InvisibleShield Glass Curve Elite Bruksanvisning
InvisibleShield
Skärmskydd
Glass Curve Elite
Läs gratis den bruksanvisning för InvisibleShield Glass Curve Elite (2 sidor) i kategorin Skärmskydd. Guiden har ansetts hjälpsam av 20 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 10.5 recensioner. Har du en fråga om InvisibleShield Glass Curve Elite eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
1
THOROUGHLY CLEAN YOUR SCREEN.
Turn off your phone and remove any accessories (case,
screen protection, etc). Clean your screen thoroughly,
even if it just came out of the box. Start with the wet wipe,
followed by the microfiber cloth. Pay extra attention to
the curved edges. Use the included dust removal sticker
to remove any remaining lint or dust.
2
PLACE EZ APPLY TRAY ON PHONE.
You must use the install tray to ensure proper alignment.
If your is not on straight, you may have InvisibleShield
functionality issues. The top of the tray is marked with the
InvisibleShield logo and aligns with the speaker end of
your phone.
Set the EZ Apply tray on top of your device and firmly
press down to secure it in place. Check the corners to
make sure they are secure and properly aligned.
3
4
REMOVE TAB 1. PEEL AND PLACE.
Before you place the onto the EZ Apply InvisibleShield
tray, notice that the top of the has been InvisibleShield
cut to fit around the speaker of your phone. This end
will go at the top of the EZ Apply tray—the end with the
InvisibleShield logo.
Peel away the clear protective film labelled #1. Do NOT
touch the exposed surface. Use the EZ Apply tabs to
place the in the EZ Apply tray. InvisibleShield
APPLY USING SQUEEGEE.
With your finger, press down on the near InvisibleShield
the middle of the screen. Then carefully remove the EZ
Apply tray and carefully peel away the protective liner.
Important: This is a full-adhesive
screen protector. The installation
process, while not difficult, requires
attention to detail. Please allow
yourself time to execute each step
carefully and thoroughly.
glass curve elite
Installation tips
For the next part, hold the squeegee with four fingers
when you run it down the length of the screen. This
will create firm, steady pressure.
Starting at the bottom of the screen, use the fabric end
of the squeegee and run it to the top of the screen in
one smooth motion.
Next, start at the bottom of the screen again and run
the squeegee up the left side of the screen. Repeat that
motion up the right side of the screen. Finally, use your
thumbs to smooth the along the edges InvisibleShield
of your screen.
1 2 3
4 5
Produktspecifikationer
| Varumärke: | InvisibleShield |
| Kategori: | Skärmskydd |
| Modell: | Glass Curve Elite |
Behöver du hjälp?
Om du behöver hjälp med InvisibleShield Glass Curve Elite ställ en fråga nedan och andra användare kommer att svara dig
Skärmskydd InvisibleShield Manualer
25 Februari 2025
Skärmskydd Manualer
Nyaste Skärmskydd Manualer
7 Januari 2025
28 December 2024
23 December 2024
20 December 2024
21 September 2024
19 September 2024
19 September 2024
7 September 2024
6 September 2024
