Lucky FL068-W Bruksanvisning
Lucky
fishfinder
FL068-W
Läs gratis den bruksanvisning för Lucky FL068-W (1 sidor) i kategorin fishfinder. Guiden har ansetts hjälpsam av 24 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 12.5 recensioner. Har du en fråga om Lucky FL068-W eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/1
-2-
so un d wav e a nd w he n the sou nd w av e i s
re flecte d o f a n o bj ec t; it t he n u se s t he
re flecte d s ig na l t o i nter pr et lo cation , s iz e,
an d c om po sition o f an o bj ec t.
1 Signal Indicator
2 Sensitivity Indicator
3 Battery Save On/Off
4 Fish Alarm On/Off
5 Backlight On/Off
6 Battery Strength lndicator
7 Water Depth lndicator
8 Fish Depth lndicator
9 Fish Location lndicator
10 Bottom Contour Detector
11 Weed Detector
fi g. 4
fi g. 3
11
1
10
9
8
2 3 4 5 6 7
3 DISPLAY VIEW
4 OPERATION AND SETTING
-3-
4.1 POWER ON/OFF
Slide and remove the Battery Door , lnstall 4 AAA
batteries. Be certain to align the batteries as per
the diagram within the battery compartment.
Close the battery door completely.
Press the POWER key to turn the power On , the
unit enter normal mode after display full show 1
second.
Press and Hold the POWER key for 3 seconds to
turn the Power Off.
To enter the simulation mode: press and hold the
POWER key for 5 seconds and release while the
power is off.
The unit must be turned off to enter
normal operation from simulation mode.
Automatic power off feature : The display will
shut off automatically when the depth display
reads continuously for 5 minutes.
NOTE:
4.2 FUNCTION SETTING
Press and Hold the SETUP key for 3 seconds,the
Save indicator{ } will blink; then pressing the
SETUP key again and again,the indicator will blink
from the current feature to be set. SAVE { }---
Alarm{ }---Backlight{ }
BAT.
BAT.
Press the ENTER key to activate or deactivate a feature.
The screen will automatically return to normal
operation after 5 seconds if no keys are pressed.
Press and hold the ENTER key for 3 seconds,
the measure unit will blink then, press the ENTER
key again and again the measure, unit will blink
from the current unit "M"or "FT"to be set.
-5-
NOTE:
This reading may also occur in water is
extremely dirty, or where there are heavy silt or
mud bottoms. Sonar is a sound signal that travels
through water. Sonar will not travel through air.
Keep this in mind when using the fish finder, as
the smallest bubble between the sonar sensor
and the water, will cause the unit not to operate
correctly.
5.2 FISH SHOW
If the finder determines that sonar has detected a
fish, the display will show a fish shaped icon (fig. 7).
The first column of fish indicators on the right of the
display shows the most current information. This
column is then moved to the left as a new reading is
displayed Fish icon moved in every 5 seconds.
NOTE:
The fish indicators move away from the right to
the left at a constant speed. This motion in no
way reflects actual movement of the fish.
The depth readout on the top right,will appear after
the power is turned ON and the sonar sensor is placed
in water. The depth meter will indicate”---” if the depth
exceeds these parameters (0 .7 to 40 meters).
fi g. 7
BAT.
11. 8
M
A.
B.
fig .15
fron t hole
seco nd hol e
-7-
fi g. 16
Two Rock lndicators identifies a considerable amount
of bottom structure, but scattered . (fig.13)
A considerable amount of time needs to be spent
fishing this area as each piece of structure could be
hiding a prize catch.Three Rock lndicators indicates
a large amount of bottom structure in a confined area.
This bottom may consist of a large rock(s), stump(s),
tree(s), or a ledge(s).(fig.14)
6. USING THE WIRELESS SENSOR
Use the wireless sonar sensor is very easy for user,
just simply attach the sensor to the end of your
fishing line and cast it into the water as your normal
float or lure.
6.1 You can tie your fish reel line to the front hole in the
wireless transducer. If you want to use the wireless
transducer as a stationary float,use the second hole to
attach your hook
using a lighter weight line. but A obstacle will break the
lighter line easily,for this reason, we suggest you not to
pull the lighter weight line if unnecessary.Slip line
techniques are not recommended because will increase
the risk of losing the wireless transducer. If you do use the
slip line method. use a lighter weight line after the lower
stop, unable get back of the wireless transducer if the
lower line with hook breaks away.
-8-
6.2 You will increase the risk of breaking your line if you use
light test pound line on your reel. The transducer in water is
positively buoyant. The maximum amount of weight for
any attachment to the transducer is approximately 6 grams,
and includes the combined weight of any hook, line, weight
swivel/snap swivel and bait that is attached to the wireless
transducer. over 5.7g will submerge the wireless sonar
sensor, causing the signal loss.
The bottom of the wireless transducer
should not be handle during soner operation, as
this may cause physical discomfort and may
result in personal injury in the form of tissue
damage. Handle the wireless transducer only by
the antenna tower when it has been in the water.
NOTE:
7.How to replace the CR-2032 battery
7.1 Remove the battery door of the wireless sonar sensor,
and press the lock-block of the battery holder and the
battery will flip pls check the picture.(fig.17 , fig.18)
7.2 Make sure that the O-ring in the battery compartment
is present, positioned correctly in the grooves, and free of
debris before reinstalling the battery door.
fi g. 17 fi g. 18
NOTE:
When the fish finder receive the signal
from wireless sensor the signal indicator{ }
will display on the screen.
The wireless transducer is not intended
for use by children younger than 6years old
without adult supervision as the transducer may
represent a choking hazard to small children.
NOTE:
The max RF distance is 120 meters unless the water
is smooth. The signal indicator will disappear if
the distance between the fish finder and the
wireless sensor over 120 meters.
-6-
Use the fish Depth lndicator to
measure the fish’s depth from
the sonar sensor (fig. 8). This
can bedone by dividing the
depth reading by 10. This
number represents the value
of each box.
(Example, the depth is 20 m,
the fish symbol appears in the
5th boxfrom the top. This means the fish is10 m from
the surface)
The display indicates the presence of short weeds
by turning on the smallest Weed indicator(fig.9)
Moderately tall weeds are depicted by turning on the
second Weed indicators(fig.10)
Tall weeds are depicted by turning on the third Weed
indicator(fig.11)
5.3 W EED SHOW
5.4 BOTTOM CONTOUR
fi g. 9
fig .8
BAT.
11 .8
M
One Rock lndicator identifies limited structure (fig. 12).
You would most likely find a small rock, a small pile
of rocks, or uneven bottom contour. This is not a bad
place for hiding fish, but due to the limited amount of
strucrure, there may not be a lot.
fi g. 10 fi g. 11
fi g. 12 fi g. 13 fi g. 14
-4-
Backlight illuminated all the time when backlight
feature ON. This feature will greatly reduce the
battery life of the unit. So it should only be used
during low light conditions. The bac klig ht will
illumin ate for 3 sec onds whe never a key is
pressed when the backlight feature is set to off.
NOTE:
You can select SAVE mode to work
when you play on long time or water quiet , in
order to extend batteries use-life.
The screen can be refreshed by pressing the
POWER key during normal operation.
5 FISH AND DEPTH READOUT
5.1 READINIG DEPTH
15.8
M M
fi g. 6
sensitivity
highest
alarm
off
alarm
on
battery full
battery half
battery low
backlight
off
backlight
on
battery save mode
battery normal mode
weak
signal
strong
signal
sensitivity
fi g. 5
-1-
WIRELESS FISH FINDER
OPERATION GUIDE
1 PRODUCT OVERVIEW
This amazing product is es pec
designed for am at eur and
professiona l fishe rm en a li ke, t
find out the location of f is h and
depth of water. The unit can be
used in ocean, ri ve r or l ake and
is fantastic for det ec tin g schoo
of fish in any partic ular area.
Using amazing and i nnovati ve
technology, this port able fi sh
finder is the ideal t ool t o bring t he
fish to you!
fi g .1
Sonar technol ogy is based on sound
waves. The system uses s on ar to
locate and defi ne s tructure, bo ttom
contour and com position, as well
depth directl y be low t he t ra nsd ucer.
The transduce r sends a s ound wave
signal and dete rm ines di stance by
measuring the t im e bet ween the
transmission of t he
fi g .2
2 HOW SONAR WORKS
We are really app reciat ed t ha t yo u pu rc ha se o ur products!
In ord er t o mak e the use rs can give the m ac hi ne ry
performance i nt o full p la y and well utilize this machine, we
ar e plea sed t o a sk the user s t o read the ope rati ng
instructi on car ef ul ly b efore operating the mac hi ne . If you
have any questi on in us e, plea se fee l fre e to con ta ct the
Zhejiang lucky Ma nu fa ctu re r Co., Lt d for
con sul tat ion: w ww.go odlu ck y cn.c om
WIRELESS FISH FINDER
OPERATION GUIDE
-9-
Product Specification:
Display:
Backlighting:
Power Requirement:
Measure Units:
Sensor Coverage: 90 degrees
Depth Range Max/Min: 130Feet (40meters)/
2Feet(0.7meters)
Operation temperature: -10 -50℃ ℃
Packaging:
1) A Wireless Remote Sonar Sensor
2) A handheld device with LCD screen
3) A operation manual
4) A neck strap
2 inch LCD
White LED
4-AAA Alkaline Batteries
Meters and Feet
Th e wirele ss tr an sduce r h as co ntact s tha t
perceive when the device is immersed in the water.
These contacts turn on the sonar transmitter/
r ec e iv e r and be gi n t ransm itt i ng th e s o na r
information via Radio Frequency to the display.
The wireless transdu cer automatically s tops
using power a few seconds after being pulled out
of the water.
Do not place the wireless transducer in a
wet area when not in use as this will turn on the
wireless transducer and shorten its usable life.
Store the wireless transducer in a dry area when
not in use to conserve power.
Never place the unit in a wet area of a boat or on
a metal sur ace that could accidentally power it on.
If
f
the unit was used in salt water,rinse it
with fresh water before storing it.
NOTE:
NOTE:
MADE IN CHINA
MANUFACTURER: JINHUA LUCKY ET MANUFACTURER CO.,LTD.
Produktspecifikationer
| Varumärke: | Lucky |
| Kategori: | fishfinder |
| Modell: | FL068-W |
Behöver du hjälp?
Om du behöver hjälp med Lucky FL068-W ställ en fråga nedan och andra användare kommer att svara dig
fishfinder Lucky Manualer
1 Januari 2025
19 September 2024
15 September 2024
7 September 2024
31 Augusti 2024
26 Augusti 2024
23 Augusti 2024
20 Augusti 2024
18 Augusti 2024
18 Augusti 2024
fishfinder Manualer
Nyaste fishfinder Manualer
8 Mars 2025
7 Januari 2025
30 December 2025
8 Oktober 2024
26 September 2024
21 September 2024
18 September 2024
13 September 2024
13 September 2024
11 September 2024