
                                                            
                        
                         28 Mars 2025
                        
                    
                                                            
                        
                         27 Mars 2025
                        
                    
                                                            
                        
                         25 Februari 2025
                        
                    
                                                            
                        
                         9 Februari 2025
                        
                    
                                                            
                        
                         31 Januari 2025
                        
                    
                                                            
                        
                         31 Januari 2025
                        
                    
                                                            
                        
                         30 Januari 2025
                        
                    
                                                            
                        
                         29 Januari 2025
                        
                    
                                                            
                        
                         15 Januari 2025