Graco Extend2Fit Convertible Bruksanvisning

Graco Bilbarnstol Extend2Fit Convertible

Läs nedan 📖 manual på svenska för Graco Extend2Fit Convertible (96 sidor) i kategorin Bilbarnstol. Denna guide var användbar för 6 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/96

Read This Instruction Manual

CONVERTIBLE CAR SEAT

Extend2Fit®

CLICK!

MUST

Ball must be completely in the blue

zone

ball must completely cover

See section 5 to secure your child.

3 Rear

Facing

Is Everything Correct?

Car Seat Does Not Move More than

1” (2.5 cm) at the Belt Path

Level Indicator’s Ball

in the Blue Zone and

Vehicle on Level Ground

Harness Straps at or Just Below the

Child’s Shoulders.

Review section 5

Chest Clip Even With Armpits

Review section 5

Cannot Pinch Harness Straps at the

Shoulder

Review section 5

3 Rear

Facing

1. Store Tether and Lower Anchor

Strap

Attach tether hook and lower anchor

connectors to the plastic bars as shown.

Rear Facing

Forward Facing

3-C Install Rear-Facing with

Vehicle Seat Belt

2. Recline the Car Seat

Pull out on handle on front of child

restraint and adjust to one of the 4

rear-facing positions.

3. Place Car Seat Rear-Facing in

Back Seat of the Vehicle

4. Make Sure Base is a minimum

of 80% on Vehicle Seat.

5. To Keep Your Child Rear-Facing

Longer

Note:

3 Rear

Facing

10. Test For Tightness

Grab the sides of the seat where the

vehicle seat belt is and slide the car seat

side-to-side and front-to-back.

If the seat moves less than 1” (2.5 cm), it

is tight enough.

11. Check the Level Indicator

Vehicle MUST Ball be on level ground.

must be completely in the blue zone.

Readjust if needed.

For infants 3 months and under, the ball

must completely cover the light blue

circle.

If needed, rolled towels may be placed

under the car seat at the vehicle seat

crease, until the ball is completely in the

blue zone.

See section 5 to secure your child.

Recheck level indicator with child in seat.

3 Rear

Facing

Is Everything Correct?

Car Seat Does Not Move More than

1” (2.5 cm) at the Belt Path

Level Indicator’s Ball

in the Blue Zone and

Vehicle on Level Ground

Harness Straps at or Just Below the

Child’s Shoulders.

Chest Clip Even With Armpits

Cannot Pinch Harness Straps at the

Shoulder

CLICK!

Review section 5

4 Forward

Facing

4-C Install Forward-Facing with

Vehicle Seat Belt

1. Store Lower Anchor Strap

Attach lower anchor connectors to the

plastic bars as shown.

2. Adjust the Car Seat

For Children 22-40 lb (10-18 kg)

MUST use recline position 4.

For Children Over 40 lb (18.1 kg)

MUST use recline position 5 or 6.

Orientado hacia atrás

Orientado hacia adelante

3. Unhook Tether Strap From

Storage

Unhook tether and lay it in the seat.

4. Place Car Seat Forward-Facing

in Back Seat of the Vehicle

Place forward-facing in vehicle seat.

The base should sit as flat as possible

on the vehicle seat.

5. Make Sure Base is a minimum

of 80% on Vehicle Seat.

4 Forward

Facing

Review your vehicle’s owner manual for vehicle seat belt use

6. Route the Vehicle Seat Belt

Thread vehicle seat belt through the

forward-facing belt path (marked with

a orange label) and out the other side.

Buckle it. The seat belt should lie as

flat as possible and not be twisted.

7. Lock the Vehicle Seat Belt

In most vehicles today, slowly pull

the shoulder belt all the way out and

then let it go back in. You will hear a

clicking sound. Slowly pull out on the

belt and it should be locked. If not,

review your car’s owner manual and

section 8-D.

9. Attach The Tether

8. Tighten the Vehicle Seat Belt

10. Tighten the Tether Strap

4 Forward

Facing

Grab the sides of the seat where the

vehicle seat belt is and slide the car

seat side-to-side and front-to-back.

If the seat moves less than 1” (2.5

cm), it is tight enough.

See section 5-A to secure your child.

4 Forward

Facing

Is Everything Correct?

Car Seat Does Not Move More than

1” (2.5 cm) at the Belt Path

Harness Straps at or Just Above the

Child’s Shoulders.

Chest Clip Even With Armpits

Cannot Pinch Harness Straps at the

Shoulder

Push down on the harness release

lever while pulling out on the

harness straps at the chest clip.

5-A

Securing Child 5-point Harness

WARNING! In cold weather, do not put snowsuits or bulky garments

on your child when placing them in the car seat. Bulky clothing can

prevent the harness straps from being tightened properly. To keep child

warm, buckle your child in the car seat and place a blanket around the

child or place the child’s coat on backwards after buckling in.

5 Securing

Child

Make sure their back is flat against the

car seat back.

Avoid bulky or heavy clothing. Doing

so will prevent the harness straps

from being tightened properly. Place

a blanket over the child after you have

secured the child.

You will hear a “click” when buckle

tongues are securely attached. Pull up

on each buckle tongue to make sure it

is securely attached.

4. Be Sure the Harness Straps

Are at the Proper Height

Harness straps

should be the

child’s shoulders. Top of head

be 1” (2.5 cm) below the headrest

adjustment lever.

Harness straps

should be the

child’s shoulders. Top of child’s ears

top of headrest.

5 Securing

Child

When you are not able to pinch

any of the harness webbing at your

child’s shoulder, the harness is tight

enough.

A snug harness should not allow any

slack. It lies in a relatively straight

line without sagging. It does not

press on the child’s flesh or push

the child’s body into an unnatural

position.

6 Accessories

6-A Accessories

(on select models)

Harness Covers

Head Support

Body Support

7 Moving

Lower Anchors

7 Moving

Lower Anchors

7 Moving

Lower Anchors

8 Additional

Information

8 Additional

Information

8 Additional

Information

8 Additional

Information

8 Additional

Information

8 Additional

Information

8 Additional

Information

8 Additional

Information

8 Additional

Information

8 Additional

Information

9 Care &

Cleaning

9 Care &

Cleaning

9 Care &

Cleaning

9 Care &

Cleaning

9 Care &

Cleaning

9 Care &

Cleaning

9 Care &

Cleaning

9 Care &

Cleaning

9 Care &

Cleaning

9 Care &

Cleaning

Head Support Cover

Undo elastic loop underneath head support

cover. Pull tab out from behind head support.

Undo the elastic loops on the sides of the

headrest.

Peel cover off head support.

Machine wash pad in cold water on delicate

cycle and drip-dry. DO NOT USE BLEACH.

To put the head support cover back on, reverse

preceding steps.

9 Care &

Cleaning

9-B Cleaning Crotch Buckle

Recline the car seat and locate the metal

retainer. Rotate the metal retainer up through

the shell and pad. From the front, pull the

crotch buckle out.

To clean buckle, place in a cup of warm water

and gently agitate the buckle. Press the red

button several times while in the water.

DO NOT SUBMERGE THE BUCKLE

STRAP. DO NOT USE SOAPS, HOUSEHOLD

DETERGENTS or LUBRICANTS.

Shake out excess water and allow to air dry.

Repeat steps as needed until it fastens with a

click. Re-insert the buckle into the same slot

it was removed. Pull up on crotch buckle to

make sure it is secured.

WARNING! Inspect and clean

buckle from time to time to

remove any objects or debris

that could prevent latching.

Produktspecifikationer

Varumärke:	Graco
Kategori:	Bilbarnstol
Modell:	Extend2Fit Convertible
Typ av operation:	Knoppen
Färg på produkten:	Grey, White
Vikt:	2830 g
Bredd:	230 mm
Djup:	310 mm
Höjd:	1110 mm
Snäll:	Stoomop/dweil
Kraftkälla:	AC
Tillgångar:	1500 W
Räckvidd:	7.5 m
På / Av knapp:	Ja
Färdig att använda indikatorlampa:	Ja
Mjukt grepp:	Ja
Snabb värme:	Ja
Antal tillbehör ingår:	19 stuk(s)
Rengöringsborste:	Ja
Innehåll:	0.5 l
Avtagbar vattentank:	Ja
Uppvärmningstid:	20 s
Rengöringsduk:	Ja
Ångtryck:	- bar
Ånga redo ljus:	Ja
Justerbar ånga:	Ja
Medföljande borsttyp:	2-in-1 cleaning brush, Rectangular cleaning brush, Round cleaning brush, Triangular cleaning brush
Matt glider:	Ja
Avtagbar bärbar ångtvätt:	Ja