Kingston HyperX FURY Bruksanvisning

Läs gratis den bruksanvisning för Kingston HyperX FURY (2 sidor) i kategorin Flashminne. Guiden har ansetts hjälpsam av 36 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 4 recensioner. Har du en fråga om Kingston HyperX FURY eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

DESCRIPTION

HyperX HX316C10FB/8 is a 1G x 64-bit (8GB) DDR3-1600

CL10 SDRAM (Synchronous DRAM) 2Rx8 memory module,

based on sixteen 512M x 8-bit DDR3 FBGA components. This

module has been tested to run at DDR3-1600 at a low latency

timing of 10-10-10 at 1.5V. Additional timing parameters are

shown in the PnP Timing Parameters section below. The

JEDEC standard electrical and mechanical specifications are

as follows:

Document No. 4807007-001.B00 04/23/15 Page 1

SPECIFICATIONS

selcyc 01)DDI(LC

Row Cycle Time (tRCmin)48.125ns (min.)

Refresh to Active/Refresh260ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin)37.5ns (min.)

Maximum Operating PowerTBD W*

0 - V 49gnitaR LU

Operating Temperature0o C to 85o C

Storage Temperature-55o C to +100o C

*Power will vary depending on the SDRAM used.

FEATURES

•JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

•VDDQ = 1.5V (1.425V ~ 1.575V)

•800MHz fCK for 1600Mb/sec/pin

•8 independent internal bank

•Programmable CAS Latency: 11, 10, 9, 8, 7, 6

•Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

•8-bit pre-fetch

•Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the fly using A12 or

MRS]

•Bi-directional Differential Data Strobe

•Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

•On Die Termination using ODT pin

•Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

•Asynchronous Reset

•Height 1.291” (32.80mm) w/heatsink, double sided

component

HX316C10FB/8

8GB 1G x 64-Bit DDR3-1600

CL10 240-Pin DIMM

Continued >>

kingston.com/hyperx

PnP JEDEC TIMING PARAMETERS:

•DDR3-1600 CL10-10-10 @1.5V

•DDR3-1333 CL9-9-9 @1.5V

•DDR3-1066 CL7-7-7 @1.5V

Note:The PnP feature offers a range of speed and timing options to support

the widest variety of processors and chipsets. Your maximum speed will

be determined by your BIOS.

Produktspecifikationer