Kenwood KSC-35 Bruksanvisning
Kenwood
laddare för mobil enhet
KSC-35
Läs gratis den bruksanvisning för Kenwood KSC-35 (25 sidor) i kategorin laddare för mobil enhet. Guiden har ansetts hjälpsam av 7 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 4 recensioner. Har du en fråga om Kenwood KSC-35 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/25
PRECAUTIONS
This AC adapter and Rapid charger is exclusively for use with KENWOOD transceivers.
The battery pack includes ammable objects such as organic solvent. Mishandling may cause the
battery to rupture producing ames or extreme heat, deteriorate, or cause other forms of damage to the
battery. Please observe the following prohibitive matters.
• Use only the specied AC adapter and battery charger by KENWOOD.
• Always remove the AC adapter from a wall outlet before attempting to inspect or clean the charger.
• Do not disassemble the charger and AC adapter.
• If the transceiver and battery pack are wet, do not place them into the charger.
• Do not expose the charger to rain or moisture.
• Do not use the damaged AC adapter and charger.
• Do not short the charging terminals with metal objects.
• Do not reverse-charge or reverse-connect the battery.
• Do not use the charger in hot or humid environments, in direct sunlight, nor near heaters.
CHARGING PROCEDURE
1 Plug the AC adapter cable into the adapter jack located on the rear of
the charger.
2 Plug the AC adapter into an AC outlet.
3 Slide a battery pack or a transceiver equipped with a battery pack
into the charging slot.
• Make sure the metal contacts of the battery pack mate securely
with the charger terminals.
• The indicator lights red and charging starts.
4 When charging is completed, the indicator lights green (or blinking
green).
• Remove the battery pack or the transceiver from the charging slot.
• When the charger will not be used for a long time, unplug the AC
adapter from the AC outlet.
CHARGER STATUS TABLE
Indicator Color Meaning
Red A battery pack is in the charging slot and charging has started.
Blinking red The battery pack is defective or the battery pack contacts are not properly
mated with those of the charger.
Green
(or blinking green)
Charging is completed; remove the battery pack or the transceiver from the
charging slot.
Blinking green and
yellow
The temperature of the battery pack has not satised the charging start
temperature. In this instance, remove the battery until its temperature
increases, then recharge it.
AC ADAPTER/ RAPID CHARGER
SIMPLE GUIDE
© 2015
B5A-1079-00
Produktspecifikationer
| Varumärke: | Kenwood |
| Kategori: | laddare för mobil enhet |
| Modell: | KSC-35 |
Behöver du hjälp?
Om du behöver hjälp med Kenwood KSC-35 ställ en fråga nedan och andra användare kommer att svara dig
laddare för mobil enhet Kenwood Manualer
25 September 2025
24 September 2025
24 September 2025
24 September 2025
9 September 2025
9 September 2025
laddare för mobil enhet Manualer
- SBS
- HP
- SKROSS
- Nedis
- Uniden
- Energizer
- Xmoove
- Aluratek
- Gigabyte
- Anker
- Alogic
- Green Cell
- Acefast
- IOttie
- Belkin
Nyaste laddare för mobil enhet Manualer
15 Oktober 2025
7 Oktober 2025
7 Oktober 2025
28 September 2025
27 September 2025
27 September 2025
27 September 2025
26 September 2025
26 September 2025
26 September 2025