Kicker CX1200.1 Bruksanvisning
Läs gratis den bruksanvisning för Kicker CX1200.1 (28 sidor) i kategorin bilradio. Guiden har ansetts hjälpsam av 5 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 3 recensioner. Har du en fråga om Kicker CX1200.1 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/28
Owner’s Manual |
Manual del Propietario |
Benutzerhandbuch |
Manuel d’utilisation |
CX Amplifiers
2012 CX Mono Amps Rev I.indd 1
2012 CX Mono Amps Rev I.indd 1
2012 CX Mono Amps Rev I.indd 1
2012 CX Mono Amps Rev I.indd 12012 CX Mono Amps Rev I.indd 1 6/22/2012 2:32:04 PM
6/22/2012 2:32:04 PM
6/22/2012 2:32:04 PM
6/22/2012 2:32:04 PM6/22/2012 2:32:04 PM
2
CX.1-SERIES AMPLIFIERS
OWNER’S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64” (3mm) bit and use the supplied #8 screws to mount the amplifi er.
The KICKER CX Amplifi ers are capable of space-saving vertical mounting. Use a 2.5mm hex key (Allen wrench)
to loosen the endpanel, remove the existing brackets, then insert and tighten the double-slotted brackets to the
amplifi er as illustrated on the next page.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
Model: CX300.1 CX600.1 CX1200.1
RMS Power
@ 14.4V, 4 1% THD+NΩ mono,
@ 14.4V, 2 mono, 1% THD+NΩ
150W x 1
300W x 1
300W x 1
600W x 1
600W x 1
1200W x 1
Length | in [mm] 8-1/8 [210] 8-1/8 [210] 12-1/16 [310]
Specifi cations common to all models:
Height | in [mm] 2-3/8 [60]
Width | in [mm] 7-3/16 [180]
Frequency Response ± 1dB 25Hz–200Hz
Signal-to-noise Ratio >95dB, A-weighted, re: rated power
Input Sensitivity Low Level: 125mV–5V
High Level: 250mV–10V
Electronic Crossover Variable Lo-pass 50Hz–200Hz, 12dB/octave
Bass Boost Variable 0–12dB @ 40Hz
Subsonic Filter 25Hz, 24dB/octave
Remote Bass Yes [sold separately]
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
MODEL: CX300.1 / CX600.1 / CX1200.1
2012 CX Mono Amps Rev I.indd 2
2012 CX Mono Amps Rev I.indd 2
2012 CX Mono Amps Rev I.indd 2
2012 CX Mono Amps Rev I.indd 22012 CX Mono Amps Rev I.indd 2 6/22/2012 2:32:28 PM
6/22/2012 2:32:28 PM
6/22/2012 2:32:28 PM
6/22/2012 2:32:28 PM6/22/2012 2:32:28 PM
3
Wiring: Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24” (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle’s chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery’s negative post and the vehicle chassis is recommended.
The CX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo’s source unit. A high-level signal can be run from the source unit’s speaker outputs to the
stereo RCA input on the end panel of the amplifi er using the KICKER ZISL as shown (make sure you set the CX
amplifi er’s input level switch to “HI”). Alternatively, the signal can be delivered to the amplifi er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to “LO”. Either input
method will provide a low-level output signal at the RCA output, which effectively passes the audio signal to
another amplifi er or component. Keep the audio signal cable away from factory wiring harnesses and other
power wiring. If you need to cross this wiring, cross it at a 90 degree angle.
source unit
high-level speaker
outputs
to amplifi er
shield
double-slotted
bracket
+
+
+
––
–
core conductor KICKER ZISL (optional)
source unit high-level
speaker outputs
OR to amplifi er
VERTICAL MOUNTING
hex screws
amplifi er side panel
2012 CX Mono Amps Rev I.indd 3
2012 CX Mono Amps Rev I.indd 3
2012 CX Mono Amps Rev I.indd 3
2012 CX Mono Amps Rev I.indd 32012 CX Mono Amps Rev I.indd 3 6/22/2012 2:32:29 PM
6/22/2012 2:32:29 PM
6/22/2012 2:32:29 PM
6/22/2012 2:32:29 PM6/22/2012 2:32:29 PM
Produktspecifikationer
| Varumärke: | Kicker |
| Kategori: | bilradio |
| Modell: | CX1200.1 |
Behöver du hjälp?
Om du behöver hjälp med Kicker CX1200.1 ställ en fråga nedan och andra användare kommer att svara dig
bilradio Kicker Manualer
13 Juni 2025
13 Juni 2025
4 Oktober 2024
1 Oktober 2024
29 September 2024
23 September 2024
18 September 2024
16 September 2024
12 September 2024
12 September 2024
bilradio Manualer
- Varta
- Harman Kardon
- Impulse
- Lenco
- Overmax
- Clas Ohlson
- DLS
- Pioneer
- Focal
- RTO
- Silvercrest
- MT Logic
- Phonocar
- Akai
- Clatronic
Nyaste bilradio Manualer
13 Juni 2025
13 Juni 2025
11 Juni 2025
11 Juni 2025
11 Juni 2025
9 Juni 2025
9 Juni 2025
7 Juni 2025
7 Juni 2025
7 Juni 2025