JL Audio MVi-DRCADAPT Bruksanvisning
JL Audio
Fjärrkontroll
MVi-DRCADAPT
Läs gratis den bruksanvisning för JL Audio MVi-DRCADAPT (4 sidor) i kategorin Fjärrkontroll. Guiden har ansetts hjälpsam av 6 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 3.5 recensioner. Har du en fråga om JL Audio MVi-DRCADAPT eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
Rotary DRC Adaptor for MVi Amplifiers
(Use with rotary-style Digital Remote Controllers only.)
MVi-DRCADAPT
Product Description:
The MVi-DRCADAPT permits the direct connection of a JL Audio rotary-style Digital
Remote Controller (DRC) to a MVi amplifier via its JLid-COMM Port.
Notes: This product is not compatible with mono MV amplifiers or the MVi-HUB.
This product is not needed for connection of M-DRC-50 push-button controller.
What is Included:
(1) MVi-DRCADAPT
(1) Mounting Clip
(2) Mounting Screws
Placement Considerations:
The MVi-DRCADAPT should be installed near the connected MVi amplifier,
where its JLid status LED can be viewed.
Installation:
1. Plug the cable end of the MVi-DRCADAPT into the JLid-COMM port of the MVi amplifier.
2. Install a compatible DRC controller (sold separately) per its instructions and connect its
cable end to the RJ45 jack of the MVi-DRCADAPT.
Mounting Clip Installation:
A mounting clip is included to secure the MVi-DRCADAPT module. Use the supplied screws
to fasten the mounting clip to a flat surface. Once the mounting clip is installed, attach the
MVi-DRCADAPT module by pressing one side of its notched center section against the
inside of one of the arms of the mounting clip. Continue pressing inward until both arms of
the mounting clip snap around the notched center section of the MVi-DRCADAPT module.
Ensure that the JLid Status LED is facing outward and visible. To remove, grasp the module’s
body and pull while rotating away from the mounting clip.
JLid Status LED:
The MVi-DRCADAPT module is equipped with a multi-color status LED.
Refer to the table below for detailed info:
MVi-DRCADAPT LED Color Status
Green JLid™ detection in progress
Blue Successful connection of a compatible DRC
Yellow Unrecognized JLid ™ device
(retry attempts result in ashing Yellow)
Yellow-Green (alternating) Faulty JLid™ device
None (JLid-COMM Port LED of the
connected MVi amplier ashes Red)
Short circuit condition of JLid ™ connection
(MVi-DRCADAPT turns OFF)
To DRC
MVi-DRCADAPT
Connects to the JLid™ COMM Port on MVi ampliers
Note: Components pictured may not be to scale.
DRC sold separately.
Produktspecifikationer
| Varumärke: | JL Audio |
| Kategori: | Fjärrkontroll |
| Modell: | MVi-DRCADAPT |
Behöver du hjälp?
Om du behöver hjälp med JL Audio MVi-DRCADAPT ställ en fråga nedan och andra användare kommer att svara dig
Fjärrkontroll JL Audio Manualer
20 September 2024
31 Augusti 2024
17 Augusti 2024
16 Augusti 2024
15 Augusti 2024
14 Augusti 2024
9 Augusti 2024
7 Augusti 2024
6 Augusti 2024
2 Augusti 2024
Fjärrkontroll Manualer
- Schwaiger
- Ferguson
- ESYLUX
- Logitech
- Medion MD6461
- Panasonic
- Hannspree
- Delta Dore
- GBS Elettronica
- Zalman
- Neewer
- KPN
- DSC
- Archos
- Maximex
Nyaste Fjärrkontroll Manualer
9 April 2025
4 April 2025
3 April 2025
3 April 2025
2 April 2025
2 April 2025
1 April 2025
31 Mars 2025
31 Mars 2025
30 Mars 2025