Hilti TE 7-C Bruksanvisning
Hilti
Borrmaskin
TE 7-C
Läs gratis den bruksanvisning för Hilti TE 7-C (16 sidor) i kategorin Borrmaskin. Guiden har ansetts hjälpsam av 25 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 13 recensioner. Har du en fråga om Hilti TE 7-C eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/16
TE 7-C
English
English 1
1 Information about the documentation
1.1 About this documentation
• Read this documentation before initial operation or use. This is a prerequisite for safe, trouble-free
handling and use of the product.
• Observe the safety instructions and warnings in this documentation and on the product.
• Always keep the operating instructions with the product and make sure that the operating instructions
are with the product when it is given to other persons.
1.2 Explanation of signs used
1.2.1 Warnings
Warnings alert persons to hazards that occur when handling or using the product. The following signal words
are used in combination with a symbol:
DANGER! Draws attention to imminent danger that will lead to serious personal injury or fatality.
WARNING! Draws attention to a potential hazard that could lead to serious personal injury or
fatality.
CAUTION! Draws attention to a potentially dangerous situation that could lead to minor personal
injury or damage to the equipment or other property.
1.2.2 Symbols in the documentation
The following symbols are used in this document:
Read the operating instructions before use
Instructions for use and other useful information
1.2.3 Symbols in the illustrations
The following symbols are used in illustrations:
These numbers refer to the corresponding illustrations found at the beginning of these operating
instructions.
The numbering reflects the sequence of operations shown in the illustrations and may deviate
from the steps described in the text.
Item reference numbers are used in the and refer to the numbers used inoverview illustrations
the product overview section.
These characters are intended to specifically draw your attention to certain points when handling
the product.
1.3 Product-dependent symbols
1.3.1 Symbols
The following symbols are used:
Drilling without hammer action
Drilling with hammering action (hammer drilling)
Chiseling
Chisel positioning
Rated speed under no load
Revolutions per minute
Protection class II (double-insulated)
Produktspecifikationer
| Varumärke: | Hilti |
| Kategori: | Borrmaskin |
| Modell: | TE 7-C |
Behöver du hjälp?
Om du behöver hjälp med Hilti TE 7-C ställ en fråga nedan och andra användare kommer att svara dig
Borrmaskin Hilti Manualer
6 Oktober 2024
23 September 2024
31 Augusti 2024
29 Augusti 2024
28 Augusti 2024
24 Augusti 2024
24 Augusti 2024
24 Augusti 2024
21 Augusti 2024
20 Augusti 2024
Borrmaskin Manualer
- Ferrex
- Kraftronic
- Blucave
- Dremel
- Gude
- Kress
- Fieldmann
- Delta
- Zipper
- Topcraft
- Powerblade
- Herkules
- Einhell Bavaria
- Tanaka
- Meister Craft
Nyaste Borrmaskin Manualer
13 Juni 2025
13 Juni 2025
13 Juni 2025
12 Juni 2025
7 Juni 2025
7 Juni 2025
3 Juni 2025
2 April 2025
2 April 2025
2 April 2025