Getac VR-X20 Bruksanvisning
Getac
Inte kategoriserad
VR-X20
Läs gratis den bruksanvisning för Getac VR-X20 (8 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 29 personer och har ett genomsnittsbetyg på 3.9 stjärnor baserat på 15 recensioner. Har du en fråga om Getac VR-X20 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/8
1
1
. Unpacking
VR-X20 DVR System
Fuse tap (ignition) -5A 15A inline fuse
Terminal connector for DC IN* Mounting kit
Terminal connector for GPIO × 2
* Use wire ferrules (not supplied) with the terminal connector
for DC IN.
Wire ferrule example:
VR-X20
In-Vehicle System
QUICK START GUIDE
GETAC VIDEO SOLUTION
M3L5 (5mm) screws
M3L6 (6mm) screws
2
2
. Identifying Components
Front Panel
No. Name Description
Power button Press to power on VR-X20.
Power LED Red light (for 10 seconds): DC power-in
Green light: Software ready
Rear Panel
No. Name Description
PoE ports To connect up to six IP cameras. Each port only supports 6W.
RS-232 port To connect an RS-232 serial device.
USB 2.0 port To connect USB devices.
DC-in
connector
To connect to vehicle ignition and battery. (See “DC-in
Connector Pin Assignments” on page 3 for wiring
information.)
USB 3.0 ports To connect USB devices.
GPIO port To provide additional control lines. There are 20 GPIO pins
in two groups of 10 pins. (See “GPIO Connector Pin
Assignments” on page 3 for wiring information.)
3
No. Name Description
RJ45
connectors
LAN1 and LAN2 to provide Ethernet connection.
LAN 1 supports 1000BASE-T, 100BASE-TX, and 10BASE-T.
LAN 2 supports 2500BASE-T, 1000BASE-T, 100BASE-TX, and
10BASE-TE.
RJ45-type
audio in
connectors
To connect up to two wireless microphones.
Wireless microphone model: WM-T2400M
GPS antenna
connector
To connect an external GPS antenna.
Combo audio
connector
To connect a headset microphone.
Wi-Fi/BT
antenna
connectors
Auxiliary and Main to connect external Wi-Fi/BT antennas.
USB-C port To connect to a device supporting USB-C 3.2 or DisplayPort.
Cellular
antenna
connectors
(optional)
Auxiliary and Main to connect external LTE antennas.
Installation must be performed by licensed professionals.
Control unit
connector
To connect to the CU-D50 control unit. (CU-D50 is an
optional item.)
Side Panel
No. Name Description
Dual nano-SIM card
tray (optional)
Inside is the nano-SIM card tray if your model has the
cellular module. (See “Nano-SIM Card Installation” on
the next page for installation instructions.)
Produktspecifikationer
| Varumärke: | Getac |
| Kategori: | Inte kategoriserad |
| Modell: | VR-X20 |
Behöver du hjälp?
Om du behöver hjälp med Getac VR-X20 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Getac Manualer
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
Inte kategoriserad Manualer
- ASA
- BDI
- Life Gear
- Belulu
- Gima
- Tube-Tech
- InvisibleShield
- Carlo Gavazzi
- Nintendo
- Da-Lite
- Frient
- Casio
- Harley Benton
- Sandia Aerospace
- Paingone
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025