Kichler 8TD24V060BKT Bruksanvisning

Kichler Inte kategoriserad 8TD24V060BKT

Läs gratis den bruksanvisning för Kichler 8TD24V060BKT (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 18 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 9.5 recensioner. Har du en fråga om Kichler 8TD24V060BKT eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/4

BEFORE INSTALLING:

All installations should comply with National and local Electrical codes.

If you have any doubts concerning installation contact a qualied licensed

electrician.

CAUTION:

To reduce the risk of re, do not install closer than 1 inch to cabinet wall or in

compartment smaller than 12 inches by 12 inches by 12 inches.

IMPORTANT SAFETY INSTRUCTIONS

a) Read all instructions.

b) Do not conceal or extend exposed conductors through a building wall,

oor or ceiling.

c) Install this system in dry or damp locations only.

d) To reduce risk of re and burns, do not install this lighting system where

the exposed bare conductors can be shorted or contact any conductive

materials.

e) To reduce the risk of re and overheating, make sure all connections

are tight.

f) Do not install any luminaire closer than 6 inches (15.25cm) from any

curtain, or similar combustible materials.

g) Power supply has three distinct sections:

o line voltage (AC Input), black and white

o 0-10V dimmer (DC input), purple and grey

o low voltage (DC Output), red and blue

It is important to keep the line voltage and the DC voltage

wires separate.

h) Turn o󰀨 electrical power before modifying the lighting system in any way.

We’re here to help 866-558-5706

Hrs: M-F 9am to 5pm EST

Kichler 8TD24V090BKT, 8TD24V060BKT Power Supplies

Installation Instructions

MOUNTING SCREW

IS-8TD24V09-US

NOTE: Kichler 8TD-Series (24V) are not compatible with dimmers

when used in conjunction with tape light controllers, also not

compatible with the phase cut dimmers.

Kichler 8TD-Series (24V) are only compatible with 0-10V dimmers.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL

INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

SAVE THESE INSTRUCTIONS

1) Turn o󰀨 power.

2) Determine desired location for mounting power supply. Power supply should

be located within 25’ of rst luminaire.

3) Secure power supply using provided mounting screws. Secure into wall studs

if possible, otherwise, use appropriate anchors rated for proper wall material

and hanging weight (not included).

4) Using the pre-punched knock-outs in the metal enclosure, route the

120V - 277V line voltage to the primary side (AC Input) of the power supply.

NOTE: A proper UL listed cable connector must be used in the knock-out to

provide strain relief and wire protection (cable connector provided).

5) Make grounding connection (connector provided).

6) Make wire connections (connectors are provided). Reference chart below for

connections and wire accordingly.

Connect Line (Black or Red

Supply Wire) to:

Connect Neutral (White

Supply Wire) to:

Black White

*Parallel cord (round &

smooth)

*Parallel cord (square &

ridged)

Clear without tracer Clear with white tracer

*Note: When parallel wire (SPT 1 &

SPT 2) are used. The neutral wire

is square shaped or ridged and the

other wire will be round in shape or

smooth (See illus.)

Neutral Wire

7) Total load of the installed lighting system must not exceed rated Wattage of

power supply.

NOTE: After determining the layout of the system, add the

wattage of each luminaire/xture together to calculate the total system

consumption. The calculated total system consumption should be equal

or less than the Class 2 power supply rating that is being used.

8) Using the pre-punched knock-outs in the metal enclosure, route and connect

the leads from 0-10V dimmer to the secondary side 0-10V dimmer (DC input)

of the power supply.

Connect dimmer+ to the purple wire and dimmer- to the grey wire NOTE:

using the supplied wire nuts or other UL approved connectors.

9) Using the pre-punched knock-outs in the metal enclosure, route and connect

the lighting system leads to the secondary side 0-10V dimmer (DC input) of

the power supply.

Connect positive to the red wire and negative to the blue wire NOTE:

using the supplied wire nuts or other UL approved connectors. Do not

exceed manufacturers’ wiring combination specications for size and quantity

of conductors.

NOTE: A proper UL listed cable connector must be used in the knock-outs to

provide wire protection (cable connector provided).

PRIMARY SIDE CABLE

CONNECTOR

SECONDARY SIDE CABLE

CONNECTOR

PRIMARY SIDE WIRE

COMPARTMENT

SECONDARY SIDE WIRE

COMPARTMENT

FIXTURE DIAGRAM

Produktspecifikationer

Varumärke:	Kichler
Kategori:	Inte kategoriserad
Modell:	8TD24V060BKT
Färg på produkten:	Zwart
Förpackningens vikt:	7000 g
Förpackningens bredd:	795 mm
Djuppackning:	128 mm
Förpackningshöjd:	530 mm
Blåtand:	Ja
Skärm diagonal:	32 "
Upplösning:	1366 x 768 Pixels
Antal processorkärnor:	4
Videoformat som stöds:	HEVC/H.265
Inkluderar operativsystem:	Android
Ethernet LAN:	Ja
Skärmform:	Flat
Ljusstyrka:	250 cd/m²
Antal USB 2.0-portar:	2
VGA (D-Sub) port(ar):	1
Antal HDMI-portar:	3
Kompositvideoingång:	1
Antal Ethernet LAN (RJ-45)-portar:	1
Smart TV:	Ja
Genomsnittlig effekt:	12 W
Strömförbrukning (i standby):	0.5 W
Antal högtalare:	2
Hörlursutgångar:	1
Analog signalformat:	NTSC
High Dynamic Range (HDR)-teknologi:	Hybrid Log-Gamma (HLG)
HDR-stöd:	Ja
HD typ:	HD
Respons tid:	- ms
VESA montering:	Ja
Panelmonteringsgränssnitt:	75 x 75 mm
Djup (utan bas):	78 mm
Höjd (utan bas):	439 mm
Bredd (utan bas):	732 mm
Vikt (utan bas):	4700 g
Skärmdiameter i centimeter:	80 cm
Digitalt ljud, optisk utgång:	1
Common Interface Plus (CI+):	Ja
Typ av tuner:	Analoog & digitaal
Digitalt signalformat:	DVB-C, DVB-S2, DVB-T2
Internet-TV:	Ja
Hybrid Broadcast Broadband TV (HbbTV):	Ja
Video-appar:	Amazon Prime Video, Netflix, YouTube
Fungerar med Amazon Alexa:	Ja
Ljudlägen:	Classic, Custom, Flat, Movie, Music, Speech
Energiförbrukning (HDR) per 1000 timmar:	32 kWu
Energieffektivitetsklass (SDR):	F
Energiförbrukning (SDR) per 1000 timmar:	32 kWu
Energieffektivitetsklass (HDR):	F
Enhetsbredd (med stativ):	732 mm
Djupenhet (med stativ):	193 mm
Enhetshöjd (med stativ):	481 mm
Kvicksilverinnehåll:	0 mg
Text-TV:	Ja
Equalizerinställningar:	Ja
Hybrid Broadcast Broadband TV (HbbTV) version:	1.5
Elektronisk TV-guide:	Ja
Audio Return Channel (ARC):	Ja
Innehåller inte:	Lood
Automatisk kanalsökning:	Ja
USB-inspelning:	Ja
Smarta lägen:	Cinema, Custom, Dynamic, Game, Natural, Sports
LED backlight-type:	Direct-LED
Antal band equalizer:	5
Fjärrkontroll ingår:	Ja
Wifi:	Ja
AC-ingångsspänning:	220-240 V
Strömförbrukning (typiskt):	- W
Fungerar med Google Assistant:	Ja
Energieffektivitetsskala:	A tot G