LG GSA-H50L Bruksanvisning

LG Inte kategoriserad GSA-H50L

Läs gratis den bruksanvisning för LG GSA-H50L (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 1.5 recensioner. Har du en fråga om LG GSA-H50L eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/4

Before installing the drive, turn off

the system power.

Disconnect the power cord,

and remove the cover.

• Remove a vacant 5.25” drive bay panel from

the computer. Slide the drive into the drive

bay.

Set the jumper on the rear of

the drive as necessary.

A. When using a Primary IDE port

If you need to connect your drive to the same

primary IDE channel as the hard drive, the drive

should be set to SLAVE position.

B. When using a Secondary IDE port

❶ If there is no device connected to the

secondary IDE channel, connect the

drive to this channel and set the jumper

to MASTER.

❷ When two drives are connected, set one

drive to MASTER and the other drive to

SLAVE. If your operating system encounters

interface problems after installing the new

drive, try swapping the jumpers or move

one drive to another IDE channel.

Installing the Drive

Method A

Method B

IGIT AL AN

AL OG

INTE

RFACE OWER

DRCSM

SLA

G39

+12

GN D

UD IO A

UD IO

Super Multi DVD Rewriter

DIGIT AL ANAL OG

INTERFACE POW ER

DRCSM

SLA

G39 +5 +

GN D

AUD IO A

UD IO

Super Multi DVD Rewriter

DT AL AN ALOG

INTERFACE POW ER

DRCS M

SL A

G39

+5 +12GND

AD IO A

DIO

DIGITA LAN

ALOG

INTERFACE PO WER

DRCSM

SLA

G39

5+12

GN D

AUDIO A U

DIO

First Drive

Second Recorder

Super Multi DVD Rewriter

Connect the IDE data

cable/DC power cable

to the drive.

❶ Connect the IDE data cable to the back of

the drive.

* Using a 40-pin IDE cable might bring the '04/08/03

error (LOGICAL UNIT COMMUNICATION CRC

ERROR (ULTRA-DMA/32))'.

In this case, substitute to 80-pin type IDE cable is

highly recommended.

This kind of error is hardly detected from some

specific motherboard.

❷ Connect a 4-pin power supply cable from

the computer to the drive.

Replace the cover,

connect the power cord

and restart your computer.

• Your computer configuration may different

from the illustrations.

❶ IDE Cable

Reserved ❷DC Power

Cable

Features

• Enhanced-IDE (ATAPI) interface.

• Power tray loading and ejection of disc.

(The disc can also be ejected manually.)

• Combination CD-R/RW, DVD-R/RW, DVD-R DL, DVD+R/RW,

DVD+R DL, DVD-RAM functions into one drive.

• Supports Region playback control Phase II.

• Automatic buffer underrun error prevention technology.

• Supports LightScribe Direct Label Printing Technology -

*Optional.

* You can use a variety of Drive

Package Items

System Environment

Computer

This unit can be operated in the system environment explained here.

* Compatibility problem in write/read function may occur with media depending on the media

manufacturing quality.

For DVD±R 18x support media: Mitsubishi Kagaku Media, That’s, Maxell (MID: MAXELL 003, MXL

RG04) are recommended.

* Upon the media condition or some of user’s enviroment the maximum speed sometimes could not

be guarantee.

Specifications

CPU: Pentium III 1.0GHz (Recommanded system

requirements for optimal performance, CPU: Pentium IV

2.4GHz or faster, Memory: 512MB or greater)

128MB or greater.

20GB or more free space. (The free space needed for

writing depends on the quantity of data.)

Enhanced-IDE interface (as Primary Slave, Secondary

Master or Slave)

5.25-inch half-height bay required

+5V/+12V power socket required

Windows ME (Not supported in LightScribe).

Windows 2000 Professional/XP(Home Edition/Professional),

Direct X 9.0 or Higher is required.

CD-R : LG, Mitsubishi Kagaku Media, Verbatim, That’s,

TDK, Ritek or HP discs are recommended.

CD-RW : LG, Mitsubishi Kagaku Media, Verbatim are

recommended.

DVD-R : Mitsubishi Kagaku Media, Maxell, That’s are

recommended.

DVD-RW : Victor. JVC, Mitsubishi Kagaku Media, TDK are

recommended.

DVD+R : Mitsubishi Kagaku Media, That’s, Maxell are

recommended.

DVD+RW : TDK, Mitsubishi Kagaku Media, Ricoh are

recommended.

DVD±R DL :

Mitsubishi Kagaku Media, Verbatim are recommended.

DVD-RAM :

Maxell, Mitsubishi Kagaku Media are recommended.

System

requirements

VGA Card Memory

Hard disk

Interface

Drive bay

Power

Software Required

CD-R, CD-RW,

DVD-R, DVD-RW,

DVD+R, DVD+RW,

DVD±R DL,

DVD-RAM media

❋ The drive’s appearance and specifications may change without

prior notice.

Software

Install the supplied CD/DVD Recording Authoring Software before using this unit.

* Please uninstall any previous CD burning software you may have loaded on your PC

in order to prevent possible compatibility issues.

Once you have installed the supplied software, you may (if you wish) begin to reinstall

previous software, taking note for errors.

Please visit www.lgservice.com and install the program,

“LG ODD Online F/W update.” By using the program,

you can automatically check the latest information about FirmWares and

update the FirmWare.

Worldwide support ; http://www.LGservice.com

Worldwide corporate site : http://www.LGE.com

Items

General

Host Interface E-IDE/ATAPI

Supported Discs DVD-ROM(Single/Dual), DVD-RW, DVD-R, DVD-R

DL, DVD+RW, DVD+R, DVD+R Double layer,

DVD-RAM, CD-Digital Audio & CD-Extra, CD-Plus,

CD-ROM, CD-ROM XA-Ready, CD-I FMV, CD-TEXT,

CD-Bridge, CD-R, CD-RW, Photo-CD (Single &

Multi-Session), Video CD, DVD-Video

Disc Diameter 12cm/ 8cm

(8cm disc can be used only with drive placed horizontally.)

Mounting direction

Horizontal/Vertical

Read/Write Speed

Write : (CD-R) : 16X, 24X, 40X, 48X

(CD-RW) : 4X, 10X, 16X, 24X, 32X

(DVD-R) : 2X, 4X, 8X, 12X, 16X, 18X

(DVD-RW) : 1X, 2X, 4X, 6X

(DVD+R) : 2.4X, 4X, 8X, 12X, 16X, 18X

(DVD+RW) : 2.4X, 4X, 6X, 8X

(DVD-RAM): 2X, 3X, 5X, 6X, 8X, 12X (Ver. 2.0 & higher)

(DVD+R Double layer): 2.4X, 4X, 6X, 8X, 10X

(DVD-R Dual layer): 4X, 6X, 8X, 10X

Read : (CD-ROM/R) : 48X max

(CD-RW) : 40X max

(DVD-ROM)(Single/Dual) :16X/12X max

(DVD+/-RW) : 12X max

(DVD+/-R) : 16X max

(DVD-VIDEO) : 8X max

(DVD+R Double layer): 12X max

(DVD-R Dual layer): 12X max

(DVD-RAM): 12X max

Items

Performance

Data transfer rate

*Sustained CD-ROM : 7200 Kbytes/s (48X max)

DVD-ROM : 22160 Kbytes/s (16X max)

*Burst(ATAPI)

16.6 Mbytes/s (PIO Mode 4), (MULTI-DMA Mode 2)

66.6 Mbytes/s (Ultra-DMA Mode 4)

Average Access CD-ROM: 120msec (Typical)

DVD-ROM : 140msec (Typical)

Buffer capacity 2 Mbytes

MTBF 125,000 Power On Hours (Duty Cycle 10%)

Environmental

Level

When operating Temperature: 5 °C to 45 °C

Humidity: 15% to 85% R.H.

When not operating

Temperature: -30 °C to 60 °C

Humidity: 10% to 90% R.H.

Electrical

Power

DC 5V, DC 12V

Item Quantity

- Internal Super Multi DVD Rewriter 1

- Recording & Authoring Software

[Nero, InCD, Power Producer,

MPEG-2 Software (PowerDVD)]

- Quick Set-up Guide for Drive 1

Quick Set-up Guide Super Multi DVD Rewriter GSA-H50N

GSA-H50L

To install of your product, please read this guide manual carefully and completely. For the detailed owner’s manual of the drive,

please refer to the CD manual.

P/NO. 3828HN1011U Ver. A

Time (

1/3Stroke

)

GSA-H50L GSA-H50N

LightScribe Supported Not Supported

* For Optimal 18x writing, 80 pin E-IDE cable and Pentium IV 2.4GHz or faster are

recommended.

Produktspecifikationer

Varumärke:	LG
Kategori:	Inte kategoriserad
Modell:	GSA-H50L
Färg på produkten:	Zwart
Vikt:	3700 g
Bredd:	442 mm
Djup:	211 mm
Höjd:	44 mm
Förpackningens vikt:	4100 g
Förpackningens bredd:	300 mm
Djuppackning:	520 mm
Förpackningshöjd:	90 mm
LED-indikatorer:	Activity, Link, PoE, Speed
Typ av förpackning:	Doos
Medföljande kablar:	AC, LAN (RJ-45)
Snabbstartsguide:	Ja
Ursprungsland:	Taiwan
Certifiering:	CE, FCC Part 15 Class A
Internminne:	128 MB
Nätverksstandard:	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3af, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Förvaringstemperatur:	-20 - 70 °C
Firmware-uppgradering möjlig:	Ja
Strömspänningsskydd:	Kortsluiting
Webbaserad hantering:	Ja
Förvaringsfuktighet:	10 - 90 procent
Återställningsknapp:	Ja
Rackmontering:	Ja
Flashminne:	32 MB
Säkerhet:	LVD, UL, CB IEC-60950-1
Medeltid mellan fel (MTBF):	463931 uur
Quality of Service (QoS):	Ja
VLAN=support:	Ja
Virtuella LAN-funktioner:	Private VLAN, Voice VLAN, Tagged VLAN, Port-based VLAN
Åtkomstkontrolllista (ACL):	Ja
Power over Ethernet (PoE):	Ja
Växlingskapacitet:	128 Gbit/s
MAC-ställbar:	32000 entries
10G-stöd:	Nee
Dataflödeshantering:	Ja
IGMP snokar:	Ja
Växlingstyp:	Managed
Antal grundläggande switchande RJ-45 Ethernet-portar:	24
Konsolport:	RJ-45
Byt lager:	L3
Typ grundläggande switchande RJ-45 Ethernet-portar:	Gigabit Ethernet (10/100/1000)
Paketbuffertminne:	4 MB
Stöd för Jumbo Frames:	Ja
Portspegling:	Ja
Spanning tree protokoll:	Ja
Anslutningsaggregation:	Ja
Koppar Ethernet-kabelteknik:	10BASE-T, 100BASE-TX, 1000BASE-T
DHCP-funktioner:	DHCP server, DHCP relay, DHCP client
SSH/SSL-stöd:	Ja
Värmeavledning:	1526.86 BTU/h
(Ytter) huvudpaketets höjd:	324 mm
(Ytter) huvudförpackningens bredd:	482 mm
(Ytter) huvudförpackningens bruttovikt:	21700 g
(Ytre) huvudpaketets längd:	540 mm
Kvantitet per (yttre) huvudkartong:	5 stuk(s)
AC-ingångsspänning:	100 - 240 V
AC-ingångsfrekvens:	50 - 60 Hz
Strömförbrukning (typiskt):	16.79 W
Drifttemperatur (TT):	0 - 45 °C
Relativ luftfuktighet i drift (VV):	10 - 90 procent
Harmoniserad systemkod (HS):	85176990
Total Power over Ethernet (PoE) budget:	185 W
Antal Power over Ethernet plus (PoE+)-portar:	24
Frakthastighet:	95.232 Mpps
Jumbo ramar:	10000
Broadcast stormbeheer:	Ja
Skyddsslinga:	Ja
Lagra och vidarebefordra:	Ja
Systemhändelselogg:	Ja
Rackmonteringspaket:	Ja
Support CD:	Ja
Kabelteknik för fiber-ethernet:	1000BASE-X
Ström per port Power over Ethernet (PoE):	30 W
Antal Combo SFP-portar:	4
Statisk väg:	Ja
BPDU-filtrering/skydd:	Ja
Telnet:	Ja
Kabellängdsdetektering:	Ja
sFlow:	Ja