LYYT DIY-CW60 Bruksanvisning
LYYT
Inte kategoriserad
DIY-CW60
Läs gratis den bruksanvisning för LYYT DIY-CW60 (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 20 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 10.5 recensioner. Har du en fråga om LYYT DIY-CW60 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
DIY LED TAPE KIT
User Manual
DIY LED TAPE KIT - SINGLE COLOUR
Introduction:
Thank you for purchasing the Lyyt DIY LED Tape . Kit LED tape is ideal for use on the underside of a counter tops, shelves, cupboards, around
window frames or in an alcove of a ceiling to name just a few examples.
Before starting please ensure that you have read this instruction leaflet carefully.
If you are unsure about any of the installation details, please have this installed by a competent installer.
Blister Contents:
1 x Reel of LED tape
1 x UK power adap tor
Possible Required tools: Scissors, Craft knife, Soldering iron and solder, 2 core DC wire and heat shrink tube.
Step 1: Preparation
Ensure that the surface you are attaching to is clear of dust and dirt. Clean thoroughly and leave to dry before fitting the tape.
Unravel the tape and connect the power supply. Check that all the LEDs are functioning correctly and if there are any faults return to your retailer
without delay.
Step 2: Cutti ng
WARNING: Disconnect from the power supply before attempting any cutting.
Measure out each section and cut with sharp scissors at the marked 5cm intervals to achieve the perfect length. Do not discard any excess tape as
it can be easily reconnected and used again (see FIG 2).
Step 3: Fitting:
Example 1: Simple straight run.
Clear the area you wish to install the tape and remove the backing paper, exposing the adhesive tape. Push tape firmly onto the surface. It is
recommended to work on 50cm sections at a time in order to ensure a professional finish. When you reach the end of your installation cut at the
marked cutting point.
Example 2: Requires cutting:
The tape can be cut at highlighted 5cm intervals for a perfect fit.
FIG 1:
Produktspecifikationer
| Varumärke: | LYYT |
| Kategori: | Inte kategoriserad |
| Modell: | DIY-CW60 |
Behöver du hjälp?
Om du behöver hjälp med LYYT DIY-CW60 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad LYYT Manualer
17 September 2024
9 September 2024
5 September 2024
4 September 2024
4 September 2024
3 September 2024
3 September 2024
3 September 2024
3 September 2024
3 September 2024
Inte kategoriserad Manualer
- Tuur
- Lazer
- Gretsch
- Gagato
- Generac
- Nobo
- Kalorik
- Wire Technologies
- Segway
- AudioQuest
- Olympus
- Profile
- Special-T
- Debel
- WeFix
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025