Hotpoint NT M11 92XB UK Bruksanvisning
Hotpoint
Torktumlare
NT M11 92XB UK
Läs gratis den bruksanvisning för Hotpoint NT M11 92XB UK (4 sidor) i kategorin Torktumlare. Guiden har ansetts hjälpsam av 11 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 6 recensioner. Har du en fråga om Hotpoint NT M11 92XB UK eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
THANK YOU FOR BUYING A HOTPOINT PRODUCT.
In order to receive a more complete assistance, please
register your product on www.hotpoint.eu/register
EN
Quick guide
Before using the appliance carefully read the Safety
Instruction.
OPENING THE DOOR DURING THE CYCLE
Laundry can be checked while the drying cycle runs and any
garments already dry can be removed, while drying continues for
the remaining items. After closing the door, press the "Start/Pause"
button to resume machine operation.
Keep the door closed until the cycle end to save time and energy.
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying cycle.
- remember to clean your lters after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments; always refer to instructions on
clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the door lter. Do not load items that
are dripping wet. Do not tumble dry large, very bulky items.
3. Close the door.
4. Press the "On/O" button.
5. Select the most suitable programme
for the type of fabric in that
load.
6. Select the options, if necessary.
7. Press the "
Start/Pause"
button to begin drying.
8. At the end of the drying cycle, a buzzer will beep. An indicator on
the control panel signals the end of the cycle. Pull the load out
immediately to prevent the formation of creases on laundry.
9. Turn the machine o by pressing the "On/O" button, open the
door and pull the clothing out. If the machine is not switched o
manually, after about a quarter of an hour from the end of the
cycle , the appliance turns o automatically to save energy.
Note that some programme/option accords with "Crease Care"
system. This means that for some hours, after the end of the
drying cycle, the drum rotates at regular intervals to prevent the
formation of creases.
In case of power failure, it is necessary to press the "Start/Pause"
button to restart the cycle.
CARE LABEL
Always check the care labels, especially when placing garments in
the tumble dryer for the rst time. Below are the most commonly
used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
The wool drying cycle of this machine
has been approved by The Woolmark
Company for the drying of wool
garments labelled as “hand wash”
provided that the garments are dried
according to the instructions issued
by the manufacturer of this machine.
Follow the garment care label for other
laundry instructions. . The Woolmark symbol is a Certi cation
mark in many countries.
M1762
FIRST TIME USE
Make sure that the water tank is correctly inserted. Make sure
that the drain hose on the back of the dryer is xed correctly,
either to the dryer’s water tank, or to your domestic drainage
system.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
Before using the dryer make sure it has been in an upright
position for at least 6 hours.
Should you wish to change the opening side of the door, please
contact our After-sales Service. (See phone number in the
warranty booklet).
CONTROL PANEL
1 ON/OFF Button (hold for Reset)
2 Programme Selection Knob
3 Start/Pause Button
Options Buttons*
4 Active Care
5 Dryness Level
6 Start Delay
7 Timed Drying
8 Cycle End
9 Gentle (hold for Key Lock)
10 Crease Care ( Mute)hold for
*Note: some models may have the wording in full instead of the icons.
INDICATORS
Dryness Level: Iron Dry - Hanger Dry - Cupboard Dry - Extra Dry
Cycle Phase: ENDDrying - Cool Down - End of Cycle -
Empty water tank - Clean door lter - Clean bottom lter
Refer to troubleshooting section: Failure: Call after sales service -
DEMO
Demo Mode
3 “
“
“
“
“
3 “
“
“
“
“
END
END
END
END
END
1
3
2
4
10
8
9
5 6 7
D
D
D
D
D
E
E
E
E
E
M
M
M
M
M
O
O
O
O
O
h
h
h
h
h
h
Produktspecifikationer
| Varumärke: | Hotpoint |
| Kategori: | Torktumlare |
| Modell: | NT M11 92XB UK |
Behöver du hjälp?
Om du behöver hjälp med Hotpoint NT M11 92XB UK ställ en fråga nedan och andra användare kommer att svara dig
Torktumlare Hotpoint Manualer
11 Oktober 2025
9 Oktober 2025
8 Augusti 2025
7 Augusti 2025
5 Augusti 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
29 Juli 2025
28 Juli 2025
Torktumlare Manualer
- Zanussi-electrolux
- Delonghi
- John Lewis
- Pelgrim
- Brandt
- Aspes
- Friac
- Maytag
- Concept
- Thomson
- Novamatic
- Balay
- Gibson
- Heinner
- Yamazen
Nyaste Torktumlare Manualer
23 Oktober 2025
23 Oktober 2025
21 Oktober 2025
21 Oktober 2025
20 Oktober 2025
20 Oktober 2025
19 Oktober 2025
18 Oktober 2025
17 Oktober 2025
17 Oktober 2025