Hydrotherm Dynamic-SS/X8/OP Bruksanvisning
Hydrotherm
Pannor & pannor
Dynamic-SS/X8/OP
Läs gratis den bruksanvisning för Hydrotherm Dynamic-SS/X8/OP (30 sidor) i kategorin Pannor & pannor. Guiden har ansetts hjälpsam av 9 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 5 recensioner. Har du en fråga om Hydrotherm Dynamic-SS/X8/OP eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/30
Welcome to the future of hot water.
OWNER’S MANUAL
DYNAMIC- XSS/ 8/OP
DYNAMIC - SS/X8/C
Congratulations on purchasing your new system.
You are now the proud owner of Australia’s best value, best performing heat
pump. We spent over three years designing and developing the Hydrotherm
range to ensure that each unit will provide years of trouble free operation.
However, in order to perform optimally it is important to ensure that your
Hydrotherm is installed and operated inline with the instruction found in this
manual. Once operational there is little you need to do, except enjoy plenty
of affordable hot water.
3
1.0 PARTS & CONSTRUCTION SCHEMATIC................
2.0 INSTALLATION INSTRUCTIONS............................
3.0 PLUMBING SCHEMATICS......................................
4.0 PLUMBING INSTALLATION...................................
5.0 ELECTRICAL CONNECTIONS.................................
6.0 COMMISSIONING THE SYSTEM............................
7.0 OPERATION PANEL INSTRUCTIONS.....................
8.0 ERROR HANDLING................................................
9.0 TROUBLE SHOOTING.............................................
10. SERVICE REPRESENTATIVE MAINTENANCE.......
11. WARRANTY.............................................................
CONTENTS
For Outdoor use, or if its installed
inside minimum15m
3 room volume
The Ambient of the appliance to
be used is -5°C to 35°C
Positioning, installation and
commissioning must be carried out
by trained personnel working in
accordance with these operating
and installation instructions.
WARNING:
This appliance is not intended for
use by persons (including children)
with reduced physical sensory
or mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision
or instruction concerning use of the
appliance by a person responsible
for their safety. Children should
be supervised to ensure that they
do not play with the appliance.
The appliance shall be installed in
accordance with national wiring
regulations.
Symbols used in these instructions
Observe the following safety instructions:
Please Note:
Warning about possible dangers.
iNote:
Important information and tips.
iNote: Carefully read these
operating and installation
instructions and keep them safe.
Should the equipment change
hands, pass these instructions to
the subsequent owner. Pass them
to the trained contractors for
servicing purposes.
1.1 Heat Pump Schematic
1.2 Heat Pump Tank Schematic
2.1 Delivery
2.2 Location
2.3 Airflow
2.4 Noise
3.1 VOLT Connection Dimensions & Components
3.2 DYNAMIC Connection Dimensions & Components
5.1 Electrical Schematic
5.2 Pre-Connection & Regulations
5.3 Hard Wiring the System
7.1 Control / Display Interface
7.2 Display Panel
7.3 Setting The Clock
7.4 Timers
7.5 F11 Maximum Temperature Setting
7.6 F12 Temperature To Activate The Heat Pump
7.7 Other Settings
4
6
8
10
12
14
16
24
25
26
27
Produktspecifikationer
| Varumärke: | Hydrotherm |
| Kategori: | Pannor & pannor |
| Modell: | Dynamic-SS/X8/OP |
Behöver du hjälp?
Om du behöver hjälp med Hydrotherm Dynamic-SS/X8/OP ställ en fråga nedan och andra användare kommer att svara dig
Pannor & pannor Hydrotherm Manualer
7 September 2024
6 September 2024
Pannor & pannor Manualer
- Imarflex
- Atlantic
- Respekta
- Wesen
- Aspes
- Amtrol
- Longvie
- Rommelsbacher
- Bosch
- Hotpoint
- Thermoflow
- Adler
- Intellihot
- Inventum
- Eccotemp
Nyaste Pannor & pannor Manualer
9 April 2025
9 April 2025
9 April 2025
1 April 2025
31 Mars 2025
13 Mars 2025
10 Mars 2025
10 Mars 2025
4 Mars 2025
4 Mars 2025