KitchenAid W10188988 Bruksanvisning
Sidor 4 Engels Diskmaskin
Läs bruksanvisningen för KitchenAid W10188988 gratis online eller ladda ner PDF:en. 21 personer har tyckt att guiden var hjälpsam. Fråga om modellen? Ställ en fråga

For Drawer Dishwasher (Single and Double Drawer)
Door Panel Removal:
Attaching Handle:
4.Measure and mark the location of the handle. The vertical
location is customer preference. Mount the handle to the
customer-supplied custom outer door panel using the two (2)
mounting screws provided.
IMPORTANT: The screws must not extend beyond the back
surface of the panel. The screw holes should be countersunk for
the screw heads to be flush with the panel.
5. Install the door panel reversing steps 1, 2, and 3 of “Door
Panel Removal”section.
6. Repeat steps 1-5 to install the handle on the other dish
drawer (for Double Drawers).
Installation Instructions
Dishwasher Handle Accessory Kit
W10084565A
IMPORTANT: A qualified service technician should perform this
installation. Wear gloves and handle panels gently.
Custom Accessory Kit contains:
■1 Handle
■2 Mounting Screws
Installation Procedures
NOTE: If door panel must be removed to install new door handle,
follow steps below:
Door Panel Removal:
1.Open dishwasher door and use a T-15 Torx™ screwdriver to
remove three (3) to four (4) screws on each side - total of six
(6) to eight (8) screws. See below for location of screws to be
removed. Hold inner and outer door panels together until all of
the screws are removed.
2.Partially close dishwasher door and tilt out the outer door
panel. Lift up outer panel and remove. Set panel aside on a
towel or covered surface to avoid scratching.
Remove (8)
screws (some
models use only
(6) screws for
panel removal)
Attaching Handle:
1.Measure and mark the location for the handle. The handle
should be centered horizontally on the front of the customer-
supplied custom panel. The vertical location is customer
preference. Mount the handle to the custom outer door panel
using the two (2) mounting screws provided.
IMPORTANT: The screws must not extend beyond the back
surface of the panel. The screw holes should be countersunk for
the screw heads to be flush with the panel.
2.Install the custom door panel, reversing steps 1 and 2 of
“Door Panel Removal” section.
pin
Pin
Front of drawer
1.Remove the pins on both sides
of the dishwasher drawer by
pulling the pins straight out
with a pair of needle-nose
pliers.
2.Gently pull the bottom of the
panel away from the
dishwasher and then pull
down.
3.Remove the three (3) screws
on each side from the three
inner holes to access back of
front panel.
Produktspecifikationer
| Varumärke: | KitchenAid |
| Kategori: | Diskmaskin |
| Modell: | W10188988 |
Behöver du hjälp?
Om du behöver hjälp med KitchenAid W10188988 ställ en fråga nedan och andra användare kommer att svara dig
Diskmaskin KitchenAid Manualer
KitchenAid KDFM404KBS Bruksanvisning KitchenAid Sculptura KUDR24SEBL0 Bruksanvisning KitchenAid KUDJ01TJBL0 Bruksanvisning KitchenAid KUDC25CHBT1 Bruksanvisning KitchenAid KDFX 6041 Bruksanvisning KitchenAid KUDU03STBL2 Bruksanvisning KitchenAid KDSCM 82140 Bruksanvisning KitchenAid KDFX 6033 Bruksanvisning
Alla KitchenAid Diskmaskin manualer
Populära i Diskmaskin
KitchenAid KDFX 6020 Bruksanvisning KitchenAid KDFE 6030 Bruksanvisning KitchenAid KDTM804EBS Bruksanvisning
Diskmaskin Manualer
Nyaste Diskmaskin Manualer
Siemens SX63EX27AE Bruksanvisning Indesit IN2FE13CNO7WUK Bruksanvisning Neff S147TBS00D Bruksanvisning Sharp QW-NA25F44BI Bruksanvisning Siemens SX63HX14CE Bruksanvisning Neff S145EBS05D Bruksanvisning Siemens SN216W00DT Bruksanvisning Neff S157TBX00D Bruksanvisning Siemens SN65ZX11CE Bruksanvisning Siemens SN23EW03LE Bruksanvisning