Heatmiser DS1-EL Bruksanvisning
Heatmiser
Termostater
DS1-EL
Läs gratis den bruksanvisning för Heatmiser DS1-EL (4 sidor) i kategorin Termostater. Guiden har ansetts hjälpsam av 7 personer och har ett genomsnittsbetyg på 3.7 stjärnor baserat på 4 recensioner. Har du en fråga om Heatmiser DS1-EL eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
Wiring Diagram
The Heatmiser DS1-EL dial type thermostat is designed
specically for electric underoor heating.
This thermostat incorporates the following functions;
• Adjustable Switching Dierential
• Digital LCD
• 230v AC, 13A Switching
Introduction 1
4
Model: DS1-EL
RCD
MAINS SUPPL
Y
L N
MATTING OR WIRE
FlOOR PROBE
DS1-EL
Want More Information?
Call our support team on:
+44 (0)1254 669090
Or view technical specications
directly on our website:
www.heatmiser.com
IN ORDER TO AVOID ANY RISK OF ELECTRIC SHOCK, TURN OFF THE POWER TO THE
HEATING SYSTEM.
This dial thermostat is designed to be surface mounted.
1. Separate the front part of the thermostat by unscrewing securing screws on the
bottom face of the thermostat.
2. Mark 2 hole positions on the wall using the backplate as a positioning template. Drill at
the marked positions and insert a wall plug in to each hole.
3. Terminate the thermostat as per wiring diagram and screw the DS1-EL back plate to the
back box.
4. Reconnect the thermostat front plate and insert the securing screws.
Installation
PDF FAQ
2
3
In normal mode, the display shows the actual room temperature. To change the set point,
rotate the dial until the digital LCD displays the new set temperature.
Setting The Temperature
Display Icons
The Heatmiser DS1-EL has a lock facility. To lock the thermostat, press and hold down the
dial for 10 seconds. You will see a lock symbol appear. To unlock, repeat the steps above.
Heating ON Keypad Locked
The Heatmiser DS1-EL oers 1, 2 and 3°C switching dierential.
With a 1°C switching dierential the heating will switch on 1°C below the set
temperature and will turn o when the set temperature is reached.
A 2°C will turn the heating on 2°C below the set temperature.
3°C will switch the heating on 3°C below the set temperature.
To set the dierential, set the DIP switches according to the table below.
This setting is only required when the sensor option is set to Air and Floor mode.
The setting is used to protect the oor surface from overheating.
The oor temperature limit can be set to 20, 28 or 40°C.
To set the required oor limit temperature, set the DIP switches according to the table.
The thermostat has three modes of operation. Select the desired mode,
and set the DIP switches according to the table.
The DIP switches can be accessed from the back of thermostat.
Air Sensor: Uses the built in air sensor only.
Air Sensor & Floor Limiting Sensor: Uses the built in air sensor but also uses the
remote oor sensor to ensure the oor temperature doesn’t overheat.
Floor Sensor: Uses the remote oor sensor only.
Lock Facility
Switching DierentialFloor Temperature Limit
Sensor Option
1 2
1 °C Switching
2 °C Switching
3 °C Switching
20°C
28°C
40°C
Air Sensor
Air & Floor
Floor Sensor
1
2
3
1
2
3
1
2
3
Switch 1 & 2 OFF
Switch 1 ON and Switch 2 OFF
Switch 1 OFF and Switch 2 ON
Switch 5 & 6 OFF
Switch 5 ON and Switch 6 OFF
Switch 5 OFF and Switch 6 ON
Switch 3 & 4 OFF
Switch 3 ON and Switch 4 OFF
Switch 3 OFF and Switch 4 ON
22
2
33
3
11
1
Should the oor temperature be achieved (even if the desired room temperature has
not) the heating will turn o. The Heat Active Icon will ash in this case.
Produktspecifikationer
| Varumärke: | Heatmiser |
| Kategori: | Termostater |
| Modell: | DS1-EL |
Behöver du hjälp?
Om du behöver hjälp med Heatmiser DS1-EL ställ en fråga nedan och andra användare kommer att svara dig
Termostater Heatmiser Manualer
17 Oktober 2024
14 Oktober 2024
10 Oktober 2024
7 Augusti 2024
7 Augusti 2024
Termostater Manualer
- Junkers
- Honeywell
- Delta Dore
- Theben
- Seitron
- EBERLE
- Zehnder
- Danfoss
- TrickleStar
- Bticino
- AEG
- Watts
- Stiebel Eltron
- Siemens
- Nedis
Nyaste Termostater Manualer
3 April 2025
26 Januari 2025
18 Oktober 2024
18 Oktober 2024
18 Oktober 2024
18 Oktober 2024
18 Oktober 2024
16 Oktober 2024
16 Oktober 2024
16 Oktober 2024