Indesit IWDC 7125 Bruksanvisning
Indesit
tvättmaskin
IWDC 7125
Läs gratis den bruksanvisning för Indesit IWDC 7125 (12 sidor) i kategorin tvättmaskin. Guiden har ansetts hjälpsam av 3 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 2 recensioner. Har du en fråga om Indesit IWDC 7125 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/12
GB
1
Contents
Installation, 2-3
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Care and maintenance, 4
Cutting off the water or electricity supply
Cleaning the washer-dryer
Cleaning the detergent dispenser drawer
Caring for the door and drum of your appliance
Cleaning the pump
Checking the water inlet hose
Precautions and tips, 5
General safety
Disposal
Description of the washer-dryer and starting
a wash cycle, 6-7
Control panel
Indicator lights
Starting a wash cycle
Wash cycles, 8
Table of wash cycles
Personalisation, 9
Setting the temperature
Setting the drying cycle
Functions
Detergents and laundry, 10
Detergent dispenser drawer
Preparing the laundry
Garments requiring special care
Load balancing system
Troubleshooting, 11
Service, 12
IWDC 7125
Instructions for use
WASHER-DRYER
English,1
GB
! This symbol reminds you to read this instruction
manual.
2
GB
Installation
! This instruction manual should be kept in a safe
place for future reference. If the washer-dryer is
sold, transferred or moved, make sure that the
instruction manual remains with the machine so
that the new owner is able to familiarise himself/
herself with its operation and features.
! Read these instructions carefully: they contain
vital information relating to the safe installation
and operation of the appliance.
Unpacking and levelling
Unpacking
1. Remove the washer-dryer from its packaging.
2. Make sure that the washer-dryer has not been
damaged during the transportation process. If it
has been damaged, contact the retailer and do not
proceed any further with the installation process.
3. Remove the pro-4
tective screws (used
during transportation)
and the rubber washer
with the corresponding
spacer, located on the
rear part of the applian-
ce ( ).see figure
4. Close off the holes using the plastic plugs provided.
5. Keep all the parts in a safe place: you will
need them again if the washer-dryer needs to
be moved to another location.
! Packaging materials should not be used as
toys for children.
Levelling
1. Install the washer-dryer on a flat sturdy floor,
without resting it up against walls, furniture ca-
binets or anything else.
2. If the floor is not per-
fectly level, compensate
for any unevenness by
tightening or loosening
the adjustable front feet
(see figure); the angle of
inclination, measured in
relation to the worktop,
must not exceed 2°.
Levelling the machine correctly will provide it with
stability, help to avoid vibrations and excessive
noise and prevent it from shifting while it is ope-
rating. If it is placed on carpet or a rug, adjust
the feet in such a way as to allow a sufficient
ventilation space underneath the washer-dryer.
Connecting the electricity and wa-
ter supplies
Connecting the water inlet hose
1. Connect the supply
pipe by screwing it to
a cold water tab using
a ¾ gas threaded con-
nection (see figure).
Before performing the
connection, allow the
water to run freely until
it is perfectly clear.
2. Connect the inlet
hose to the washer-dr-
yer by screwing it onto
the corresponding wa-
ter inlet of the applian-
ce, which is situated on
the top right-hand side
of the rear part of the
appliance . (see figure)
3. Make sure that the hose is not folded over
or bent.
! The water pressure at the tap must fall within
the values indicated in the Technical details table
(see next page).
! If the inlet hose is not long enough, contact a
specialised shop or an authorised technician.
! Never use second-hand hoses.
! Use the ones supplied with the machine.
GB
3
Technical data
Model
IWDC 7125
Dimensions
width 59.5 cm
height 85 cm
depth 53,5 cm
Capacity
from 1 to 7,5 kg for the
wash programme;
from 1 to 4,5 kg for the
drying programme
Electrical
connections
please refer to the technical
data plate fixed to the machine
Water con-
nections
maximum pressure 1 MPa
(10 bar)
minimum pressure 0.05
MPa (0.5 bar)
drum capacity 52 litres
Spin speed
up to 1200 rotations per minute
Energy rated
programmes
according to:
- AS/NZS
2040.2 (wa-
shing)
- AS/NZS
2442.2 (drying)
Wash: programme 2; tem-
perature 60°C at 1200 rpm;
run with a load of 7,5 kg.
Drying: the smaller load
(2kg) must be dried by
selecting the “ ” dryness
level. The load must consist
of 2 sheets, 1 pillowca-
se and 1 hand towel; the
remainder of the load must
be dried by selecting the “
” dryness level.
This appliance conforms to
the following EC Directives:
- 89/336/EEC dated
03/05/89 (Electromagnetic
Compatibility) and subse-
quent modifications
- 2012/19/EU (WEEE)
- 2006/95/EC Low Voltage)
65 - 100 cm
Connecting the drain hose
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.
Electrical connection
Before inserting the plug into the electrical so-
cket, make sure that:
• the socket is earthed and complies with cur-
rent regulations;
• the socket can withstand the maximum load of
the appliance, which is indicated in the Techni-
cal data table (see opposite);
• the power supply voltage falls within the values in-
dicated in the Technical data table (see opposite);
• the socket is compatible with the plug of the ap-
pliance. If this is not the case, either the socket
or the plug must be replaced.
! The machine must not be installed outdoors,
even in covered areas. It is extremely dangerous
to leave the appliance exposed to rain, storms
and other weather conditions.
! Once the machine has been installed, the
electricity socket should be easily accessible.
! Avoid using any extension cord or multiple
socket outlet.
! if this appliance is supplied from a CAUTION:
cord extension set or electrical portable outlet
device, the cord extension set or electrical por-
table outlet device must be positioned so that it
is not subject to splashing or ingress of moisture.
! The cable should not be bent or compressed.
! The cable should be replaced only by authori-
sed technicians.
! If the supply cord is damaged, it must be repla-
ced by the manufacturer, its service agent or simi-
larly qualified persons in order to avoid a hazard.
Warning! The company shall not be held re-
sponsible for any incidents that occur if these
regulations are not observed.
The first wash cycle
Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, using the wash cycle 2.
Produktspecifikationer
| Varumärke: | Indesit |
| Kategori: | tvättmaskin |
| Modell: | IWDC 7125 |
Behöver du hjälp?
Om du behöver hjälp med Indesit IWDC 7125 ställ en fråga nedan och andra användare kommer att svara dig
tvättmaskin Indesit Manualer
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
tvättmaskin Manualer
Nyaste tvättmaskin Manualer
4 Juli 2025
4 Juli 2025
4 Juli 2025
4 Juli 2025
4 Juli 2025
4 Juli 2025
4 Juli 2025
4 Juli 2025
4 Juli 2025
4 Juli 2025