Gembird 3DP-PLA-FL-01 Bruksanvisning

Läs gratis den bruksanvisning för Gembird 3DP-PLA-FL-01 (1 sidor) i kategorin ej kategoriserat. Guiden har ansetts hjälpsam av 33 personer och har ett genomsnittsbetyg på 4.0 stjärnor baserat på 5 recensioner. Har du en fråga om Gembird 3DP-PLA-FL-01 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Printing TempTensile strength (X-Y)8.8-9.3 Mpa

Bed TempBending strength30000 lb/in2

Density (g/cm³)Elongation at break (X-Y)

500-600

（

%

）

Retraction distanceMelting Point137 ºC

Retraction speedMelt Volume Rate6.38 (170 ºC, 2.16 kg)

Glass transition temp.Printing speed40-80/Smm

FLEXIBLE PLA+ (FPLA+) PRINT RECOENDATIONSMM

FPLA+ Technical details

190-220Cº

0-40

º

C

Gembi ope B.V.rdEur

Wievrouwen , CD Alre, The Neerlas.�561358methnd

1.21-1.30 g/cm³

1 cm

20 /smm

54 ºC

The FPLA is strinng and zing.gioo

We reend f you to use a 0.6 nole and print at acommormmzz

nozzle temperare of 0tu19

0

C with a bed temperature of 40.℃

Moisture absorption resistance of FPLA

+

Filament

▪ Since Flexible PLA

+

(FPLA

+

) comes from the PLA family and since it is soft, it will easily absorb moisture.

▪ We strongly recommend that the filament be kept in the vacuum bag immediately after its use and not be kept

outside.

▪ If the humidity in the filament persists, it is recommended to dry the filament at 50 ºC for 2 to 3 hours and then

use it for best results.

Use following parameters to prevent Stringing & Adhesion

Issue

Solution

The Filament is adhering a lot. This st adheres too well touff

textured PEI treated beds. The boom layer is dicu to�ffilt

remove and stretches leaving a

white led texture on the print.coor

Reends using PVB obe in the plate lower theprinttemperature tocommglor

180190so to deg C.Ucan al usea sma layer of baby powder on the bed as ll

we.ll

Nle 0.5/0.6mmozzmm

Produktspecifikationer