Kramer SKIC-6 Bruksanvisning
Kramer
högtalarstöd
SKIC-6
Läs gratis den bruksanvisning för Kramer SKIC-6 (2 sidor) i kategorin högtalarstöd. Guiden har ansetts hjälpsam av 23 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 12 recensioner. Har du en fråga om Kramer SKIC-6 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
SKIC Speaker Mounting Kit
Congratulations on purchasing your Kramer SKIC Speaker Mounting Kit which used for is
securing in-ceiling speakers to the ceiling T-channel grid and comes in three sizes: SKIC-4 for
the Galil 4-CO, SKIC-6 for the Galil 6-CO for the and SKIC-8 Galil 8-CO.
The back can speakers are supported by a C-ring and two tile rails he tile rails prevent the (t
speakers from falling if the tile itself comes out or falls apart, as their ends catch onto the
T-grid). When mounting onto the ceiling tiles, use both supports. When mounting onto a
sheetrock ceiling, the C-ring alone is used to reinforce the ceiling material.
Be sure that the tiles can support the speaker. Smaller sized tiles or berglass-type tiles cannot
support the weight of the speakers. In such a case, the speakers will require additional support.
Each Speaker Mounting Kit includes: SKIC
Eight support ring screws, washers
and nuts
Two ceiling support rings (C-ring)
Four tile rails
Installing the Speaker Mounting Kit
The is installed after cutting the opening in the ceiling tile for the speakers. SKIC
To install the SKIC, as illustrated in the example in Figure 1, do the following:
1. Place the C-ring over the hole cut in the ceiling tile (on the “ceiling” side). Place it around
the hole so that the tabs located in parallel to the tile edges. are
Figure 1: Installing the Back Can Speakers
2. Place the tile rails the tile and snap them into the two tabs on the C-ring. on
Align the rails so that the ends extend over the T-channel grid.
3. Insert 2 screws through each tab on the C-ring to secure the rails.
4. Push the speaker into the ceiling hole until the front bae rim is leveled with the ceiling.
5. Tighten the mounting tabs (see Figure 2).
When tightening the mounting tabs, the tabs automatically turn outward, thus clamping
the speaker to the wall from its rear side.
Note: Do not over-tighten the mounting tabs. It may cause damage to both the speakers
and the surface.
Figure 2: Tightening the Mounting Tabs
Specications
DIMENSIONS:
Tile rails: 64.1cm x 2.2cm x 3cm ( .2 0.2. 25 ” x 0.87” x 97”) W, D, H
21.6cm x 8cm (8.5” x 3.15”)
Model
Outer Diameter
Inner Diameter
SKIC 4
18.5 ( ) cm 7.28”
14.2 cm (5.6”)
SKIC 6
24. 9.532 (cm ”)
20cm (7.9”)
SKIC 8
28.6cm (11.3”)
24.4cm (9.6 ) ”
DISTANCE
BETWEEN FIXING
POINTS:
SKIC 4: 19.1cm (7. ) approx. 5”
SKIC 6: 25.1cm (9. ) approx. 9”
SKIC 8: 29.5cm ( . ) approx.11 6”
WEIGHT OF
MOUNTING KIT
(FOR PAIR):
SKIC 4: 1.03kg (2.27lbs) approx.
SKIC 6: 1.08kg (2. lbs) approx. 38
SKIC 8: 1.14kg (2. lbs) approx. 51
SHIPPING WEIGHT
(FOR PAIR):
SKIC 4: 1.18kg (2.6lbs) approx.
SKIC 6: 1.27kg (2.8lbs) approx.
SKIC 8: 1.36kg (3lbs) approx.
Produktspecifikationer
| Varumärke: | Kramer |
| Kategori: | högtalarstöd |
| Modell: | SKIC-6 |
| Placering: | Tak |
| Kompatibilitet: | Galil 6-CO |
| Produktens färg: | Silver |
| Harmonized System (HS)-kod: | 85189000 |
Behöver du hjälp?
Om du behöver hjälp med Kramer SKIC-6 ställ en fråga nedan och andra användare kommer att svara dig
högtalarstöd Kramer Manualer
10 September 2024
9 September 2024
6 September 2024
högtalarstöd Manualer
- Multibrackets
- Crestron
- Monacor
- Bogen
- Peerless-AV
- Tannoy
- Monoprice
- Ultimate Support
- Teufel
- Yamaha
- Bose
- Pyle
- Chief
- Axis
- Pro-Ject
Nyaste högtalarstöd Manualer
27 Februari 2025
20 Februari 2025
20 Februari 2025
6 Februari 2025
5 Februari 2025
15 Januari 2025
14 Januari 2025
1 Januari 2025
1 Januari 2025
31 December 2025