GE UX12B36PSS Bruksanvisning

Läs gratis den bruksanvisning för GE UX12B36PSS (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 22 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 8 recensioner. Har du en fråga om GE UX12B36PSS eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

UX12B36PSS

12” High Backsplash

WARNING To prevent ignition of combustible

materials, the entire back wall above the range

must be protected by a backsplash constructed of

non-combustible material.

This stainless steel backsplash accessory must be

installed in combination with a custom, non-combustible

backsplash built beyond the 12” height of the backsplash.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

■ IMPORTANT—Save these instructions

for local inspector’s use.

■ IMPORTANT—Observe all governing

codes and ordinances.

■ Note to Installer —Be sure to leave these

instructions with the consumer.

■ Note to Consumer —Keep these instructions with

your Owner’s Manual for future reference.

■ This kit provides for the installation of a 12” high

backsplash for 30”, 36” or 48” Professional Ranges

and Rangetops.

Installation

Instructions

31-10690-1 01-18 GEA

TOOLS AND MATERIALS REQUIRED

■Glovestoprotectagainstsharpedges

■T-15and#2Phillips

screwdrivers

■Drillwith3/32”and

9/64”bits

■Safetyglasses

■Level

■Pencil

This Kit Includes

■Wallsupportpanel

■Coverpanel

■Hardwarepackagewith

 –5StainlessSteelTorx15

#8self-tappingscrews

 –5Phillips#2panheadwood

#10screws

INSTALL 12” BACKSPLASH

WARNING This backsplash must be securely

fastened to the wall. Failure to do so could result in

damage or personal injury.

■Installandleveltherangeorrangetopandthe

range hood according to the installation instructions.

■Removethebacksplashpackagingandprotective

film.

■Usealeveltopencilahorizontallineonthewall,1/8”

abovetherangeorrangetop.The1/8”gapallowsthe

cover panel to overlap the wall support panel.

■Locatewallstudsoneachside.Wherestudsarenot

available, plan to use wall anchors (not provided).

■Alignthewallsupportpanelonthemarked

horizontallineandcenteredlefttoright.

■Thewallsupportpanelmustbesecuredtothewall

atall4corners.Usewoodscrews(provided)orwall

anchors (not provided) to secure the support panel

to the wall.

■Placethecoverpaneloverthewallsupportpanel

andsecurewithTorxscrews(provided).Install2

screws on each side.

WallSupportPanel

CoverPanel

Hardware

Package

Install4WoodScrews

InstallT-15

Screws

Wall

Support

Panel

WallSupport

Panel

CoverPanel

Center

Arrow

1/8”

Produktspecifikationer