Garmin GHS 10 Bruksanvisning
Läs gratis den bruksanvisning för Garmin GHS 10 (12 sidor) i kategorin Radio. Guiden har ansetts hjälpsam av 11 personer och har ett genomsnittsbetyg på 3.6 stjärnor baserat på 6 recensioner. Har du en fråga om Garmin GHS 10 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/12
GHS10/10i handset
installation instructions
instructions d’installation
istruzioni di installazione
installationsanweisungen
instrucciones de instalación
GHS 10/10i Installation Instructions EN-1
These installation instructions are for
the GHS 10 and GHS 10i handsets.
The GHS 10 is for use with the Garmin
VHF 200 radio and the GHS 10i is for
use with the Garmin VHF 200i radio.
For additional information, refer to the
VHF 100/200 Series Radio Installation
Instructions that came with your radio.
For operational instructions, refer to
your VHF 100/200 Series Radio Owner’s
Manual.
The handset comes with a 32.8 ft. (10 m)
extension cable, a bulkhead mounting
plate, a weather cap, and the necessary
cable hardware.
Install the GHS 10 or GHS 10i
handset at least 20 in. (500
mm) from any compass.
To connect the GHS 10 or GHS 10i
handset:
1. Using the mounting plate as a
template, use a center punch to mark
the three screw locations on the
surface.
2. Use a pencil to trace the cable hole in
the center of the mounting plate. Set
the mounting plate aside.
3. Use a in. (22 mm) hole saw to cut ⅞
the cable-mounting hole.
4. Use a in. (3 mm) drill to drill the ⅛
three mounting-plate holes.
GHS 10/10i Installation Instructions
Mounting
plate
Weather cap Cable nut
Cable-mounting
hole
External speaker
wires
EN-2 GHS 10/10i Installation Instructions
5. Use the three 3.5 × 20 mm, panhead
mounting screws to attach the
mounting plate.
6. Connect the extension cable to the
microphone relocation port on the
rear of the VHF 200 or VHF 200i
radio.
7. Mount the other end of the extension
cable through the mounting plate and
weather cap, securing with the cable
nut.
8. Connect the handset to the extension
cable.
Connecting an external
speaker next to the
GHS 10/10i handset
The green and yellow wires on the
extension cable can be used to connect
an external passive speaker (4 ohm, 5 W
minimum).
1. Connect the yellow wire to the
positive (+) connection on the
external speaker.
2. Connect the green wire to the
negative (-) connection on the
external speaker.
Specications
Dimensions: 6.34 × 2.82 × 1.69 in.
(16.1 × 7.16 × 4.28 cm)
Weight: 12.98 oz. (368 g)
Temperature Range: from 14ºF to
122ºF (from -10ºC to 50ºC)
Compass-safe Distance: 20 in.
(500 mm)
Waterproof: IEC 60529 IPX7
(Immersion in 1 meter of water for
30 minutes)
Please visit www.garmin.com
for additional documentation and
information.
Produktspecifikationer
| Varumärke: | Garmin |
| Kategori: | Radio |
| Modell: | GHS 10 |
Behöver du hjälp?
Om du behöver hjälp med Garmin GHS 10 ställ en fråga nedan och andra användare kommer att svara dig
Radio Garmin Manualer
3 September 2024
1 September 2024
31 Augusti 2024
21 Augusti 2024
5 Augusti 2024
31 Juli 2024
Radio Manualer
Nyaste Radio Manualer
16 Juni 2025
14 Juni 2025
14 Juni 2025
14 Juni 2025
14 Juni 2025
14 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
12 Juni 2025