Hinkley Lighting Harbor 2573AR Bruksanvisning

Hinkley Lighting Lättnad Harbor 2573AR

Läs gratis den bruksanvisning för Hinkley Lighting Harbor 2573AR (2 sidor) i kategorin Lättnad. Guiden har ansetts hjälpsam av 8 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 4.5 recensioner. Har du en fråga om Hinkley Lighting Harbor 2573AR eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
assembly instructions
Family: Harbor Item No. 2573
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Prepare gem strap for mounting by threading two screws provided into (A) (B)
back of gull wing bracket of gem strap - see .(A) Drawing 1
Be sure the holes into which the screws are threaded match the spacing of holes (D)
2. Mount gem strap to junction box , using the two 1” screws not provided.(A) (J) (C)
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet and follow all instructions to make all necessary wiring connections. (I.S. 18)
Then refer back to this sheet to continue installation of this fixture.
1. Hang the fixture by slipping the holes in the ceiling pan over the screws (D) (1) (B)
in the mounting strap - see .(A) Drawing 2
2. Thread on ball knobs to secure fixture to the ceiling.(F)
1. To install glass, thread stem approximately 1/4” into coupler , located in the (2) (6)
center of ceiling pan - see .(1) Drawing 3
2. Slip glass onto stem and up against ceiling pan and hold in position.(3) (2) (1)
3. Slip rubber washer onto center stem and hold in position.(4) (2)
4. Thread bottom finial onto end of stem and hand tighten.(5) (2)
Note: Using a tool to tighten these items could cause glass damage.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
hanging the fixture from the ceiling, and then installing the glass.
start here
2573
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Mounting
Drawing 3 - Glass Installation
B
1
3
4
5
2
6
D
F
J
C
A
1
Drawing 1 - Strap Detail
B
(side view)
gull wing
bracket
B
4.4.08
REVISION 1
T24 JA8-2016
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com


Produktspecifikationer

Varumärke: Hinkley Lighting
Kategori: Lättnad
Modell: Harbor 2573AR

Behöver du hjälp?

Om du behöver hjälp med Hinkley Lighting Harbor 2573AR ställ en fråga nedan och andra användare kommer att svara dig