Hoover HL V8DGB-80 Bruksanvisning
Hoover
Torktumlare
HL V8DGB-80
Läs gratis den bruksanvisning för Hoover HL V8DGB-80 (6 sidor) i kategorin Torktumlare. Guiden har ansetts hjälpsam av 7 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 4 recensioner. Har du en fråga om Hoover HL V8DGB-80 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/6


OPERATION
Do not open the door during the automatic
programs in order to obtain a proper drying.
1. Open the door and load the drum with
laundry. Ensure that garments do not
hinder closure of the door.
2. Gently close the door pushing it slowly
until you hear the door 'click' shut.
3. Turn the Programme Selector dial to
select the required drying programme (see
Programme Guide).
4. Press the button. The dryer will start
automatically and the indicator above the
button will be continuously lit.
5. If the door is opened during the
programme to check the laundry, it is
necessary to press to recommence
drying after the door has been closed.
6. When the cycle is nearing completion
the machine will enter the cool down
phase, the clothes will be tumbled in cool
air allowing the load to cool down.
7. Following the completion of the cycle the
drum will rotate intermittently to minimize
creasing. This will continue until the
machine is switched OFF or the door is
opened.
10
5.
DOOR and FILTER
Pull on handle to open the door.
To restart the dryer, close the door and press
Start / Pause button.
WARNING! When the tumble dryer is in
use the drum and door may be VERY HOT.
Filter
IMPORTANT: To maintain the efficiency of
the dryer check that the fluff filter is clean
before each drying cycle.
1.P u l l t h e f i l t e r
upwards.
2.Open filter as shown.
3.Gently remove lint
using a soft brush or
your fingertips.
4.S n a p t h e f i lt e r
together and push
back into place.
1
2
Filter Care Indicator
Lights when the filter needs cleaning.
If the laundry is not drying check that the filter
is not clogged.
IF YOU CLEAN FILTER UNDER
WATER, REMEMBER TO DRY IT.

7.
CONTROLS AND
INDICATORS
A
B
C
D
E
A-Programme Selector - Rotating the knob
in both directions it's possible to select the
desired drying program. To switch or cancel
off the dryer rotate the knob on OFF.
B- Display Digit - The display shows the
remaining time for drying, the postponed
time in case of delayed start selection and
other notifications setting.
C-Buttons -
1.Start/Pause Button
To start the selected program and/or
suspend it.
2.Delay Start Button
It allows to delay the start of the program
from 1 to 24 hours in 1-hour intervals. The
delay selected is shown on the display.
After pressing the START button the time
showed decrease hour after hour.
Opening of the porthole with delayed start
set, after re-closing the porthole, press start
againg to resume the counting.
3.Time cycle selection
It's possible transform a cycle from automatic
to programmed, up to 3 minutes after the
start of the cycle.
The progressive pressure increases the
time in 10-minute intervals.
After this selection to reset the automatic
dying functioning is necessary to switch
off the dryer In case of incompatibility, all
LEDs flash quickly for 3 times.
4.Drying Selection Button
It allows to set the desired dryness level
editable option up to 5 minutes after the
starting of the cycle:
- It leaves the Ready to Iron :
garments slightly wet to facilitate ironing.
- To get garment ready Dry Hanger :
to be hang.
-Dry wardrobe : For laundry that can
be directly stored
- To get completely dry Extra-dry :
garments, ideal for full load.
This appliances is equipped with Drying
Manager Function. On automatic cycles,
each level of intermediate drying, prior to
the reaching the selected one, is
indicated by flashing the light indicator
corresponding to the degree of drying
reached
5.Rapids Button
It's possible switch an automatic
program to RAPID program, up to 3
minutes after the start of the cycle. The
progressive pressure increases the time
(30-45-59 minutes).
After this selection to reset the automatic
dying functioning is necessary to switch
off the dryer In case of incompatibility, all
LEDs flash quickly for 3 times.
6.Anti crease
This option allows to activate an anti-
creases movement of the drum pre cycle
in case of activation of the delay and at
the end of drying cycle. It is activated
every 10 minutes, up to 6 hours after the
end of the drying cycle. To stop the
movements set the knob to OFF.
Useful when it's not possible to remove
immediately.
7. Keylock
This function allows to block unwanted
changes of the set options on the bezel ,
during drying phase.
Activation/ Inactivation: Push 4 and 5
buttons simultaneously for two seconds .
The sign "LOC" appears on the display.
Unlocking the option, on the display
appears the sign "Unl", only once.
11
123456
7
EN
Produktspecifikationer
Varumärke: | Hoover |
Kategori: | Torktumlare |
Modell: | HL V8DGB-80 |
Färg på produkten: | Black, White |
Vikt: | 538 g |
Höjd: | 114 mm |
Snäll: | IP-beveiligingscamera |
Ljudformat som stöds: | PCM |
Stemcodecs: | G.711 |
Vormfaktor: | Dome |
Placeringsstöd: | Binnen |
Anslutningsteknik: | Bedraad |
Monteringsmetod: | Plafond |
Videolägen som stöds: | 1080p |
Maximal upplösning: | 2048 x 1536 Pixels |
Totalt antal megapixlar: | 3 MP |
Videokomprimeringsformat: | H.264 |
Diameter: | 146 mm |
Typ av strömkälla: | Power over Ethernet (PoE) |
Minimal belysning: | 0.1 Lux |
Antal kameror: | 1 |
Integrerad minneskortläsare: | Ja |
Kompatibla minneskort: | MicroSDHC, MicroSDXC |
Inbyggd hårddisk: | Nee |
Nattseende: | Ja |
LED-typ: | IR |
Infraröd våglängd: | 1100 nm |
HTTPS-kryptering: | Ja |
Ljudsystem: | 2-weg |
Antal Ethernet LAN (RJ-45)-portar: | 1 |
Fokus: | Handmatig |
Brännvidd: | 2.8 - 12 mm |
Certifiering: | CE, FCC |
Full HD: | Ja |
Optisk sensorstorlek: | 1/3 " |
Bildstabilisator: | Ja |
Bildsensortyp: | CMOS |
Kamerans slutartid: | 1/10000 s |
Gränssnitt: | RJ-45 |
Typ kamerasluter: | Elektronisch |
Password bescherming: | Gebruiker |
Grafikupplösningar som stöds: | 320 x 240,640 x 480 (VGA),800 x 600 (SVGA),1280 x 720 (HD 720),1920 x 1080 (HD 1080),2048 x 1536 (QXGA) |
webbläsare: | Ja |
Brusreducering: | Ja |
Säkerhetsfunktioner: | Vandaalbestendig |
Max 30 bilder per sekund: | 30 fps |
Firmware-uppgradering möjlig: | Ja |
Nätverksprotokoll som stöds: | IPv4/v6, TCP, UDP, DHCP, PPPoE, HTTP, HTTPS, DNS, DDNS, NTP, RTP, RTSP, RTCP, SMTP, FTP, IGMP, ICMP, ARP, Bonjour, UPnP, QoS, SNMP |
Webbaserad hantering: | Ja |
Fjärrstyrd: | Ja |
IP-adressfilter: | Ja |
Progressiv skanning: | Ja |
Snabbinstallationsguide: | Ja |
Signal-brusförhållande: | 52 dB |
Power over Ethernet (PoE): | Ja |
Jag kodar: | IK09 |
Samplingshastighet: | 8 kHz |
Rotationsvinkel: | 350 ° |
Antal TV-linjer: | 1250 |
Panoreringsintervall: | 0 - 350 ° |
Dag/nattläge: | Ja |
Maximalt antal bländare: | 1.4 |
Strömningsmetod: | Multicast |
Rörelsesensor: | Ja |
Night vision scope: | 30 m |
Infrarött (IR) termineringsfilter: | Ja |
Bithastighetskontroll: | Constant Bit Rate (CBR), Variable Bit Rate (VBR) |
Justering av bildkvalitet: | Brightness, Contrast |
Strömförbrukning (strömförsörjning via Ethernet (PoE)): | 6.49 W |
Wide Dynamic Range (WDR): | Ja |
Bitrate: | 28Kbps - 6Mbps |
Wifi: | Nee |
Drifttemperatur (TT): | -10 - 50 °C |
Tiltvinkelområde: | 17 - 163 ° |
Justering av slutarhastighet: | Automatisch/handmatig |
Mask privat zon: | Ja |
Linsens betraktningsvinkel, horisontell: | 70.5 ° |
Rotera & spegla: | Ja |
Gränssnitt för objektivfäste: | Boardaansluiting |
Linsens betraktningsvinkel, vertikal: | 55.4 ° |
Automatisk förstärkningskontroll: | Ja |
Iris: | Ja |
Audio detectie: | Ja |
Behöver du hjälp?
Om du behöver hjälp med Hoover HL V8DGB-80 ställ en fråga nedan och andra användare kommer att svara dig
Torktumlare Hoover Manualer
28 Juli 2025
28 Juli 2025
27 Juli 2025
27 Juli 2025
27 Juli 2025
27 Juli 2025
19 Juni 2025
18 Juni 2025
18 Juni 2025
18 Juni 2025
Torktumlare Manualer
Nyaste Torktumlare Manualer
31 Juli 2025
30 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025