Irritrol RS1000 Bruksanvisning

Irritrol Inte kategoriserad RS1000

Läs gratis den bruksanvisning för Irritrol RS1000 (12 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 14 personer och har ett genomsnittsbetyg på 3.5 stjärnor baserat på 7.5 recensioner. Har du en fråga om Irritrol RS1000 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/12

Wireless RainSensor User’s Guide 1

Table of Contents

Component Overview 2

Quick Start Installation Instructions 3

Detailed Installation Instructions

• Mounting the Receiver

• Wiring the Receiver

• Control Wire Connection

• Power Wire Connection

• Initial Receiver Testing

Installing the Sensor / Transmitter

• Testing the Signal Strength

• Installation

• Freeze Sensor Installation

Wireless RainSensor Operation

• Normal Operation

• Smart Bypass

• Power Down

• Receiver Learn Mode

• Attention Required

Sensor Adjustment

Battery Replacement

Changing Sensor/Transmitter Code 9

Troubleshooting 10

Specications 11

Electromagnetic Compatibility 12

Technical Support Numbers 12

Congratulations on your purchase of the Irritrol Systems Wireless RainSensor. The

Wireless RainSensor components are designed for easy installation, so your sensor

controlled irrigation system will be up and running in minutes.

Before attempting the installation, please read through these instructions in their

entirety, and refer the installation instructions for your irrigation system controller/timer

in regards to connecting a rain sensor or rain switch. The Wireless RainSensor is

designed to work with either Normally Open or Normally Closed sensor circuits.

: Please note the following information regarding installation and use of Important

the Wireless RainSensor components:

• The RainSensor Receiver Module is designed to operate with 24 VAC power

only. Connecting the receiver wiring to 120/240 VAC power may result in severe

equipment damage.

• Installation methods must comply with all applicable national and local building

codes. If you are unsure about proper wiring practices, have a qualied contractor

perform the installation for you.

• The Receiver cover should always be used when the Receiver is installed outdoors.

• The Sensor/Transmitter should never be submerged in water or installed inside a

rain gutter.

Introduction

Wireless RainSensorTM

Models RS1000 & RFS1000 (+Freeze)

User’s Guide

RS1000

SENSOR STATUS

SIGNAL

POWER

Blinking Bypass ON

Blinking Attn. Reqd.

SENSOR STATUS

PRESS

Receiver

Sensor/Transmitter

Produktspecifikationer

Varumärke:	Irritrol
Kategori:	Inte kategoriserad
Modell:	RS1000
Färg på produkten:	Zwart
Höjd:	730 mm
Antal brännare/kokzoner:	1 zone(s)
Strömförsörjning:	230 V, 50/60 Hz
LED-indikatorer:	Temperatuur
Typ av enhet:	Vloer
Totala tillgångar:	2000 W
Bakyta (BXD):	395 x 395 mm
Kokyta form:	Rond